Question about 1997 Kia Sportage
Where would I find the port location for obd2 reader on a kia sportage right hand drive steering
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Rule of thumb...unless you get a better answer: look for a couple of wires on a small plate that is in the airflow of the fan on the heater/ac unit. The resistor pack is always air cooled by the fan.
Posted on Nov 11, 2008
The fuel filter is bolted to the frame rail below right of the battery. It is cylinder shaped and has a fuel line at each end.
Procedure for removing it:
Find the fuel tank access plate under the rear seat. With the engine idling disconnect the fuel pump wiring harness and let the engine stall. This relieves the fuel pressure.
The lines on the fuel filter itself are "quick connect" fittings. Depress the tabs on the fuel line and push TOWARDS the filter. The line should pop off. It's difficult to depress the tabs and you CAN use a pair of pliers but be careful or you'll damage the fitting.
Reverse to install new filter. Reconnect fuel pump, start the engine, and check for leaks.
Posted on Aug 14, 2009
They are under the black plastic cover that is in the middle of your valve cover gasket. Remove the intake hose from the aluminum intake plenum on top of the valve cover and the silencer box against the firewall. Remove all the connectors from the sensors which should be 2 on the plenum and the 2 large vacuum hoses on the plenum. Then remove the 3 12mm bolts from the plenum at the throttle body and remove the plenum. You can reuse the throttle body gasket at the plenum so don't destroy it. All the other bolts are 10mm and use a screwdriver to loosen the clamps on the hose. The sensors have clips that you need to remove with a small screwdriver, then disconnect them. Remove the bolts on the cover and the cover. Then remove the bolts holding the coil packs down. Do one plug at a time. 2 of them are connected to the 2 plug wires and 2 are underneath the 2 coil packs. The connectors on the coil packs are fragile so remove them carefully. Reverse the steps to reinstall the plenum, etc.
Posted on May 20, 2010
Tips for a great answer:
Feb 05, 2017 | 2002 Suzuki Aerio
Jul 25, 2015 | Hummer Cars & Trucks
Apr 30, 2015 | 1997 Kia Sportage
Feb 20, 2014 | 2002 Suzuki Grand Vitara
Feb 18, 2014 | 1996 Honda Accord
Aug 06, 2013 | 2008 Dodge Nitro
Feb 12, 2012 | 1993 Chevrolet S-10
Aug 03, 2010 | 2002 Toyota MR2 Spyder
Feb 11, 2010 | 2001 Kia Sportage
Aug 18, 2009 | 1995 Honda Accord
40 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: