Question about 2007 Toyota Hilux 2.7
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: How to reset timing belt light
to reset the light you need to remove speedo dash assembly ,on the back of the printed curcuit there is a small screw and a hole next to it remove screw and fit to empty hole . refit assembly
Posted on May 07, 2009
go have a look at the feul filter (prsuming its deise and that it is the only light staying on after startingl) under there will be a little white butterfly nut loosen this nut and see if water or diesel poors out of there or alternatly replace the filter easy to do ,or do what every one else does and diconect the wire ,but there is always gonna be a result from not doing it correctly,good luck
Posted on May 17, 2009
More than likely you have some bent valves which can lead to alot of money to fix. If you can do it yourself try to find a wrecked one or one with a bad bottom end and just get there cylinder heads and put on your motor with a new timing belt.
Posted on Sep 24, 2009
2005 3.0 TD Hilux
with key off hold odometer button in while continuing holding button in turn key to the on position release button when fuel light goes out then pushing button in again gives you a series of numbers from 1 - 20 set to 15 (150000km's) and hold button in again until T-Belt light goes out.
Posted on Jul 04, 2011
Remove the key from the ignition but keep it handy. Important: Disconnect the negative terminal of the battery for longer than 90 seconds to prevent the risk of having the airbags deploy! Replace the diesel filter (Follow the instructions that can be found in Toyota service manuals (search www). Remove the diesel filter sensor cable (the one on top of the filter assembly). Make sure the new O-rings seat properly. Close the filter assembly by turning the locking ring until it clicks. Bleed the filter assembly by pushing the little plunger thing on the top of the assembly until pumping becomes difficult. Connect the negative back onto the battery. Insert the key in the lock and turn until the dashboard warning lamps come on, but do not start the car yet. Within 3 to 60 seconds of doing this re-connect the diesel flter sensor cable. The light should be extinguished. Obviously there could be another problem causing the light to remain on (not flashing - steady on). If the light is flashing, then you have water in the system and should follow the answer supplied elsewhere by someone else to drain the water. Now start the car and enjoy clean diesel fuel driving. You should really not wait for the light to come on steady before chnaging the filter. Some fanatics believe every 10,000km is the longest you should wait, but this depends on fuel quality, low or high sulfur content, etc. Rather do it more frequently than having to buy new injectors.
Posted on Jul 28, 2012
Tips for a great answer:
Aug 17, 2016 | 2007 Toyota Hilux 2.5
Mar 03, 2016 | Toyota Cars & Trucks
Aug 19, 2015 | 2006 Toyota Hilux 3.0
Feb 11, 2015 | Toyota Cars & Trucks
Dec 02, 2014 | Toyota Cars & Trucks
Jul 16, 2014 | 2007 Toyota Hilux 2.7
Nov 21, 2013 | 1991 Toyota Pickup
Dec 12, 2010 | 2002 Toyota Land Cruiser
Aug 29, 2009 | 2004 Toyota Land Cruiser
29 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: