Question about Jeep Cherokee

2 Answers

My 1985 jeep Cherokee 2.8L. stop or turn only left then stall over over why ?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Your question is unclear. Please rewrite it.

Posted on Oct 17, 2013

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

If it has a throttle-body carburetor it may be sticking.

Posted on Oct 17, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 840 Answers

SOURCE: Turn signals quit working

one of the bulbs is not working soneither ill work so you need to check both bulb check the rear first its the easiest 2 screws inside rear and pull out light

Posted on Jan 25, 2009

emissionwiz
  • 76846 Answers

SOURCE: Turn signals not working on 2001 Jeep Grand Cherokee

replace the turns signals flasher unit.

Posted on Mar 02, 2009

emissionwiz
  • 76846 Answers

SOURCE: Jeep stalls

try doing the procedure below, should cure the problem.
Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Posted on Jun 02, 2009

ZJLimited
  • 17970 Answers

SOURCE: 1993 jeep grand cherokee, choking, pulling then stalled,

Check:
- Fresh Air Intake Hose: Clogged or Damaged FreshAir Intake Hose.
- Carburetor: Worn, Faulty or Damaged Carburetor.
- Mass Air Flow Sensor: Damaged, Loose, or Faulty Mass Air Flow Sensor or Circuit.
- EGR Valve: EGR Valve Sticking Open/Leaking.
- Idle Air Control Valve: IAC Valve Sticking or Faulty.

Good luck.

Posted on Sep 01, 2009

  • 59 Answers

SOURCE: my 1993 grand cherokee jeep stall when i put it in

Check the crankshaft position sensor mine was doing the same thing also make sure there is nothing rubbing ontop it

Posted on Apr 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 jeep cherokee died/stalled while driving


run fault codes to se if any faults have been recorded.

Dec 05, 2013 | 2004 Jeep Grand Cherokee

1 Answer

How to adjust timing chain on 1985 2.8 v6 jeep cherokee chief


no need to adjust the timing you need to turn the rotor to the left a it will start and it's not a v6 jeep only make inline6

Jan 26, 2013 | 1985 Jeep Cherokee

2 Answers

While running my 1985 Jeep Cherokee shuts down and I have to wait about 5 to 15 minutes for all electricity to come back to the entire vehicle. Could this be a bad ignition module?


Could be a bad ignition module or could point to faulty wiring. The longer your vehicle runs the hotter some electrical components get and that's the 5 - 15 minutes it wants to cool down.

Jan 22, 2012 | 1985 Jeep Cherokee

1 Answer

I have a 94 jeep cherokee with a in- line 6. its stalling out and sometimes starts up before it even rolls to a stop or sometimes like now when im sitting here at work waiting for my wife cause it stalled...


After it stalls, have someone listen at the tank to see if the fuel pump is running when you turn the key on. If you can't hear it, it has failed (they overheat and bind, when cooled down they work 'till they again get hot). if the pump is running, likely the crank position sensor (11 o'clock on the bellhousing looking from rear) has failed....symptom is pretty much identical.

Mar 01, 2011 | 1994 Jeep Grand Cherokee

1 Answer

What motor or motors came in the jeep cherokee in 1985 in the US.


1985 Jeep Cherokee came with either a 4 cylinder 2.5L with a 1 barrel carb or a 6 cylinder 2.8L with a 2 barrel carb. The 4WD only had the option of a 4 cylinder 2.1L turbo Diesel.

Jan 21, 2011 | 1985 Jeep Cherokee

2 Answers

Firing order for 1985 jeep Cherokee


Engine size would be a start.

Nov 05, 2009 | 1985 Jeep Cherokee

1 Answer

Where is the flasher located in an 85 cherokee pioneer?


Both four way and turn flashers should be on fuse panel above and in front of your left foot. If not, then the one there is the four way and the directional is under the dash either on the left or right of the steering column. (looks the same as four way)

Sep 02, 2009 | 1985 Jeep Cherokee

1 Answer

Jeep stalls


try doing the procedure below, should cure the problem.
Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake.

Jun 02, 2009 | 1991 Jeep Cherokee Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...