Question about 1998 Chevrolet C1500
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
carefully use a screwdriver or chisel to pry the interior panel off of the door...it's thin, like an upholstered piece of hard board, held on by plastic ribbed push-studs, every so often. Those studs can be pryed out and pushed in to reinstall many times if you're careful but I did manage to break one on my truck. Of course there is also a couple of screws near the door handle as I recall but they are visible. A small piece of triangular shaped plastic must also be popped / pryed off of the forward window area. I'm drinking right now, but I think you may have to drill out a rivet to remove the old handle assembly but it is really easy, just pick a drill bit about the same diameter as the rivet and drill it till it falls apart. Install the new assembly with a pop rivet of your own. good luck
Posted on Feb 09, 2009
On all C/K's of this body-type 88-98, the fuel filter is located under the driver's side door inside the frame rail near the crossmember that supports the tail of the transmission. Replace it with AC Delco part GF-626, FRAM part G3727, or other comparable brand corresponding metal bodied filter. You should use a flare-nut wrench for the line fitting and one for the filter fitting. I'm not sure of the size needed for the filter, but the line should be 5/8". For SFI engines ('96 and later) you need to bleed off the pressure in the line. Locate the pressure test port on the fuel rail under the hood, remove the cap, press valve to relieve line pressure and recap valve. If ground clearance is not high enough to get under vehicle and work, raise it with jack and rest frame on jackstands. * Caution: Fuel in lines and filter will run out once fittings are undone. Use fuel safe container to catch fuel spill. Take wrenches and hold filter from rotating, while loosening line fittings. Remove Filter from bracket by sliding and manipulating fuel lines for clearance, and slide filter out of bracket. Reassembly is reverse of disassembly. Tighten fittings snugly. Reconnect battery, turn ignition on (do not start). Pump will make brief whirring sound - less than 5 seconds. Check for leaks. No leaks - good. Now you can drive again.
Posted on Nov 04, 2009
Testimonial: "Thanks For the tips should i use Plumbers tape on both ends of fuel filter before tightening?"
Hello, the steering position sensor just snaps into the bottom of the steering column. remove the steering shaft at the bottom of steering column, then slide the sensor off
Posted on Jun 19, 2010
Tips for a great answer:
Aug 18, 2014 | 1998 Chevrolet Blazer
Jul 15, 2014 | 1998 Chevrolet C1500
Jun 01, 2014 | 1984 Chevrolet C1500
Jun 04, 2011 | 1998 Chevrolet C1500
Oct 02, 2010 | 1998 Chevrolet C1500
Jan 17, 2010 | 1998 Chevrolet C1500
Nov 15, 2009 | 1998 Chevrolet C1500
Jun 19, 2014 | 1998 Chevrolet C1500
59 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: