Question about Cadillac SRX

Open Question

2005 cadillac srx battery draining, battery good

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: where is the oil filter located on a cadillac srx

Directly under the engine. You'll see a large smooth portion under there that looks like the underside of a bath tub and on the lowest portion of that is a bolt. Thats your oil reservoir where you drain your oil. The filter should be located near that pointing toward the front of the vehicle. GM OEM filters are usually black but could be white and are almost always 3" filters so a filter wrench that fits a 3" filter will get it off without problem.

Posted on Nov 13, 2009

Testimonial: "Thanks forn the help! This info has been hard to find from other sources. Again thanks!"

Ad
techbuster
  • 5081 Answers

SOURCE: rear liscese plate bulbs on 05 cadillac srx

First you have to take out the one and only screw in the rear hatch door - it's where the hand pull down is you use to close the hatch.
Then you have to pop all the plastic clips all the way around the plastic door panel, trying not to pull them out from the frame . If you do pull out the white plastic plugs from the frame you better make certain you take them off the plastic housing and insert them back into their frame holes - or you will never get the housing back on.

Once you have the housing loose disconnect the inside tail gate light wire to remove the whole thing. Then you have to remove 7 to 8 nuts from the back of entire License plate, back up bulb housing using a deep socket to get in there. Work it loose from the rear of the car and it will come out just enough to work on the lights.
This is tricky since the screw mounts don't give you much room to work with.

Once you have the license plate and back up bulb frame loose you will see the two housings for the license plate bulbs on top.

Slide out the license plate bulb lens and twist the bulb connection to remove the bulbs.
Replace both of them - you don't want to do this again in a month when the other one blows.

OPTIONAL:
Once you take out the bulbs you might see that the housing is melted where the bulb wanted to burn through. Drill two small holes one is each end of the housing before I put everything back together to release some of the heat.


Reverse the whole process to put everything back together. It's not easy.
Make sure you insert the cables through the opening for the hatch handle or it will kink and not work properly.

The bulbs come in a two pack of cost $4.95 .

Posted on Nov 24, 2009

  • 389 Answers

SOURCE: where is oil drain plug on 2005 V8 SRX caddilac

crawl under the car with a drain contaner and a cresent wrench. Under the engine is the oil pan. The drain plug is located on the bottom end or slightly above on the side. It may be covered in dirt so scrap around. It has to be there. No other place for the oil to come out. It is possable it is a plug type with a large allen wrench hole or a squar hole that a ratchet will fit in to but most of them it is a bolt type. Don't forget to change the oil filter when changing oil. Let me know if this helps, The Raz

Posted on Apr 17, 2010

Sheikhtijani
  • 1284 Answers

SOURCE: how do you replace license

Hi,
First you have to take out the one and only screw in the rear hatch door - it's where the hand pull down is you use to close the hatch.
Then you have to pop all the plastic clips all the way around the plastic door panel, trying not to pull them out from the frame . If you do pull out the white plastic plugs from the frame you better make certain you take them off the plastic housing and insert them back into their frame holes - or you will never get the housing back on.

Once you have the housing loose disconnect the inside tail gate light wire to remove the whole thing. Then you have to remove 7 to 8 nuts from the back of entire License plate, back up bulb housing using a deep socket to get in there. Work it loose from the rear of the car and it will come out just enough to work on the lights.
This is tricky since the screw mounts don't give you much room to work with.

Once you have the license plate and back up bulb frame loose you will see the two housings for the license plate bulbs on top.

Slide out the license plate bulb lens and twist the bulb connection to remove the bulbs.
Replace both of them - you don't want to do this again in a month when the other one blows.

OPTIONAL:
Once you take out the bulbs you might see that the housing is melted where the bulb wanted to burn through. Drill two small holes one is each end of the housing before I put everything back together to release some of the heat.


Reverse the whole process to put everything back together. It's not easy.
Make sure you insert the cables through the opening for the hatch handle or it will kink and not work properly.

The bulbs come in a two pack of cost $4.95 .

Take care

Posted on Jul 28, 2010

  • 2841 Answers

SOURCE: on a 2005 cadillac srx, v6, how are the cylinder

The firing order is 1-2-3-4-5-6. Cylinders are located on the driver's side front to rear of engine 1-3-5 passenger side front to rear 2-4-6.

Posted on Aug 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

All power light come on over dash for a 2005 Cadillac SRX, but won't come on. What is wrong?


Marvin, 1st thing if able to do so, is check for good battery, it should be no lower then 12.2 volts to enable vehicle to start. A good charged battery would be 14.4 volts or higher.
If you know battery is OK, I would say that your cars security system has been activated and you will have to follow instructions from your manual to reset security.
Security not the issue check, fuses, starter relay, if found to be OK, starter is defective.
Show your appreciation, press the helpful button and follow me on fixya for more tips and info

Feb 18, 2016 | 2005 Cadillac SRX

1 Answer

Where is my dipstick located on my 2006 srx cadillac


Hi Amber,
I presume that you want to change the oil on the Cadillac. The link below will tell you how to change the oil, where the drain plug is and where the filler is a. It will tell you where the dipstick is.
Oil Filter Change Cadillac SRX 2004 2009 2006 Cadillac SRX 3 6L V6
This is a good, clear video.

Mar 04, 2015 | 2006 Cadillac SRX

1 Answer

Open my hood on 2005 Cadillac srx battery dead keys don't work


Plug a charger into the cigarette lighter or connect a charger to the frame and the positive wire to the large starter wire under the car. This will give enough power to operate the locks.

Oct 14, 2014 | 2005 Cadillac SRX

1 Answer

Something is draining my battery on 2006 cad srx


Do a Parasitic Current Drain Test

Go to You Tube Video & watch how

Apr 08, 2014 | 2006 Cadillac SRX

1 Answer

2005 cadillac srx dash was going crazy/dead battery


Make sure your that the transmission is in Park "P" position in order to removed the key. I will suggest you to take your battery to your local Auto Parts to run a diagnostic to confirm that the battery will not longer hold power. If the battery is dead it means that it is time to replaced. Good Luck!

Jan 13, 2014 | 2004 Cadillac SRX

1 Answer

Intermitant battery drainage 2007 cadillac srx


Hi.

First ensure that battery is OK. If battery drains while driving, then the problem is related to alternator. Check that there is no problem with dome light or other device staying on because of a shorted switch.

If the rest is OK and battery drains when the truck is parked, check for contacts that may result in parasitic drains. See : Parasitic Battery Drain.

Regards.

Ginko

Apr 05, 2011 | 2007 Cadillac SRX

1 Answer

How do I replace the battery in my 2005 Cadillac srx?


how to replace the battery in my 2004 cadillac srx

Oct 24, 2010 | 2005 Cadillac SRX

1 Answer

Where is oil drain plug on 2005 V8 SRX caddilac


crawl under the car with a drain contaner and a cresent wrench. Under the engine is the oil pan. The drain plug is located on the bottom end or slightly above on the side. It may be covered in dirt so scrap around. It has to be there. No other place for the oil to come out. It is possable it is a plug type with a large allen wrench hole or a squar hole that a ratchet will fit in to but most of them it is a bolt type. Don't forget to change the oil filter when changing oil. Let me know if this helps, The Raz

Apr 17, 2010 | 2006 Cadillac SRX

3 Answers

I have one low cell for my 2005 srx. do i need a


WHEN YOU REPLACE BATTERY.MAKE SURE NEW BATTERY HAS THE SAME COLD CRANKING AMPS OLD BATTERY HAS.IF YOU NOT SURE YOUR OWNERS MANUAL WILL TELL YOU OR THE AUTO PARTS PLACE WILL FIND WHAT YOU NEED.BUT IF THAT YOUR ORIGINAL BATTERY LOOK ON TOP OR SIDES.YOU WILL SEE WHAT CCAMPS YOU NEED.TURN OFF RADIO BEFORE DISCONNECTING BATTERY SO YOU WONT LOSE CODE.

Nov 13, 2009 | 2005 Cadillac SRX

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...