Question about 1997 Chrysler Concorde

Open Question

Engine code check kwpadd

Ecu light up sometimes car lacking in power

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 67 Answers

SOURCE: car is a 2003 PT

The P0700 is a general transmission control fault. It would be very difficult for an individual lacking expensive equipment to figure this out, I would take the vehicle to a transmission shop or chrysler dealer.

Posted on Mar 27, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 jetta turbo no power


Lack of fuel.
Boost hose off or split.
ECU detected Over Boost and engine now in default.
Do you get normal power after restart? If so, ECU is limiting power as it has detected a problem. Need scanner to determin what code/s has been set in ECU.

The boost hose under the engine on the right side
where it goes to the turbo has a habit of coming apart at the clip .

Mar 11, 2014 | 1998 Volkswagen Jetta

1 Answer

2006 VW Jetta code U0100


This problem is with ecu / ecm= engine control computer. These are a common and horrible problem on vw's, particularly on tdi's. The signs in a tdi are when car dash lights come on, but no glow plug light,trans gear lights flash, but car still tries to crank. And hopefully ecu has enough power to out out code u0100= no communication with ecu. Unfortunately the ecu will need to be replacd. The ecu is located under the hood, near and under the wipers. Used ecu with same codes run $50-200. New $1000. If get used one make sure has a return policy. codes must match production quarterly year.

Apr 14, 2013 | 2006 Volkswagen Jetta

1 Answer

I Have a 94 cherokee country with a 56028297 ecu,it has no power at the grey wire at the ecu,it does flash sometimes and I can hear the relay work sometimes. I can bypass the fuel pump relay circuit and...


If you hear relays clicking sometimes and the jeep won't start, at those times, is the check engine light illuminated on the dash, or not? If no check engine light is on the dash, at times when the jeep won't start, your ecu is in need of repairs. The ecu sends power to the ignition and fuel relays and when the ecu starts to malfunction, the relays usually start clicking.

May 11, 2011 | Jeep Cherokee Cars & Trucks

1 Answer

Sometimes i get lack of power,this seems tobe intermittent?its as if there is a delay of about 3 seconds,sometimes i smell fuel.ive changed plugs and air filter.please can u help?


is the check engine light on?
this could be a number of different sensors(mass air flow, crankshaft position sensor etc), or even a wet ECU.

I have a 99 M3 (new to 400,000 kms), had to change the ECU twice now. ecu compartment gets wet. Wet circuit boards do lots of different things. If you've checked most of the standard stuff plus, coils, check the ECU box area below the windshield passenger side.

mine started with a replacement windshield, grounded off area never retouched with paint and rusted out, water off the windshield drained into the ecu compartrment and soaked the ECU slightly different results when things got wet,

Jan 30, 2010 | 1999 BMW 323 Series

1 Answer

I have 2 Bmw's. The one 330i is manual and the other Automatic. My problem is the automatic 330i holds back on the power, really holds back on power. Sometimes it wants to perform and sometimes when you...


check for a wet ecu...
read below on the e36

the ecu compartment is under the windshield on the passenger side on E36

you gain acess to it under the hood....
this compartment gets wet, the ecu lays on a flat surface in that
compartment.

the bottom side of the circuit board gets wet and starts corrosion.

remove the ecu, take the bottom plate off, clean the bottom of the circuit
board with alcohol and a soft tooth brush.

you should be able to see the signs of corrosion or conductive build up.

this gunk bridges solder points doing all sort s of wierd things to your
car, including false sensor readings from asc/abs controllers and other
sensors....

all the way to engine failure and worst case burnt and shorted wiring
harness.

I'm on my 3rd ecu, took me and the repair boys a few years to figure this
one out.

BTW: i would get that ecu mounted above that flat surface, use some sort
of standoff to raise it so that it is not laying in the wet.

Dec 27, 2009 | 2001 BMW 330

1 Answer

Lack of power renault software fault code df055


Fault code description: DF055 Coded line circuit,Short circuit to +12V.Active - this code DF055 is Cylinder 4 injector circuit

Try checking the voltage on the immo wire that connects the immo ecu with the engin ecu this is the coded line. on this wire must be a signal and the Max. amplitude is 5v. if you measure more than 5 volts then check wire or any interference on it . if you dont know where to find the wire then look for pin 59 at engine ecu .

Oct 23, 2009 | Renault Sportwagon Cars & Trucks

1 Answer

Lack of power


LOTS OF THINGS!... did the CHECK ENGINE light come on? Whenever the 'CHECK ENGINE' (Service Engine Soon) light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on.
You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE the problem and perhaps eventually fix the problem.

Aug 25, 2009 | 1996 Hyundai Accent

1 Answer

Legacy lacking power and using lots of fuel


Are you sure its the transmission ecu that is the problem ?
Are you getting any engine ecu error codes ?
Sounds to me like its going into limp home mode.....
Crankshaft sensor ?
Camshaft sensor ?
Engine ecu ?
Thats where I would be looking ........
Looking forward to your reply.

Jun 29, 2009 | 1993 Subaru Legacy

1 Answer

"service engine soon" light is on continuous, and lack of power


without a code Check.. Its impossible to know exactly why the Light is on..Dont throw parts at it without a code check..Autozone does them free.. No excuse LOL Thanx

Mar 11, 2009 | 2002 Ford E250

Not finding what you are looking for?
1997 Chrysler Concorde Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...