Question about GMC Canyon

Open Question

Code b2960 - Canyon GMC Cars & Trucks

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2004 Buick Rendevouz, and am having a problem with the Passkey 3 system not engaging the starter. clicks inside the vehicle at two relays and at BCM. starter works with wire to battery


How do you know it's a passkey 3 anti-theft system problem ? Light lit on the insturment cluster ? Padlock car symbol . If the security light is lit ,do you have a scan tool that can read these codes
DTC B2960
DTC B3031
DTC B3055
DTC P1626
DTC P1629
DTC P1630
DTC P1631

Not a code reader for the Engine OBD 2 codes .

Aug 23, 2017 | Buick Cars & Trucks

1 Answer

2001 Cadillac debille security light stays on some times flashes but runs how do you find what resistanc the chip has with a meater and were you put it. to by pass


There is no resistance you can check , no place to by-pass anything . If the security light is on have it checked for DTC'S - diagnostice trouble codes . This will say what to check !

DTC B2734
DTC B2960
DTC B3031
DTC B3055
DTC P1630
DTC P1631

Autozone , napa , advance , pep boys , none of these can check for these codes , Dealer !

When an ignition key is inserted into the ignition lock cylinder, the transponder embedded in the head of the key is energized by the exciter coils surrounding the ignition lock cylinder. The energized transponder transmits a signal that contains its unique value, which is received by the theft deterrent control module. The theft deterrent control module then compares this value to a value stored in memory (learned key code). If the value is correct the theft deterrent control module sends the enable password via the serial data circuit to the powertrain control module (PCM).

Mar 24, 2017 | Cadillac Cars & Trucks

1 Answer

2000 Pontiac Montana 3400 3.4 V-6. The security system is engaged showing low fuel but its full, the 10min. reset didn't work. What is a hard fault? Please help..


You need to have a scan tool hooked up to read DTC'S diagnostic trouble codes ! These would be hard faults .
DTC 6 Theft Deterrent Relay Control Circuit Shorted
DTC B2734 Coded Key Controller Memory Failure
DTC B2960 Invalid Coded Key Present
DTC B3031 Key Decoder Device in Assem Learn Mode
DTC B3055 Key Not Present.
Do you have another key you can try .

Oct 27, 2016 | Pontiac Cars & Trucks

1 Answer

My 1999 chevy silverado starts and dies within two seconds. has anyone had this experience before and how did you fix it?


does it have a b2960 security code set, i bet it does, it probably has a security problem and is going into fuel shut off, try replacing the ignition switch harness, this is 98% of the time the problem

Jan 15, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

How do you reset the security light on a 2005 chevy cobalt?


There is no reset , if security light is lit there is a problem with the anti-theft system .Should have it checked for DTC'S - diagnostic trouble codes . Could have 8 different B - codes
DTC B0685 DTC B2955 DTC B2960 DTC B3031 DTC B3033 DTC P1626 DTC P1630 DTC P1631
You would need a professional type scan tool to read these type codes , not an OBD 2 code reader .

Apr 14, 2012 | Cars & Trucks

2 Answers

2001 chevy express van 3500 while driving security light comes on dash then engine shuts down , once pulled off the road it will start back up.. did this 3 times on hour drive.. feels like gas pedal just...


You need to get the codes from the theft deterrent module.Usually a B2960.This will help in the diagnosis of the problem.Hope this helps.Good luck.

Apr 07, 2010 | 2001 Chevrolet Express

1 Answer

I have a problem whith the passlock i want to know how to bypass it thanks


THERE IS NO BYPASS FOR THIS SYSTEM. THE PASS LOCK SENSOR IS LOCATED IN THE IGNITION SWITCH HOUSING IN THE STEERING COLUMN AND HAS TO RECIEVE A SIGNAL FROM THE ROTATION OF THE IGNITION SWITCH TO ENABLE STARTUP. IF IT IS SETTING A B2960 CODE OR SOMETHING RELATED TO PASS LOCK SENSOR IT NEEDS TO BE REPLACED AND REPROGRAMMED. THERE IS A MANUAL PROCEDURE FOR THIS SHOULD YOU DECIDE TO REPLACE IT.

Aug 31, 2009 | 2003 Chevrolet Impala

2 Answers

Security light/oldsmobile alero


do not cut wires replace ignition lock cylinder possible code b2960

Dec 02, 2008 | 1999 Oldsmobile Alero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...