Question about Ford Escape
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
i would have to say to check for a relay in your fuse boxes for power steering pressre switch or it may have its own police pkgs have a lot of relays due to all the extras
Posted on Sep 11, 2008
Take a picture of it before you take it apart so you know where everything goes.
1.Take belt off
2. Unbolt any bracket that the power steering pump is bolted too.( only if you have to unbolt a bracket)
3. Disconnect lines from steering pump
4. After replacing power steering pump fill with Auto. trans fluid.
5. After filling start car and turn wheel left and right a few times this will get the air out of the system and recheck fluid level.
Posted on Apr 22, 2009
you have to remove the whole headlight assembly, then pop off the front cover pull the old bulb out and put the new one in. reverse the process to re-install. there is a small plastic tab on the topfront of the headlight assembly, that is what you need to release to get the clear cover off and get inside.
Posted on Oct 07, 2009
Sounds like you need a new power steering hose. To verify this, I would dry up any wet areas on the hose and pump with a towel, get a flashlight and start the vehicle and try to determine the exact site of the leak which is usually at the ends of the hoses. Good luck!
Posted on Mar 11, 2010
Engine over heating can be caused by a number of things. When you say the water pump and radiator appear to be ok I am also guessing that you checked the coolant level to make sure it is normal.
If the level is low then you obviously have a leak. Insufficient coolant circulating will not cool the motor properly because it won't be able to draw enough heat out. If the level is normal then you need to check the thermostat to make sure it is opening properly. To do this, run the motor to temperature and check the top and bottom hoses. They should both be hot and firrm once the thermostat opens meaning the circulation loop is operating properly. If the top is hot and firm and the bottom is cold/soft or collapsed then the thermostat isn't opening.
If the thermostat is operating properly then you ned to look for some other obstruction or cause for coolant loss. Check the head/intake gaskets, hose connections, hoses, over flow tank, radiator fins, radiator side tanks etc..
Posted on Jun 10, 2010
Testimonial: "Thank you for your quick response. I will get the head/intake gasket checked."
Tips for a great answer:
Apr 03, 2015 | 2003 Ford Escape
Jun 04, 2017 | 2003 Ford Windstar
Feb 15, 2013 | 2003 Ford Escape
Jan 09, 2011 | 2003 Ford Escape
Nov 19, 2010 | 2003 Ford Escape
Sep 15, 2010 | 2003 Ford Escape
Mar 11, 2010 | 2003 Ford Escape
Dec 01, 2009 | 2003 Ford Escape
Jul 13, 2009 | 2003 Ford Escape
Nov 20, 2017 | Ford Escape Cars & Trucks
14 people viewed this question
Usually answered in minutes!