You mean the park lamps.
the park lamp (HL switch 1 click, is park or as some call it tail or other running. same o samo)
the park circuit is the most complex lighing inthe car.
2 front, 3 rear.
4 sides.
and 10 in dash. and console, as many as 20 in all.
so if all work but some, the lamps are out, replace them.
how , as in how to remove them. ok.
there are basically 3 ways from 1920 to now, all cars on earth.
1: take out the lenses screws and , remove bulb
2: if no screw, look behind lamp. see screws, or nuts, bingo
3: last, on some cars the lenses pry out. do this last so you dont break the lenes.
there are exceptions, on some cars ring snaps on the lens locking it. pry it off,
in most cars, open the operator guide, see index
see lighting, turn to that page see lamp change out, bingo
lost the op guide?, Google will Find them all,, no need to guess, RTM.
On this make the warning lights all come on together, the check engine light is the cause of all.
Hello
When the service engine
soon light (Also called the check engine light or engine management
light) is turned on this is to alert you to the fact that Powertrain
Control Module (computer) has detected a failure somewhere in the
systems it controls you may not feel any difference in the way the
engine runs, this can be the transmission or the engine or emission
system, there are fault codes set in the modules memory for these
faults. What needs to happen now is to have the powertrain control
module scanned with a special tool called an OBD2 electronic engine
control scanner or a OBD2 code reader. Once the code(s) are read then
you must perform the diagnostics for each code and make the
appropriate repairs based on the findings of the diagnosis that was
performed, this is called doing "Pinpoint" testing.
89 views
Usually answered in minutes!
×