Question about 1995 Mercury Sable

Open Question

How do you remove a transmission from a 2005 Mercury Sable

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Car wont move.

Could be that your linkage is broken and just looks like it is shifting or a bad tranny module or tranny but i would look at the linkage and see if it is hooked up to the tranny.

Posted on Oct 10, 2008

Ad
  • 31 Answers

SOURCE: removal of transmission

You suspend the engine from the top (with the proper tool). Remove the front sub-frame. Remove the axles, cooling lines, electrical plugs and cables. Unbolt the transmission from the engine and lower it out of the car from the bottom using a transmission jack.

Posted on Feb 09, 2009

chuck943
  • 783 Answers

SOURCE: 1998 mercury sable how to remove auto transmission

You have to use and engine support bar that hooks across the top of the strut towers like this
http://cgi.ebay.com/ebaymotors/Astro-Pneumatic-5820-Engine-Support-Bar-With-Front-Arm_W0QQitemZ110370058738QQcmdZViewItemQQptZMotors_Automotive_Tools?hash=item110370058738&_trksid=p4506.c0.m245&_trkparms=72%3A1171%7C65%3A12%7C39%3A1%7C240%3A1318

Then you remove the sub frame under car and remove tranny thru the bottom.

Posted on Apr 03, 2009

  • 1 Answer

SOURCE: Remove the right rear door panel in a Mercury Sable

Removed two screws from the perimeter of the door, one in the back edge and the other under the bottom. Remove one screw from the handle cup where the window switch is located. Placed some tape around the edge of the handle cup for protection against scratches and pried the cup out with a small putty knife. It is hard, but will pop out. Next I taped the paint around the door panel and used a flat bar to reach behind the panel and had enough of a gap to see the orange tabs and pried each one to remove the panel completely. The panel does not need to be lifted up to removed, just pull it straight off the door. A few tabs may still be holding, but will pop off with a bit of pressure.

Posted on Oct 08, 2009

  • 3640 Answers

SOURCE: 1997 mercury sable won't shift into overdrive

first of all, check the kickdown cable to transmission. it may be out of adjustment. or just bad.if its the cable out of adjustment, it is sure cheaper then a tranny.

Posted on May 02, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 Mercury sable MAF and MAP sensors


2005 Mercury sable MAF and MAP sensors ?????? What about them ?

Apr 05, 2017 | 2005 Mercury Sable

1 Answer

How to change transmission filter on a 1999 mercury sable transmission slips or don't change properly sometime on take off.


place large masonry mixing tray[home depot]under transmission pan to catch fluid. remove 19 bolts on transmission pan.pull off filter.make sure o-ring gasket is removed if it is not on old filter.push in new filter.clean old gasket off pan.install new gasket and pan. refill transmission fluid.check pan for leaks.

Mar 25, 2015 | 1999 Mercury Sable

1 Answer

Water in head light 2005 Mercury Sable, can I replace a gasket, are something to stop the water leak?


I've had success with sealing around headlamp with clear silicon. You have to remove it to get all around it.

Mar 07, 2014 | Mercury Cars & Trucks

1 Answer

Cabin air filter replacement for Mercury Sable 2005


Open the hood and look at the right (passenger) side of the cowl between the wipers and the firewall. My 2000 was easy to slide the black plastic out (after removing the clips) and slipping in the filter.

Jun 05, 2010 | 2005 Mercury Sable

1 Answer

Got a code 1742 on my sons mercury sable


Okay this is a internal problem in the transmission you will need to remove side cover and oil pan of the transmission.This is a big job to do it safely you will need a hoist and engine cradel this a profesional job my advice to you unless you have done this before 2 or 3 times take it in for service this is a delicate job mistakes can resault in costly mancanical further repairs.Hope this helps,John

Dec 27, 2009 | 1999 Mercury Sable

1 Answer

I have a 2005 Mercury Sable when it shifts into third gear it jerks and a little again into fourth gear. First and second are pretty normal. It has 140,000 miles


Sounds like the band that controls 3rd and forth gear is almost worn out. Have you followed the recomended interval for transmission fluid changes? What does your trans fluid look like?

Nov 23, 2009 | 2005 Mercury Sable

1 Answer

Removal of transmission


You suspend the engine from the top (with the proper tool). Remove the front sub-frame. Remove the axles, cooling lines, electrical plugs and cables. Unbolt the transmission from the engine and lower it out of the car from the bottom using a transmission jack.

Feb 09, 2009 | 1995 Mercury Sable

1 Answer

Car wont move.


Could be that your linkage is broken and just looks like it is shifting or a bad tranny module or tranny but i would look at the linkage and see if it is hooked up to the tranny.

Aug 21, 2008 | 2005 Mercury Sable

1 Answer

1996 MERCURY SABLE 65,000 MILES ON SPEEDO. TRANSMISSION STARTED TO SLIP ALSO RUST UNDER VEHICLE. LINCOLN MERCURY STATED REPAIR WOULD COST 4 TO 5 THOUSAND DOLLARS AND YOU MIGHT AS WELL JUNK THE VEHICLE


Transmission problems are an issue with Sables. If you Google transmission and Mercury Sable you will come to quite a few complaints. There are actually a few posts on this website where folks are having issue too. Personally a cheap o-ring in my 1999 Sable went out resulting in a $1800 transmission repair bill. I literally gave the car away about three years ago. In almost 20 years of owning vehicles the two years I had the Sable was the most expensive and busiest in the way of repairs.

Jul 29, 2008 | 1999 Mercury Sable

Not finding what you are looking for?
1995 Mercury Sable Logo

Related Topics:

74 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5522 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...