Question about Cadillac DeVille

Open Question

How do I replace the heater core on a 1994 cadilac sedan deville?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 77194 Answers

SOURCE: 63 cadillac sedan deville heater core removal and installation instructions

I do think you have to pull he dash, for that you will need a manusl, try ebay for used factory manuals, I have had good luck getting them there for all my cars.

Posted on Oct 17, 2008

Ad
Shouldibuyit
  • 44 Answers

SOURCE: replace heater core 1994 chevy g20 conversion van

Here a are the instuctions to remove it. I did not know if you have A/C or not so I included both for you.

REMOVAL & INSTALLATION
Without Air Conditioning
ALL MODELS
See Figure 1

  1. Disconnect the negative battery cable.
  2. Remove the coolant recovery bottle.
  3. Place a pan under the van and disconnect the heater intake and outlet hoses. Quickly remove and plug the hoses and support them in an upright position. Drain the coolant from the heater core into the pan.
CAUTION When draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on the ground. This will prove fatal in sufficient quantity. Always drain coolant into a sealable container. Coolant should be reused unless it is contaminated or is several years old.
  1. Remove the heater distributor duct-to-case attaching screws and the duct-to-engine cover screw. Remove the duct.
  2. Remove the engine cover.
  3. Remove all the instrument panel attaching screws.
  4. Carefully lower the steering column. Raise and support the right side of the instrument panel. Refer to for further details.
  5. Remove the defroster duct-to-case attaching screws and the two screws attaching the distributor to the heater case.
  6. Disconnect the temperature door cable. Carefully fold the cable back and out of the way.
  7. Remove the three nuts from the engine compartment side of the distributor case and the screw from the passenger compartment side.
  8. Remove the heater case and core assembly.
  9. Remove the core retaining straps and remove the core.
To install:
  1. Install the core.
  2. Install the core retaining straps.
  3. Install the heater case and core assembly.
  4. Fasten the three nuts on the engine compartment side of the distributor case and the screw on the passenger compartment side.
  5. Connect the temperature door cable.
  6. Install the defroster duct-to-case attaching screws and the two screws attaching the distributor to the heater case.
  7. Install the steering column.
  8. Fasten all the instrument panel attaching screws.
  9. Install the engine cover.
  10. Install the duct. Install the heater distributor duct-to-case attaching screws and the duct-to-engine cover screw.
  11. Connect the heater intake and outlet hoses.
  12. Fill the cooling system.
  13. Install the coolant recovery bottle.
  14. Connect the negative battery cable.
1990-95 MODELS With A/C

  1. Disconnect the battery ground cable.
  2. Remove the engine cover.
  3. Remove the steering column-to-instrument panel bolts. Lower the column carefully.
  4. Remove the upper and lower instrument panel attaching screws. Remove the radio support bracket screw.
  5. Raise and support the right side of the instrument panel.
  6. Remove the lower right instrument panel bracket.
  7. Remove the vacuum actuator from the kick panel.
  8. Disconnect the temperature cable and vacuum hoses at the case. Remove the heater distributor duct from over the engine hump.
  9. Remove the two defroster duct-to-firewall attaching screws below the windshield.
  10. Under the hood, disconnect and plug the heater hoses at the firewall.
  11. Remove the three nuts and one screw (inside) holding the heater case to the firewall.
  12. Remove the case from the van. Remove the gasket for access to the screws holding the case together. Remove the temperature cable support bracket. Remove the screws and separate the case. Remove the heater core.
To install:
  1. Install the heater core.
  2. Assemble the case and fasten the screws.
  3. Install the temperature cable support bracket.
  4. Position the gasket, then install the case in the van.
  5. Fasten the three nuts and one screw (inside) holding the heater case to the firewall.
  6. Connect and plug the heater hoses at the firewall.
  7. Fasten the two defroster duct-to-firewall attaching screws below the windshield.
  8. Install the heater distributor duct.
  9. Connect the temperature cable and vacuum hoses at the case.
  10. Install the vacuum actuator at the kick panel.
  11. Install the lower right instrument panel bracket.
  12. Fasten the radio support bracket screw.
  13. Fasten the upper and lower instrument panel attaching screws.
  14. Fasten the steering column-to-instrument panel bolts.
  15. Install the engine cover.
  16. Connect the battery ground cable.
  17. Refill the cooling system as necessary.

Posted on Nov 28, 2008

  • 7 Answers

SOURCE: heater core

bad news for you because you may have to take the dash apart on the pass side to pull heater core a shop wasnts about $600 in labor but it can be done i did on my 1993 good luck

Posted on Jan 27, 2009

  • 5 Answers

SOURCE: Water Pump

If you have the NorthStar 4.6L engine this is going to be the easiest water pump you ever done and even if you have not. Auto Zone will be able to help they have a special tool for removing and replacing it. I would suggest replacing the hoses when you do this also. When you get the pump you will also need a O ring for the pump cover, and a new thermostat. get the proper antifreeze also.
Auto Zone should also have some instructions with pic's to help you.. email me if you have any questions.......

Mac.......

Posted on Mar 10, 2009

michigan man
  • 3533 Answers

SOURCE: need instructions to replace 1994 Rodeo heater core

try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Posted on Mar 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to install heater core for a 1995 Cadilac Deville 4.9L


you must remove the clamps from the heater core from the engine compartment and the covers from under the dash to be able to remove the heater core

Feb 24, 2015 | 1995 Cadillac DeVille

3 Answers

My cadillac is not giving me any hot air ,ive replaced the radiator, changed the thermostat, has a new water pump, where do istart to look.


Feel the 2 tubes at the firewall for the heater core. If they are not getting hot, the heater core needs to be flushed out or replaced. I had this problem with a 1990 Cadilac Deville, it was just a plugged up heater core.

Remember to install sealant after flushing out the system to prevent leaks.

Jan 25, 2011 | 1992 Cadillac DeVille

1 Answer

I have a cadilac sedan deville 1994 and every time i turn it on it says that i have to wait 3 minutes due to theft system starting disable why is that?


It is having a hard time reading your chip in your key. I have the same problem on my 99. You can get them replaced but there not cheap.

Nov 20, 2010 | 1994 Cadillac DeVille

1 Answer

Can you tell me where to find my heatercore hoses on my 1994 cadillac sedan deville?


The heater-core hoses are usually paired together behind the engine, and they go through the firewall. Two rubber covers usually hold them tightly to the firewall. They are not that dificult to identify.
If your heater still works, they get quite hot, and you could feel them to further identify.

Dec 21, 2009 | 1994 Cadillac DeVille

1 Answer

1994 cadilac fans not coming on, checked fans they work, it is


the problem could be the engine coolant tempature sensor. all1992 through 1994 models equipped with electronic climate control can display trouble codes.replace coolant temp sensor.if problem contines have powertrain control module checked

May 15, 2009 | 1994 Cadillac DeVille

2 Answers

Who can tell me the code on a 1994 cadilac po58


P0058 HO2S Heater Control Circuit High (Bank 2 Sensor 2)
Has something to do with your relay. I have searched through all my manuals and cannot find anything else about it. But you will need to replace a O2 sensor

Feb 10, 2009 | 1994 Cadillac DeVille

1 Answer

63 cadillac sedan deville heater core removal and installation instructions


I do think you have to pull he dash, for that you will need a manusl, try ebay for used factory manuals, I have had good luck getting them there for all my cars.

Oct 17, 2008 | Cadillac DeVille Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...