Question about Infiniti Cars & Trucks

1 Answer

My driver door all of a sudden only opens when i put the key in and lock it then unlock it, door hinges are fine and tight, fuses under dash are fine, im not sure which fuse or relay i should check under the hood,

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Infiniti Master
  • 3,187 Answers

It would be the door lock pin. you know the one you can push down when you in the car to lock the doors. drivers door are prone to do this, you will need to take the door panel off and get to the lock and were the linc is for the locking inside there is a rotating ring you will need to clean this.. wd40 or something like it not grease. pull up and down the pin arm wile doing this. should work fine after this.

Posted on Oct 15, 2013

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 105 Answers

SOURCE: Driver side door won't lock electronically

very common problem is the door lock actuator. i would recommend replace that. a good idea also would be to remove the door panel and check all the rods that connect to the assembly and make sure one didnt pop off.

Posted on Oct 27, 2009

Testimonial: "I figured it out before i got the answer, but you were right, it was the actuator for sure, i replaced it and it worked just fine. thank you!"

  • 31 Answers

SOURCE: Tying to locate the fuse (fuses) for power

Hi
sounds to me like the electrical cable inside the drivers door has come unplugged or broken where door swings( youll see a black ribbed rubber piece that shields the cable check for damage) youll need to remove the door panel for visual. The fuse should be listed on the fuse cover (interior). If the passenger side is functional it is more likely that the cable is unplugged or damaged as the passenger and drivers side would be on same circuit.
I hope this helps you

Posted on Dec 30, 2009

  • 47 Answers

SOURCE: which fuse in fuse relay center controls automatic door locks?

Check fuse #14, in the fuse panel on the inside drivers side.

Posted on Jan 10, 2010

  • 1455 Answers

SOURCE: The power door locks for my 1996 Odyssey just

Sure sounds like your problem is the power door lock control unit. Best thing to do is get a replacement unit(new or used) and install it, unless you can open and fix the defective unit yourself.

Posted on Jan 10, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota Echo dash lights won't come on.


Nope, theres nothing under the car wires run along the inside of the doors under the carpet, about your door locks, the drivers controls the lock/unlock make sure you have so the passengers can unlock, also check your child lock lever on the rear doors , make sure those are move in the right position, if you got the child safety on sometime the driver piwer swutch wont open it, make sure your courtesy light is not all the way off, the Dimmer, it controls the instrument panel lights, FUSE FOR THE COURTESY, i belive is conected to the door lights, halo on your key or light, glove box light, and your dome light's. Hope this helps, CHECK FUSES WITH METER OR TEST LIGHT.

Dec 17, 2016 | Toyota Cars & Trucks

1 Answer

How to disable 98 civic alarm keeps drain battery


Might have broken wiring harness wires that run from the cabin to the door. There is a rubber boot that covers this harness, runs near the door hinges, remove boot and check all wires and if you find any damaged or broken, repair and test auto door lock.

Jun 19, 2017 | 1998 Honda Civic

1 Answer

1999 hyundai alarm fuse location


Hello! There is a fuse that supplies power to the Drivers door Lock/unlock Relay...I do not know from your question if the door locks and unlocks properly...That is 20 A fusible link C in the under hood box...Blue in color...
Also there is the ignition key interlock solenoid switch fuse #4 (15 A) in dash fuse box...If all fuses are good and the doors lock/unlock properly I would suspect a defective ignition switch; Yellow/black wire that supplies (12 volts hot at all times to the alarm system) splice has gone open...guru...saailer

Feb 07, 2012 | 1999 Hyundai Accent

2 Answers

Power door locks do not work


If they all stopped working at the same time I would take a look at the fuses to make sure its not bad,This fuse is located in the fuse box at the end of the dash on the drivers side or under the dash on the drivers side.The location of the fuse is written inside the cover or in your owners manual.

Feb 12, 2011 | 2002 Ford Taurus

1 Answer

Power door locks do not work. Will not lock or unlock from key or switch from inside the car. If you push the button to lock from key horn still sounds but doesnt lock. You can open and close both side...


Check your fuses. Because the locks are powered they have a fuse. Most likely the fuse box is located on the driver side under the steering wheel/ dash.

Oct 04, 2010 | 2005 Dodge Grand Caravan

1 Answer

I can't unlock my 2003 kia rio with the key, and when I unlock it from the inside it relocks itself before I can open the door


Hello,
Just had the same problem and know it is fixed.
You may have worked out that you can use the fob to unlock and then immediately lift the passenger handle to get access- not ideal.
In my case I couldn't turn the key in the drivers door either
1, Remove the 25 AMP fuse for door locking from fuse box under the bonnet. This disables central locking. The passenger door opens fine. The key however won't turn in drivers door.
2, Spray WD40 or other moisture repellent protective lubricant on key. Insert into drivers lock- gently turn back and forth. Half remove key so you can spray more WD40 into lock- a good blast will do. Keep gently turning until you can lock and unlock.
3, Replace 25 amp fuse
4, Hopefully job done- worked for me

Jan 12, 2010 | 2003 Kia Rio

2 Answers

I CAN NOT OPEN THE DRIVER DOOR PASAGER DOOR AND REAR DOOR BY KEY


If I understand you correctly your saying that the only door on your van that you can unlock with a key or remote is the sliding side door and that all the other doors will not unlock with the key or the remote? If this is the case then the two front doors most likely have a problem with the fuse to the actuators so you should check the fuse in the fuse box which may be located either under the drivers dash or in the engine compartment on the drivers side over the wheel well.

Aug 21, 2009 | 1996 Mercury Villager

2 Answers

Door locks wont work


check if the batteries in key remote are good.
if good
nedd to reset your key by putting in the ignition just turn the dash lights on ...dont start the car and once the ignition lights shows on the dash board just press unlock and lock once ot twice until it locks and unlocks while u in the car. try that it had worked for me before should do for urs.

May 12, 2009 | BMW X5 Series Cars & Trucks

1 Answer

Power locks not working right


Hey, this might work.....get in truck, close doors, put key in ignition in lock position.....hold down the door lock button on driver side door control and wait for the lock control to be displayed on the information screen(odometer read-out).....it should say like lock 1, lock 2, lock 3, lock 4.....or something, I always reset mine to LOCK 1, to do this hold the odometer reset button on dash for a sec or two til it changes settings, then release, repeat till you get to LOCK 1, then quickly press and release odometer reset button to exit program, this is the function to lock doors over 15 mph and when out of park and to unlock doors when returned to park......yours' might be set to another function number....try it out, let me know if this helps.........good luck!

Nov 10, 2008 | 2004 Chevrolet Colorado

1 Answer

Keyless entry keylob want lock or unlock doors or trunk.change battery and checked all fuses.


You need to program the remote. Get in to the car and LOCK all doors with the switch on drivers side door. Take the key and insert it into the ignition cylinder in and out 6-10 times, until the flashers/hazards flash on your dash board. Or just keep putting the key in and out (nice and easy now, not fast) until you see the lights on dash flash. After the lights flash, turn the key into ACC mode to make the whole dash light up.(do not start car) .With the key in ACC position, hit any button on remote, that will make the hazards flash again. Turn key off and unlock door with switch again. Open door.DONE.
Good luck.

Jul 15, 2008 | 2001 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14338 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...