Question about 1984 Chrysler LeBaron

Open Question

1984 chrysler lebaron needs to be primed time to time now it just burns off the prime gas and won't keep running

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a hitachi cs40 and whe I prime it 10 times it starts up and runs until the prime is gone the shutsdown.


rebuild the carby as the diaphragm is not functional and pumping the fuel up

Feb 05, 2017 | Cars & Trucks

2 Answers

Where is the fuel filter located at on a 1989 chrysler Lebaron


On 1989 Chrysler Lebaron 2.2L TBI 4cyl the Fuel Filter is located under vehicle, passenger side, below trunk area, next to fuel tank, mounted in fuel line.

Hope this helps; remember to rating this answer leaving a testimonial comments. Have a nice day.

Oct 17, 2011 | 1989 Chrysler LeBaron

1 Answer

Wiring diagram for 1984 Chrysler LeBaron ignition system


Try repair manual here
http://www.manualslib.com/

Oct 23, 2010 | 1984 Chrysler LeBaron

2 Answers

Ran out of gas and not getting gas to carberator after adding gas


Hello there:
If you have tried priming the fuel pump by turning on the key and listening for the fuel pump to be running if it is it may just need to be primed with a hand priming pump untill you get fuel
but if you still dont get any fuel i would check out the fuel filter to see if it is clogged and needs to be replaced
to locate the fuel pump and filter go under the drivers side and look at the frame of the vehical not quite half way back and you will see the fuel filter and just in front of this about 10 inches towards the engine will be the fuel pump ok>
best regards michael

Nov 05, 2009 | 1984 Ford Econoline

1 Answer

Silverado not starting unless prime


There is a check valve in the fuel pump that sounds like it may have gone bad. Check the fuel pressure at the shredder valve, there should be 60 to 65psi during the prime and will drop 5 psi when the engine is running. Once the fuel line is primed, check to see how fast you lose your prime. Since you replaced your injection system, we can eliminate the fuel pressure regulator leaking which was common on the injection system your truck run's on. If the fuel pressure drops fast then it's going to be a bad check valve at the fuel pump and it may be time to replace the fuel pump it self. Good luck and hope this helps. Note: do not try to start the engine with putting gas through the throttle body, it's been know for small fires to start and burn the spider injectors. 

Sep 04, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

1987 LeBaron won't start unless I pour gas into


Check you injector seals,you may be losing pressure in the fuel lines

Jul 16, 2009 | 1987 Chrysler LeBaron

3 Answers

1984 Chrysler LaBaron fuel recommendation


Premium. Gas is rated by octane lnumbers and those numbers have stayed the same over the years. Mid gas would not have a high enough octane rating for your engine.

Jul 10, 2009 | 1984 Chrysler LeBaron

1 Answer

Engine misses


you could have a blown head gasket in between two cylinders.or you need to change your fuel pressure regulator,you might need a new fuel filter..

Dec 02, 2008 | 1984 Chrysler LeBaron

1 Answer

Problems


try turning the switch to the on position and then of and repeating about 5-6 times... NOT trying to start it .. this will prime up your fuel and should start it... after about 5 times... leaving it on for a couple seconds on each turn... try to start it..hope it just needed a prime :D

Sep 16, 2008 | 2003 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...