Question about Chevrolet Cars & Trucks

1 Answer

Steering box I need instructions on how to rebuild a steering box for a 1982 chevy silverado

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,002 Answers

Go to faxonautoliterature.com and order the GM shop manual for the truck. It will have complete instructions and measurements.

Posted on Oct 16, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: 1982 G30 Chevy Van power steering fluid

Find the power steering pump. The fluid goes in the top of the pump. Look for a twist off cap that has a measuring stick attached to the under side, when you take it off. Make sure you use the correct type of fuild for YOUR kind of vehicle. There are diffrent types for different makes of vehicles. Don't OVERFILL the pump.

Posted on May 15, 2008

  • 61 Answers

SOURCE: chevy steering wheel controls

You first have to disarm and remove the air bag (unscrews with bolts from behind the steering wheel) and then you will see the screws for the switches. Only the silverado awitches will work.

Posted on Jan 29, 2009

  • 468 Answers

SOURCE: Power steering and brake line location2002 Chevy Silverado 2500HD

the power steering lines are very short hoses approximately 8 inches long that go from the power steering pump down to the steering box, which is located on the frame, just below the pump. The brake lines run from the master cylinder(where you fill it with fluid on the drivers side firewall) down to the frame, and then follow the frame both directions; both to the front end and the rear end, along the drivers side frame rail, just on the inside of it. The fuel line runs along the same path to the rear.

Posted on Oct 03, 2009

  • 593 Answers

SOURCE: leaking pitman arm seal at gear box

most of the good rebuild kits have the diagram in it there is not that much in there secter shaft worm gear + some seals and the parts are
not cheap you may be better off with a good used one with fresh seals

Posted on Jan 11, 2010

ftw1952
  • 10319 Answers

SOURCE: 2001 chevy silverado leaking steering fluid by the fluid resevoir

Most likely the hose needs to be replaced or the clamp is loose from age

Posted on Jun 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevrolet diagrams


Mary, 2003 Chevrolet Silverado 2500HD suspension and steering diagrams. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2003 Chevrolet Silverado 2500 Parts GM Parts Department Buy genuine GM...
2003 Chevrolet Silverado 2500 HD Parts GM Parts Online GM Parts Direct
Chevrolet Silverado 2500 HD Ball Joints eBay
How To Install Replace Inner Tie Rod Chevy Silverado GMC Sierra 99 06...

Aug 02, 2014 | 2003 Chevrolet Silverado 2500HD

1 Answer

I need to replace the two top bearings on my 1982 Chevy Silverado K10, Tilt wheel steering column. How do I take it apart?


It is doable if you have the right pullers.
Take off the steering wheel (special puller)
Remove steering lock plate lock ring and plate(special puller)
Remove ignition key and tumbler
Remove T/S switch you should be able to get to top brng
Disengage tilt wheel spring
Take apart dimmer switch assy ( remember how it goes)
Remove 4 bolts connecting collar to steering shaft
Rotate collar upward to remove from shaft
With collar off, you can get to the lower brng.

Oct 31, 2013 | Chevrolet Silverado Cars & Trucks

1 Answer

1982 C30 silverado dually 7.3ltr towing capacity


call the chevy dealers in your are they will know this info also call chevy corp or gmc thay can help you out

Jan 24, 2013 | Chevrolet Cars & Trucks

1 Answer

How do i adjust/fix play in steering


There is a 'dampener' on the steering box- it is a nut that surrounds a bolt (I think it has a allen head)-loosen the surround bolt and tighten the bolt, it dampens the recirculating ball in the steering box. Other than that, steering linkage parts and proper tire alignment are the only other factors that determine 'play' or lack thereof-the steering box can also have slop in it that might require either a rebuild or replacement.

Nov 16, 2011 | 1982 Chevrolet El Camino

1 Answer

I need a steering coloum for a 1982 chevy half ton two wheel drive. I would like to know whitch years will interchange?


You should be able to get one from 1980-1987. The model chqanged in 1988. It's quite possible that pre 1980 will also fit since the change in1980 was mostly cosmetic. Hope this helps.

Jan 28, 2011 | 1983 Chevrolet Silverado

1 Answer

How to remove and install a steering box w power in 1982 chevy van 250 engine ...will I need special tools,etc...? Hopefully with pictures of procedure...Thanx...Greg


the only special tool you'll need is a "pickle fork" to remove the pitman arm off the old gear box.
You can find this pickle fork at your local auto parts store to buy or rent.

Oct 12, 2009 | 1985 Chevrolet Chevy

1 Answer

How to replace rack and pinion on chevy 2003 silverado


Silverados do not have rack and pinion steering. The steering box is bolted to the frame on the drivers side, that can be removed by removing the bolts holding it on, the steering shaft bolts, and the pitman arm.

Aug 13, 2009 | 2003 Chevrolet Silverado 1500

1 Answer

Power steering and brake line location2002 Chevy Silverado 2500HD


the power steering lines are very short hoses approximately 8 inches long that go from the power steering pump down to the steering box, which is located on the frame, just below the pump. The brake lines run from the master cylinder(where you fill it with fluid on the drivers side firewall) down to the frame, and then follow the frame both directions; both to the front end and the rear end, along the drivers side frame rail, just on the inside of it. The fuel line runs along the same path to the rear.

Mar 03, 2009 | 2002 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...