Question about Ford Transit Connect

1 Answer

The airbag light came on. on my 57reg transit how do i get it off

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,113 Answers

Usually it requires the control circuit board replaced at $125 or more used (i rebuild my own for $5 or so since the working components are a wire wound resistor and a thermal cutout) By the way... working on airbag system could be dangerous... if not now... later. Think lawsuits if it is found to have been repaired and is not factory authorized etc.

Posted on Oct 15, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2015 ford transit 350 airbag light stays on after replacing radio


Get the airbag trouble code read and then you'll know what's going on. Without that you've got no starting point.

Sep 29, 2017 | Ford Cars & Trucks

1 Answer

How do I remove the drivers airbag


pull very hard and if dusen"t work cut with a knife slowly and then pull again

Feb 25, 2016 | 2012 Ford Transit Connect Cargo Van XL...

1 Answer

My Renault megane coupe 57reg has been off the road for a couple of months just getting it back on the road needed a new battery and now nothing works. The head lights won't turn off, the boot won't open,...


WOW , i'd go straight to a mechanic unless some else knows what this is ,i can only think of corrosion getting into the engine compartment fuse box so i' say take this out and carefully check each fuse /relay plug in slot /connectors for signs of corrosion and clean off , don't forget to dissconnect the battery first

Jun 29, 2014 | Cars & Trucks

1 Answer

2012 3500hd noise coming from front end. thought it was a wheel bearing, dealer replaced, still there. any ideas?


It is not supposed to be some horrible event. We are now in the process of this transition from one World Age to the next.----------------------------------------------------------------------------------------------
bmw airbag reset tool

Jan 07, 2013 | Cars & Trucks

1 Answer

Steering wheel removal


Disarm the Steering wheel SRS Airbag module by disconnecting the battery negative for 5 minutes, the remove the module bolts at rate of steering wheel with thin walled deep 8mm 1/4" drive socket. Next pull the airbag off the wheel and careful unlatch the connector lock and set the Airbag aside, then remove the lock ring and then the steering wheel nut on the steering sector shaft threaded end, you will now need a steering wheel puller to remove the pressed on wheel from the shaft. You can buy a puller from most parts stores for about $10.00

Jul 03, 2012 | 2011 Ford Transit Connect

1 Answer

Print Email Problem with Toyota Cars & Trucks How to off airbag light Say on my airbag how to off What's your problem?


The light for the Airbag/SRS system is on because the system control module has sensed a fault and turned off the airbag SRS system. What you must do now is have a scan done of the airbag module to see what fault codes show up in the airbag modules memory.

Jun 28, 2012 | Toyota Cars & Trucks

1 Answer

Transit connect 07 airbag modulater reset


there is no simple reset for the restraint module. if the system proves out ok when the car is started, then the light will go off. if there is a problem detected, then the light may flash or stay on steady. the vehicle needs to be hooked up to a ford diagnostic computer

Feb 18, 2012 | 2010 Ford Transit Connect

2 Answers

My airbag light blinks 7 times when i startmy car


{: ) If the airbag light goes off after that 7 blinks (some are 6 or 8), that will be normal. The airbag module will blink the airbag warning light on the cluster while performing self-test during initial start-ups. After the self-test and the airbag module did not detect any fault within the airbag system, it will turn the warning light off. If the airbag warning light continuously blink or stayed lit after the expected elapse time, then there is really a concern and you need to double check the airbag system with a scan tool.

Aug 31, 2011 | Chevrolet Blazer Cars & Trucks

1 Answer

S class 320cdi explain warning light pass airbag off


as the driver is supposed to be responsible for the safety of the passengers in transit,mercedes (are the only maker),decided that it would be better this way round.its not an airbag light,its a seatbelt warning light.(person sitting down with a ********)

Apr 02, 2010 | Mercedes-Benz S-Class Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...