Question about Isuzu Ascender

1 Answer

I have a 04 isuzu ascender windows wont work from drivers door control

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 192 Answers

Check for broken wires in the harness on the hinged side of the drivers door. The wires usually break in the center space where they are bent back and forth from the door opening and closing.

Posted on Oct 16, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Isuzu Ascender Fuel Filter

The fuel filter is located with the fuel pump inside the gas tank

Posted on Oct 28, 2008

  • 55 Answers

SOURCE: power windows

This means you need to head to the junk yard and replace the unit that controlls all the windows from the drivers seat. Very simple fix. Good luck

Posted on Dec 30, 2008

  • 2 Answers

SOURCE: 04 Jeep Power Windows

THIS REALLY WORKS****** Saved atleast $600 easy
Ok so when you open your driver door there is a black boot that goes from the body of Jeep to the door (inside the Jam when you open door-its visable) Take this loose...inside there is a wire bundle...there was a black and orange wire in there that were both broken....All we did was strip these and reconnect them w/ connector....Voila..windows all roll up and down..interior lights come on and the locks work and the power mirrors....I AM SO HAPPY THAT THIS WORKED SAVED ME SO MUCH $$$$

Posted on Feb 09, 2009

  • 172 Answers

SOURCE: power windows and power locks wont work

Check your fuses first. Then check for power at the switches, and power from the switches to the respective solenoid and motor. Most likely it's fuses. Also check where the wiring runs through the door into the car for bare spots in the wiring that might have blown the fuses.

Posted on Jan 21, 2010

  • 94 Answers

SOURCE: my 2003 isuzu ascender won't start, when you crack

or you have a broken ground wire, an for shifting it mite nutaral safty switch.

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Window fuses for 04 Isuzu ascender


power windows. are you saying they are all dead, DO SAY ?
they are in the fuse box, i guess you have yet to look>?
they have names on them.
left CB is CB2, in PDC box, Fuse block rear it say
right CB is CB1, in PDC box, same


25990078-b5pjo3cin0lhc1b54v4xlnuy-4-0.jpg below is the box. under the seat, why not read your operators guide in the glove box it shows how to reach all FB

25990078-b5pjo3cin0lhc1b54v4xlnuy-4-1.jpg

Dec 02, 2015 | Isuzu Cars & Trucks

1 Answer

Where can I find the fuse for my 2005 Isuzu Ascender 7 passenger rear driver window


There isn't one. If any of the windows work, that one should also work. Replace the regulator/motor. They come together. One circuit breaker works all the windows.

May 28, 2015 | 2005 Isuzu Ascender

1 Answer

Where on my 04 Isuzu ascender is the camshaft position sensor


On the I6 engine, it's on the front of the engine on the block near the camshaft. Directly below where you put your oil in.

Mar 10, 2015 | 2004 Isuzu Ascender

1 Answer

Isuzu ascender fuse box


double posted, adds where is fuse box with out where said.??
here, what fuse operates my electric windows.
ok.
the fuses not a fuse its a circuit breaker. (auto resets too)
the fuse is shown below. top left.
did you connect a scan tool to see if there are errors? if not why not?
the DDM controls the motors.
there are 2 of these. one for left and one right.
not stated.

e239c194-3d9a-410c-a5ff-c952e4a5848b.jpg

Jul 09, 2014 | 2004 Isuzu Ascender

1 Answer

I also have been experiencing oddities with my 2006 Isuzu Ascender. The gas gauge will show correct readings then will drop to empty at about the half tank mark and stay there until I fill it back up...


the tank sending unit works off a resistor to read the amount of fuel in the tank. you will need to replace the entire tank sending unit for fix this problem. As for the door problem....The short in the wiring for the door has to be found to repair

Sep 19, 2012 | 2006 Isuzu Ascender

1 Answer

2006 RX330, After having battery problems, I can't open all the windows from the driver's door. All the windows work from their respective door. Any suggertions? Thanks Tom


Each window has a pressure sensor that must be reset each time the battery is disconnected. My wife has an '04 RX330. According to the owner's manual for '04, to reset the pressure sensor for a window, bring the window down half-way, using the control on the same door as the window and then raise it back up, holding the up position on the control for 1 second after the window is all the way up.

On the '04, this brings window control back to driver's side module.

Feb 01, 2011 | 2006 Lexus Es 330

1 Answer

2007 isuzu Ascender keyless entry. I can hear a


sounds like a bad lock mech open door up and check acuator

Jan 22, 2010 | 2007 Isuzu Ascender 7 Passenger

1 Answer

04 isuzu ascender leaking hot water passenger side


if it smells sweet then its the heater core

Jul 12, 2009 | 2003 Toyota Matrix

1 Answer

1997 Isuzu Rodeo, 4.2L All windows stopped working!!!


all windows controlled from the drivers door...if you have someone in the family with BIG fists have them stand beside the drivers door panel and putting the **** against the door, SLAM their fist into the door panel right under the switches. Take a can of WD-40 and spray ALOT directly around the switches in the door using the little red hose WD40 gives you. GM's are known for carbon-tracking their door mechanisms...build up over the years...sometime banging the door knocks the buildup loose allowing the circuit to work.

Jun 14, 2009 | 1997 Isuzu Rodeo

1 Answer

Power windows


This means you need to head to the junk yard and replace the unit that controlls all the windows from the drivers seat. Very simple fix. Good luck

Dec 30, 2008 | 1997 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...