Question about 2002 Chevrolet TrailBlazer

1 Answer

Need info on how to remove radio on 2002 Chev Trailblazer?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Expert
  • 225 Answers

Pretty easy on your truck. You have to remove the dash trim. Yours should be one piece including the trim around the radio. You will need to tilt the steering wheel down to wiggle the trim out from around the back of it. After that the radio is easy to get at and the mounting screws are easy to see. There is just enough extra length on the wiring harness to pull it out so you can unplug the connector.

May want to wipe down the faces of all your gauges while you are at it.

Posted on Oct 16, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 255 Answers

SOURCE: chev trailblazer strut removal

Hi, removal of the struts need some mechanical knoledge and must be carefull removing the spings,secure your car with a jack stand remove the tire ,position a jack onder lower control arm,disconect brake line ,remove the three screws on top of the strut ,remove the two nuts and screws at the lower end of the strut ,lower the jack slowly ,the strut assembly should come out, you need a strut sprig compressor to compress.the springs,remove the nut at the center of the strut,rplace the stut,instalation is the reverse of the procedure..Good Luck

Posted on Aug 17, 2008

tripletauto
  • 1450 Answers

SOURCE: lower ball joint removal how to

  1. Remove the steering knuckle with wheel hub and bearing attached.
  2. Remove the lower ball joint flange with a chisel.
  3. Install J9519-E and J34874 to the lower ball joint.
  4. Remove the lower ball joint from the lower control arm using J9519-E and J34874


  1. Install the lower ball joint and J9519-E, J41435, and J45105-2 to the lower control arm.
  2. Install the lower ball joint to the lower control arm using J9519-E, J41435, and J45105-2.
  3. Remove J9519-E, J41435, and J45105-2 from the lower control arm
    1. Install J9519-E and J45105-1 to the lower ball joint.
    2. Flare the lower ball joint flange using J9519-E and J45105-1.
    3. Remove J9519-E and J45105-1 from the lower ball joint.
    4. Install the steering knuckle with wheel hub and bearing attached. Install the tire and wheel.
    1. Lower the vehicle.
    2. Check the front wheel alignment.
these jouints are pressed in and there is a flange that is flared this is what the tool numbers refer too.

Posted on Sep 12, 2008

  • 393 Answers

SOURCE: 2002 CHev.Trailblazer license plate lights

check and make sure the bulbs are not loosing their ground

Posted on Nov 15, 2008

CMR_Racing
  • 24 Answers

SOURCE: cds trap in 2002 Trailblazer factory installed am-fm mp3 player

you should be able to pull it out and take the top off

Posted on Dec 13, 2009

alicantecoli
  • 22095 Answers

SOURCE: how do i remove alternator? 06 Chev Trailblazer

if you cannot remove the bolt then remove whatever is blocking your access

Posted on Apr 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a sound like a vacuum leak under dash and brakes are very hard to engage 2002 chev trailblazer


Your brake booster is bad. Remove the brake master cylinder under the hood. Then on the inside,under the dash, remove the nuts for the booster.

Jul 24, 2015 | 2002 Chevrolet Chevrolet TrailBlazer LS

1 Answer

2002 chev trailblazer locks in park and locks key in ignition, vehicle will not start or turn over?


Sounds like you need a new ignition switch, not the one that the key goes into, but the actual ignition switch....it's black and it's located on the bottom of the column. Pretty easy job, and is common to go out.

To remove your key....your year had a hole in the plastic, on the bottom side of the steering column, just below the key......some may have been filled or not done at all. Some have an outline of a hole that can be drilled or cut out. Either way, this is an access hole to the solenoid to remove your key. Press this in and your key will come out.

Mar 08, 2011 | 2002 Chevrolet TrailBlazer

1 Answer

Where is the cam sensos located on 2002 chev.


See number one left hand side of the front of the engine
487648.gif

Jul 29, 2010 | 2003 Chevrolet Trailblazer Ext

1 Answer

How do i remove alternator? 06 Chev Trailblazer


if you cannot remove the bolt then remove whatever is blocking your access

Apr 25, 2010 | 2006 Chevrolet Trailblazer

1 Answer

My passenger window will not go down and my door will not unlock/lock with the keyless entry control on my 2002 chev. trailblazer, what kind of part do I need and how much does it cost?


you will need to replace the drtivers side master control switch module this will solve the problem. often times the contacts inside the module wear through constan t use.

Apr 18, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

How do i replace the license plate bulbs on a 2002 chev trailblazer


There will be one or two screws or push pins securing the lense. Remove the screw or pin and pull the lense out. Twist the bulb socket and pull out the bulb. If you haven't already purchased the replacement bulbs, it will use a 194 bulb.

Apr 17, 2009 | 2002 Chevrolet TrailBlazer

1 Answer

Need to replace oxygen sensor in chev trailblazer 2002 LS-failed


Yes.....but it would help to get the socket for it. It looks like a normal socket but has a **** down the side to aid in the wires going to it.

Apr 02, 2009 | 2002 Chevrolet TrailBlazer

2 Answers

Key stuck in ignition of 2002 chev. trailblazer


Remove the cover of the switch, there is a silver button below the place where you put the key. Press it and the key will be released!

Dec 21, 2008 | 2002 Chevrolet TrailBlazer

1 Answer

2002 CHev.Trailblazer license plate lights


check and make sure the bulbs are not loosing their ground

Nov 15, 2008 | 2002 Chevrolet TrailBlazer

1 Answer

Chev trailblazer strut removal


Hi, removal of the struts need some mechanical knoledge and must be carefull removing the spings,secure your car with a jack stand remove the tire ,position a jack onder lower control arm,disconect brake line ,remove the three screws on top of the strut ,remove the two nuts and screws at the lower end of the strut ,lower the jack slowly ,the strut assembly should come out, you need a strut sprig compressor to compress.the springs,remove the nut at the center of the strut,rplace the stut,instalation is the reverse of the procedure..Good Luck

Jul 09, 2008 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
2002 Chevrolet TrailBlazer Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...