Question about 2005 Honda Civic 1.7i

2 Answers

P0238 dodge code

Hi when i pull away fast the car goes in to limp mode and won,t go past 2500 revs untill you stop the car and turn the engine off for a few minutes then it resets its self. thanks

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 20,706 Answers

Gas or diesel , turbo or not? what year?


limphome. what year car? what engine,?
the top Limp reason is failed sensor. ECT/MAP/MAF/TPS. or crank/cam sensors.
the DTCs (all) that cause limpome are in the FSM,listed clearly.
the blue box above shows honda.
the dodge code. (bad MAP?) illegal Map pressure found.

Posted on Oct 17, 2013

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 3,187 Answers

Cam sensor failing, or crank sensor both do the same thing and is common fault they do get hot.

Posted on Oct 17, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2976 Answers

SOURCE: 1997 Accord overheats and rpm revs from 1000 to 2500 continuosly

If you have runaway reving, you probably have a clogged MAP sensor.

Posted on Feb 13, 2009

  • 43 Answers

SOURCE: Code po740

Hate to say this but i think you need to take to a transmission shop sounds like you have an internal problem that may get worse.

Posted on Mar 31, 2009

  • 1 Answer

SOURCE: Honda Accord 2004 Diesel Problem

i had the same problem and it turned out to be a dirty fuel filter,am sure this will cure the problem,ps they are a nightmare to replace,take it to a dealer

Posted on Jan 28, 2010

cardenderek
  • 783 Answers

SOURCE: I have a P0847 code on my 2006 Honda Civic DX.

make sure the sensor is still plugged in :) it may just need to be replaced. Dont drive until you do, if you can, take to the dealer, should be a less than 200$ fix total.

Posted on Mar 12, 2010

  • 133 Answers

SOURCE: I have 1999 Honda Civic

where ever you had the belt change, take it back, and tell them they didn't leave it right, because it seems the timing is off. this happens when the timing belt is changed and not put properly. even if its just one tooth off, it can cause this problem. and for future transmissionfluid changes, the transmission should never be flushed as it can damage important components within the transmission. but like i said, have the timing belt refitted, because this is going to keep going on if its not fixed. hope this helps, goodluck

Posted on May 21, 2011

Testimonial: "Quick, sensible advice"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan primera 2005 1.8 sx goes limp mode at night with lights and wipers on. No measurable battery or charger problems. Switch off lights and the problem goes away instantly.


The only thing these components have in common is the ground wires. There are many grounds on a vehicle. But the main three are the battery to body, battery to engine and engine to body. These are fairly large wires/cables. They should be checked with an ohm meter. I replace or repair any wires that have more than 5.0 ohms of resistance.

Oct 08, 2016 | 2005 Nissan Primera

1 Answer

1997 dodge ram 2500 automatic in limp mode.


goes into limp mode when not functioning properly, could be a control solonoid, check fluid level first, but, the solonoid may be the problem

Mar 06, 2013 | Dodge Ram 2500 Cars & Trucks

1 Answer

95 eagle vision esi slips out of gear at stops


there is a limp mode but I doubt if that is the problem
It indicates that the torque converter clutch servo/solenoid is faulty
run the fault codes to confirm if that is it or a faulty TCM
check wiring around the transmission

Apr 19, 2017 | 1995 Eagle Vision

1 Answer

I have a 94 dodge Intrepid ES 3.5L Okay when i go to accerate my car if i push the gas down real fast my car jumps then the Rpms start to rev up it doesnt shift after that, rpms just keep climbing. If I...


Well the tcm is going into limp in mode. Have the vehicle scanned. If it is in limp then it has a trouble code in the tcm. This will give you a clue to what is going on.

Apr 22, 2010 | 1994 Dodge Intrepid

1 Answer

2006 check engine light came on and RPM slowed to 2000


Not the fuel filter, this is an emissions problem. Sounds like it is in Limp Mode. You need to have the ECU scanned for trouble codes. Is this vehicle not still under warranty for the emissions system? Call your Dodge dealer and find out.

Sep 02, 2009 | 2006 Dodge Ram 2500

1 Answer

Check engine light comes on and it goes into limp home mode


connect a vacuum guage to the intake port and,
look for a cracked or, broken vacuum fitting or, line your engine is occasionally getting too much air this causes it to over rev.

May 29, 2009 | 1995 Isuzu Rodeo

1 Answer

Chrysler 3.5 won`t rev past 2500 rpm?


remove the aircleaner intake hose and, check the intake air control flap for free movement

Apr 22, 2009 | 2002 Chrysler 300M

5 Answers

Renault traffic 03 1.9dci low power until turbo cuts in and wont rev past 3800rpm in any gear also occasionaly cuts out with engine management/glow light on no faults on diagnostics


my trafic did the same.no power pulling away until the turbo kicked in and it turned out to be the airflow meter.Hope this helps as it cured mine.Plus non of them rev past 3800 revs its normal.

Feb 28, 2009 | 2006 Renault 181

1 Answer

1996 dodge avenger when cold, the transmission go in limp mode


Is the vehicle's Check Engine Light on? It should briefly light up when you turn the key on (before you start the engine) to show that the light is working correctly. Based on what I've read I believe you should have one or more trouble codes. A place like AutoZone will read the trouble codes for you for free, and you can look them up here - http://www.engine-light-help.com/generic-check-engine-light-codes.html

Dec 12, 2008 | 1998 Dodge Avenger

Not finding what you are looking for?
2005 Honda Civic 1.7i Logo

189 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...