Question about Mercury Cars & Trucks

1 Answer

Where is the windshield wiper linkage up on a 1995 mercury marquis

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 20,706 Answers

Under the wiper shaft.
are you asking how to remove them?
on most cars this is complex. and varies by models and options and even country sold.
but its all here , alldata.com

if you read the manual there will be lots of pit falls here.
things that break easy. just pulling wiper arms can be a small horror.

Posted on Oct 15, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
jetwash
  • 43 Answers

SOURCE: windshield wiper

1) listen if windshield wiper motor is turning when switched on. The motor is under hood up near firewall.
If no noise and fuses are OK, motor may need replacement.

2) If motor can be heard whirring, then maybe the plastic link between the motor shaft and the wiper arm assy has worn or broken. (A very cheap part). This can be accessed by removing cowling or vents in front of windshield. This is a common failure.

Posted on Oct 26, 2008

maygemini
  • 147 Answers

SOURCE: 1999 Honda accord windshield wipers

hey you can unbolt them indiviually and tighten them in any position..but to remove open hood see the plastic cover bottom of windshield remove it ...basic hand tools... but to mess with the motor and the moving arm underneath you may have to pull the dash its hard takes several housrs..

Posted on May 08, 2009

csmock132
  • 4669 Answers

SOURCE: How do I adjust the linkage on my 1995 Mercury

The bolts loosen up on the bracket that holds the shifter shaft to the cable. Look up from the floor board and look above the steering column in the shift cable area. Wiggle the shifter and you should see the problem. Tighten the bolts with a torx bit.

Posted on Jun 14, 2010

Testimonial: "fixed problem in 10 min."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove windshield wiper motor off of 1999 mercury marqui


Wiper motors on this car are a very rare failure, so have you jumped 12 volts to the wiper motor and does it work or not, do that before you tear into it. The switch is the more common issue. Also the wiper motor can be tested with a Ford special scan tool called and "NGS", it runs the wiper motor through it's cycles by controlling the BCM..

Mar 24, 2017 | 1999 Mercury Grand Marquis

1 Answer

When i turn my wipers on one will clean the windshield and the other will not move, what do i need to do?


Someone will probably need to remove the wiper arms and the panel between the hood and the windshield to access the linkage coming from the wiper motor.

Feb 08, 2013 | 1996 Mercury Grand Marquis

1 Answer

1996 Mercury Grand Marquis wipers don't work. I changed the motor and the fuse isn't blown


You need to take the plastic cowls off that cover the wiper arm linkage and wiper transmission to inspect it...cowl is held on with 3 Phillips screws near windshield and some one inch wide metal clips, take off the gasket that fits on top. If both are not working check the transmission where linkages attach, if one wiper blade is not working it is usually the drivers side where the nylon bushing that forns a ball/socket sort of connection fails due to build up of debris and the rusting of parts that follows, let me know if this helps.

Dec 17, 2012 | 1993 Mercury Grand Marquis

1 Answer

2000 grand marquis driver's side windshield wiper lifts off windshield


Hello Steve,

From your post, "Finally had enough and stuffed a small block of wood between the driver's side bottom of the molded plastic linkage frame enough to lift the whole thing enough to put a moderate amount of pressure behind the wiper blade..", it sounds like this box is warped or somehow out of alignment. Is it possible for you to buy this box from a wrecking yard? Has you car ever been in a collision? If so the frame may have so un-repaired buckling resulting in the misalignment.

Mar 10, 2017 | 2000 Mercury Grand Marquis

1 Answer

Heater core is leaking on the floor


I had the same problem with my 2001 Mercury Marquis, but it wasn't the heater core, it was the compartment for the condensate drain for the air conditioning and the compartment to catch the rain water that comes down the windshield and drains through the windshield wiper cowling. You have to take off windshield wiper on passenger side and cowling underneath the wiper of the passenger side and you will see a screen over in the corner and that's where the box is for the drain. so much trash was down in there that the flapper wouldn't open to let the water out. Ours only leaked when it rained, but it looked like it could have been the heater core. Good luck.

Nov 15, 2012 | 2001 Mercury Grand Marquis

1 Answer

1997 mercury grand marquis wipers


We have the same problem on our 97 Grand Marquis. We have replaced the wiper blades and the drivers wiper arm with a used one. The problem was not completely solved but it did work better. We are going to replace the arm with a new one and see if that works better.

Oct 25, 2011 | 1997 Mercury Grand Marquis

1 Answer

Where is windshield wiper motor for 1992 mercury grand marquis


1992-98 Vehicles
  1. Disconnect the negative battery cable.
  2. Remove the rear hood seal. Remove the wiper arm assemblies by raising the wiper blade off the windshield. Move the slide latch away from the pivot shaft and slowly lower the arm onto the latch. This unlocks the arm from the pivot shaft and holds the blade off the glass. Pull the arm from the pivot shaft.
  3. Remove the cowl vent screws and disconnect the washer hoses from the washer jets.
  4. Detach the electrical connectors from the wiper motor.
  5. Remove the wiper assembly attaching screws, lift the assembly out and disconnect the washer hose.
  6. Unsnap and remove the linkage cover.
  7. Remove the wiper module assembly retaining bolts and remove the module from the vehicle.
  8. Remove the linkage retaining clip from the motor operating arm by lifting the locking tab and pulling the clip away from the pin.
  9. Remove the motor retaining screws and remove the motor from the vehicle.
  10. The installation is the reverse of the removal.

ad37f8d.jpg

Fig.: Lift up to release the clips and remove the hood-to-cowl weather strip


ca6ea0f.jpg

Fig.: Remove the cowl panel-to-firewall retaining clips



Remove the driver's side then the passenger side cowl panel from the vehicle


d57f264.jpg



Fig.: Detach the electrical connector for the wiper motor

Release the wiper motor retaining clips and remove the cover from the vehicle


ffed3a6.jpg



Fig.: Remove the wiper module assembly retaining bolts and remove the module from the vehicle


412221d.jpg



Fig.: Remove the wiper motor retaining bolts and ...


46edc09.jpg


Fig.: ...remove the wiper motor from the vehicle




Hope helps (remember comment and rated this).

Aug 02, 2010 | 1992 Mercury Grand Marquis

1 Answer

1996 Mercury Grand Marquis - wipers will not work. Have check multifunctional switch and motor. Both ok.


if motor and switch are ok and the motor is running, then it's the ball joints on the arms that have become disconnected underneath the windshield in the firewall vicinity. Also, the wiper arms could be stripped out.

Jul 03, 2010 | 1996 Mercury Grand Marquis

1 Answer

Auto maintanence


Yes the spring in the arm is weak, replace the arm and your problem will be solved.

Oct 06, 2008 | 2000 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...