Question about Cars & Trucks

1 Answer

I have a Hyundai Getz 1.1 2008 model, the car doesnt start the engine turns on but it does not spark I have replaced the cam sensor, plug cables and plugs

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 13 Answers

Even if you don't have health insurance, it is not compulsory to purchase health insurance from new marketplaces. If you are uninsured, you might have to pay a fine after January 1, but for some people, that fine is going to be much lesser than what they might have to pay for health insurance plans.

http://www.hcentive.com/private-health-insurance-exchange.html

Posted on Oct 15, 2013

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

preciousluv
  • 3 Answers

SOURCE: 2000 Hyundai Accent will suddenly stall and wont restart

Have someone check the idle sensor. I had to have mine replaced along with another that I don't remember which one is was.

Posted on Jan 08, 2009

  • 293 Answers

SOURCE: Car will not start.Engine turns over but spark plugs willnot fire

I would say replace ignition coil, that might me the problem, otherwise it can be the ecu, which might have some electrical problems not allowing the car to stay running. Good luck.

Posted on Dec 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The engine is slow to response at low rpm. above 2k rpm the engine response return to normal. spark plug, plug wire and ignition coils had been replaced, but the problem still persist.


Have you run a fault code test on this? Is the fuel pressure within specs under a load? Have you tried cleaning the MAF sensor heated wire?

Jul 21, 2016 | 2005 Hyundai Getz 1.6

1 Answer

How do I arrange my spark plug wires on my Hyundai Getz go 2002


How to change spark plugs hyundai accent 01 - 05 - YouTube

? 3:18
https://www.youtube.com/watch?v=tU2vwisJ7v4
Feb 16, 2012 - Uploaded by PNBNC
I filmed this right after changing my old plugs, I figured it was easy enough to film and some people can profit from it. for a ... Coil, you mean wire lol ... When you go to put the spark plug back in, never start it with the ratchet.

How To Replace Change Install Spark Plugs 2001-06 ...

? 3:17
https://www.youtube.com/watch?v=yVV2KcPDFIo
May 14, 2013 - Uploaded by 1A Auto Parts
... spark plugs. This video is applicable to the 2001, 2002, 2... ...spark plugs. This video is applicable to the 2001, 2002, 2003, 2004, 2005, 2006 Hyundai Elantra 2.0L. ... +queentonks A little know-how can go a long way. We're glad ... When do you think is good to replace my spark plugs wires? My spark ...
2001 Hyundai Accent Firing Order: Engine Mechanical ...www.2carpros.com/.../hyundai-accent-2001-hyundai-accent-firing-orderApr 23, 2009 - Engine Mechanical problem 2001 Hyundai Accent 4 cyl Two Wheel Drive Manual 95000 ... Now I'm trying to figure out how they go back on. How do I find out the Engine Firing Order for my car - Hyundai Accent 2001 1.5L?Which is cylinder 1 - 1.6 Accent - Hyundai Forum: Hyundai ...www.hyundaiperformance.com/.../16837-cylinder-1-1-6-accent.htmlJan 13, 2003 - 3 posts - ‎3 authorsFrom what I read though, the coil pack is configured as 1 4 2 3. I'm assuming the first wire on the coil pack goes to cylinder 1. Can anyone ...

Dec 16, 2015 | Hyundai Cars & Trucks

1 Answer

HYUNDAI GETZ 1.3 2005 A/C NO SPARK NO FUEL


Some info about the car can be found
The Korean Car Guide Hyundai Getz Part II Engine


The failure to start could be due to the Crank Timing Sensor. The sensor not working will stop the computer from knowing when the spark should be activated and the injection of the fuel should take place.
I hope this is the problem. and that you can find
This is only my opinion and It seems to fit the problem posted

Jan 13, 2014 | Cars & Trucks

1 Answer

Hyundai getz starting problem


If the battery is exhausted, four years is a good age, then yes, the engine will have difficulty turning against compression.

Jun 16, 2017 | 2007 Hyundai Getz 1.6

1 Answer

Engine won't start


you need to replace the crank position sensor .

Oct 27, 2012 | 2005 Hyundai Getz 1.3

1 Answer

On My 2005 Hyundai elantra 2.0 if I plug my cam sensor in it will turn over but won't start. If I unplug cam sensor it will start but car has a slow start on take off need help?


remove cam sensor clean it put it back in try the car if it still not right replace the sensor you may need to replace crank sensor as well when did it last have a timing belt replaced ?if its got over100 ,000 km on it and hasnt been done i would have it done if the belt brakes it can be fatal for the engine if its old then it may have jumped a tooth wich will put the cam timing out i would look there first turn the engine over by hand till the timing mark on the crank pulley is showing tdc remove the top half of the timing belt cover remove no1 spark plug use a suitable probe to check that no1 piston is at the top if so check the marks on the cam gears are in line with there marks if all marks line up the valve timing is ok

Apr 06, 2011 | 2005 Hyundai Elantra

2 Answers

My hyundi getz 2002 model turns over but dose not start


DOES THE YELLOW KEY LIGHT APPEAR WHEN TURNING THE IGNITION ON IF NOT THEN DISCONNECT THE BATTERY FOR AN HOUR THEN RE-CONNECT AND TRY AGAIN. THIS PROCEDURE SHOULD RESET THE ECU IF NOT THE KEY NEED TO BE RE-CODED. TRANSPONDER MIGHT BE AT FAULT.

Jul 14, 2009 | Hyundai Motor 2004 Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...