Question about 2007 Dodge Magnum SRT8 Wagon
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2006 dodge magnum check engine
Get in the car, close the door. Perform the following steps fairly quickly (less than 3 seconds) :
Turn key to ON
then back to ACC
then to ON
then back to ACC
then to ON
If there are any stored codes, they will appear immediately, in place of the odometer. For instance an "INTAKE AIR TEMPERATURE SENSOR CIRCUIT HIGH" error will set a code of P0113.
You may also try and pull Fuse 11, and wait 10-15 seconds to reset the cars internal computers.
More information can be foudn here: http://www.custommagnums.com/forums/misc-mods/1361-how-check-obd-2-codes.html
Posted on Jan 15, 2009
SOURCE: 2005 Dodge Magnum error code...
Your heated O2 sensor has a heeater problem most likely. Most likely time to change out your HO2 sensor. Most cars actually have only primary heated. Not sure for this application but would thus assume the primary sensor or otherwise known as precat O2.
With a sensor high you have high voltage back to the pcm thus most likely shorted heating element.
There is an outside chance of a cross short to the ground circuit of your O2 sensor. If after replacing your sensor you still have a problem then start looking for this.
I see you went to the auto parts store and got an HO2 sensor (Should be a 22mm or 7/8" -- same size) and replace the Primary and if that do not solve the problem, then see if you have a heated postcat HO2 if not then see above.
Good luck and hope this helps, oh and Bank 1 is where your #1 cylinder is.
Posted on May 13, 2009
SOURCE: error code p0128
It is very likely your thermostat is stuck open. Replace the thermostat and it should be fine.
P0128 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature)
Posted on Oct 03, 2009
the esp stands for electronic stability program,you will need to have the computer scanned for codes, these codes will help in the repair,you may have a bad speed sensor or the check engine light may have shut down the esp,when the engine detects a problem it shuts down the esp because it feels that the esp cant operate correctly when the engine is not running correctly,so the first thing is to scan for the codes, hope this helps, good luck,
Posted on May 10, 2010
Tips for a great answer:
Feb 12, 2015 | 2011 Dodge Ram 2500
Dec 29, 2012 | 2005 Dodge Magnum
Jan 17, 2012 | 2007 Dodge Magnum SE
Sep 20, 2011 | Dodge Charger Cars & Trucks
May 10, 2010 | 2005 Dodge Magnum
Oct 03, 2009 | 2006 Dodge Magnum
28 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: