Question about 1994 Dodge Intrepid

1 Answer

Has a miss , we aleady put plugs wires gas filter

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 4,514 Answers

A miss can mean injector problems too--car is old and worn--dont replace mor parts til u du a scan or data stream to pinpoint issue----ign coil and module shud be suspect also

Posted on Oct 14, 2013

2 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 707 Answers

SOURCE: 1998 dodge avenger missing, replaced plugs, wires,

Clean or replace the EGR valve..........Hope this helps.

Posted on Aug 21, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What is causing miss?

runs like it's missing
Have scanned for trouble codes, could be dirt in a fuel injector or a weak/bad coil.

Mar 31, 2016 | 1999 Chevrolet Cavalier

1 Answer

When u start to go if u give it gas it will bogg out and won't go but if u barely push the gas pedal it will go but has no power

i would say mabey the injectors but you said it runs good in the morning.....and you said filter, did you mean air filter or fuel filter

Feb 09, 2013 | Cars & Trucks

1 Answer

Whats causing my truch to vigoriously shake when idoling and between 50 to 60?

A misfire should have Coded on the check engine light. You have 2 systems for each cylinder. Gas and spark. A dirty injector can cause a miss. A bad plug, wire, or coil on plug (if this truck has the newer system) can cause a miss.

You can try a new injector for the one cylinder and see if that helps. Really depends on which engine you have for difficulty in getting to the plugs. The 5.4 series had deep boring for plugs and there are books about this problem. I believe the coil on plug type coil has a resistence of 10,000 Ohms from the top terminal to the base of this coil. It may need to be benchchecked.

As your service light did not work, perhaps you should find out if its lightbulb is missing. I hope my solution is helpful.

Mar 28, 2012 | Cars & Trucks

1 Answer

My 1990 F-150 4.9 6cld has 191000 miles, new fuel pump, new plugs, new coil, drained and cleanded gas tank. When in idle below 1000 rpm doesnt miss any. try incresse rpm acts and sounds like all 6 cyl r...

check the connection of all of the spark plug wires to the plugs, you may have put a wrong one on, when cleaning the gas tank as well it can dislodge a lot of dirt, cleaning injectors and a new fuel filter could solve the issue as well

Mar 01, 2011 | 1990 Ford F150

1 Answer

I have an 1989 4.3 it wont start unless i press the gas pedal down. then once it is started it idles fine but as soon as you put it into gear and try to give it throttle it dies, but if i am lucky enough...

Change the gas filter if you havn't already done so. It sounds like fuel restriction to me or perhaps a faulty fuel pump or cheap gas has blocked the gas filter. Hope this helps! Good luck!

Aug 03, 2010 | 1988 Chevrolet S-10

1 Answer

Sometimes hesiatates when the air is on, slow to take off, lurches. replaced gas filter, air filter put in on machine at auto store said miss fire 5

check your tune up. #5 plug wire & plug come on back here, i am sure some one will be able to help you fix your truck thank you for using fix ya.please feel free to ask again.

Jun 21, 2010 | 2001 Chevrolet Blazer

1 Answer

1998 Sebring cranks and fires but won't start?

I would put three cans of dry gas in the fuel tank. Let it sit for a few and then crank it over. The other issue may be that the fuel filter needs to be changed.

Mar 05, 2009 | 1998 Chrysler Sebring

1 Answer

Missing while idel

It is probably a bad coil, have someone put it on a computer and see what cylinder is missing. The coils go bad all the time on the 5.4's

Dec 22, 2008 | 2007 Ford F-250 Super Duty Lariat

Not finding what you are looking for?
1994 Dodge Intrepid Logo

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides