Question about 2002 Land Rover Freelander

Open Question

Cooling system airlock bleed bleeding - 2002 Land Rover Freelander

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: HOW TO BLEED FUEL LINE ON LANDROVER

on most Discovery's the fuel rail will have a schrader type valve (usually on the right side of rail -US pass side). let the car sit a while before you do this and have some rags to collect any fuel that shoots out. (wear protective eyewear, and dont stand directly in line wiht this as it can shoot a distance). press the valve (like a tire valve) slowly, and fuel will squirt out until the pressure is equalized. in some cases, wiht weaker pressure regulators, you may not get much out at all. thx

Posted on Jun 10, 2010

Ad
  • 129 Answers

SOURCE: where is the cooling system bleed valve

cooling system bleed is the large plastic screw right on top of the coolant resevoir.

Posted on Dec 10, 2012

  • 1966 Answers

SOURCE: Having trouble bleeding cooling system on 2006 Range Rover. No heat and fan is blowing

The easy way need to be done:
-Make sure the is not presure in the cooling system before do thisor release carefully.
-Disconnect the upper hose from the radiator and fill water (coolant)
through the hose to the engine. If water can't get in beacuse the thermostat is closed. Simply remove it and fill untill full.

Mai Lor

Posted on Feb 22, 2013

  • 35614 Answers

SOURCE: Airlock / Bleed

Maybe you installed it backwards

Posted on Jun 09, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i bleed coolant system on mg zr 2003


after filling cooling system there is a bleed screw on the coolant pipe that runs round the end of the cylinder head.rh has you look under bonnet 8mm head,loosen that or remove it may be blocked! the heater can give problems if you have completely drained the system or have had a major leak it may be airlocked! make sure the heater is set to hot, run engine until coolant flows from bleed screw, close bleed screw, remove coolant cap carefully,and top up.leave to stand for 20 mins or so. re top up run engine @2500 revs if the heater is cold and you have no bleed screw on the heater hose. there is a valve that fails in the heater hose bypassing the heater matrix.that may need replacing if the heater is cold, hope this helps.

Mar 08, 2015 | MG Cars & Trucks

2 Answers

Dan how do I bleed 2004 Kia coolant car temp is good but sometime at idle heater starts to blow cool hit throttle gets great heat


I agree with your logic. Attached vid addresses bleeding. Sounds like at low rpms, not enough flow to transfer the heat. So bubble or maybe a partially obstructed core. There are a couple of vids on clearing a core... GOod luck, let us know if you figure it out.

Jan 11, 2015 | 2004 Kia Sorento

2 Answers

Air lock in cooling system


Did you drain the system and your refilling? There may be a small bleed valve on a high spot of the cooling system, try looking for it and bleed any air through it. Good luck!

Jun 25, 2014 | Skoda Octavia Cars & Trucks

1 Answer

1992 325i has airlock. How do I use the bleed screw to get the air out?


Just open it up with the engine running. Then watch until coolant starts to come out and then top off the system after it cools down, make sure the coolant bottle is full on shut down..

Aug 23, 2012 | BMW 325i Cars & Trucks

1 Answer

My heater is blowing cold air already changed thermostat


check the cooling system to see if you have airlock, it may need bleeding after you changed thermo

Feb 04, 2011 | 2001 Chevrolet Malibu

1 Answer

Cooling system airlocked


Airlocked? Often by pulling a line of an air buble will be relased. moving hoses so they can fill with water and the air can pass works too. You did not mention the engine you have. Mine is the 2.3, when I drained, flushed and refilled the system had no major problems. there is a air bleed line from the water outlet (under ps pump, left side of engine) to the plastic bottle, right front. the restriction is in the niple at the pastic bottle is it pluged preventing the air to bleed? I always drill a 1/16 hole in the flange of a new thermostat when replacing it, that helps the air to escape and the system to better fill. The thermostat is on the return to the engine, water pump inlet, under the exhaust manifold (not a great design)

Nov 13, 2010 | 1995 Pontiac Grand Am

3 Answers

Daewoo Leganza.Airlock in cooling system, heater blower works but


remove thermostat and drill a small hole in it to allow the air to come up to header tank

Jan 30, 2010 | 2000 Daewoo Leganza

1 Answer

Howto fix airlock in radiator


The generic method of bleeding air from the cooling system is to use a floor jack and raise the front of the car as high as poss, then fill the coolant recovery tank full and run the engine until it just starts to overheat, high end of normal zone on gauge, then shut the engine down and run cold water over the radiator core, this will self bleed the system and the coolant will be pulled from the recovery tank, repeat as necessary, never let the recovery tank run dry or more air will be pulled into the cooling system l , if it still overheats then you need to have the head gaskets checked with a gas analyzer for hydrocarbons present in the radiator or recovery tank

Nov 10, 2009 | 2003 GMC Envoy

1 Answer

HI my 51plate golf seems like it has an airlock in the cooling system heaters blow cold replaced thermostat has new radiator and i seem to be getting alot of pressure building up in the bottom hose and the...


dont get many faults with heater matrix in 51 plate golfs,but its a very common fault you have........the water pump impellor breaks up and dont move the water round the system,and the system is self bleeding..

Jan 18, 2009 | 2001 Volkswagen Golf

Not finding what you are looking for?
2002 Land Rover Freelander Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76649 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...