Question about 2007 Ford Explorer Eddie Bauer

1 Answer

2007 Ford Explorer Eddie Bauer stalls while driving. All instrument lights come on. Does restart. (1st time it happened, it started right back up. 2nd time, started only after it sat for 1/2 hr.) 2 different repair garages hooked it up to their computer and neither were able to identify a problem. Any advice on what to have checked next would be greatly appreciated.

Posted by on

  • Ian Law Feb 06, 2014

    I had exect same proplem but after several times of stalling or not starting the engine light light up and there was a code for the mechanic to diagnose, I was told it was the Torque converter & solinoid (By Midas) and after $1,300.00 They only replaced the solinoid body? and charged the same price, and the car is still not starting sometimes and there is trans leak, they beter fix it, was told it was covered but we will see!!!

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Ford Master
  • 615 Answers

You might try changing your camshaft position sensor it will not usually turn your check engine light on and will usually start after sitting until it cools down. if this was helpfull please leave me good feed back

Posted on Oct 16, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Ford Explorer Oil change rest message

Turn ignition on. Don't start the car. When the message shows up press setup. It will tell you to press reset to reset the oil life to 100 %.

Posted on Aug 25, 2009

harley9701ha
  • 424 Answers

SOURCE: i have 98 eddie bauer ford explorer with headlight problems

The headlamp switch will cause the lamps to turn off. The switch heats up and turns the headlamps off. It will cool down and work for about 10 minutes and cut out,

Posted on Oct 08, 2009

  • 14036 Answers

SOURCE: My 1999 Ford Explorer Eddie Bauer windows and

CHECK VENT WINDOW MOONROOF FUSE AND RELAY.IT TIED INTO SAME CIRCUIT POWER WINDOWS AND INTERIOR LIGHTS.,

Posted on Jan 11, 2010

  • 1 Answer

SOURCE: I have a 2003 Ford explorer (eddie Bauer series)

I have the same problem what do i do?

Posted on Feb 05, 2010

  • 14036 Answers

SOURCE: My 1993 ford explorer stalls right out after 15 mins of driving

FAULTY FUEL PUMP.A BAD FUEL INJECTOR .OR COULD BE IDLING TOO LOW ALSO IF ENGINE GETTING TOO HOT OR OVERHEATING.CHECK THE ANTIFREEZE LEVEL.TO SAVE TIME AND MONEY HAVE IT SCANNED.

Posted on May 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuse for sun visor lights located


Just Google 2007 Ford Explorer Eddie Bauer Fuse Diagram

Aug 29, 2016 | 2007 Ford Explorer Eddie Bauer

2 Answers

I have a 2007 Eddie Bauer Explorer how do I fix the message center that keep flashing circle slowly then it flashes calibrate complete.


Do you have base instrument cluster) or high series instrument cluster) ?
Symptom Chart Condition Possible Sources Action
  • The message center is not operating correctly (base instrument cluster)
  • Instrument cluster
  • OBSERVE the operation of the message center when pressing the TRIP/SELECT button. Does the message center display change when the TRIP/SELECT button is pressed?
    • If the message center display changes, the system is operating normally at this time.
    • If the message center display does not change, INSTALL a new instrument cluster. REFER to Section 413-01 . TEST the system for normal operation.
  • The message center is not operating correctly (high series instrument cluster)
  • Message center switch
  • Instrument cluster
  • Go To Pinpoint Test A .

Jan 24, 2015 | 2007 Ford Explorer Eddie Bauer

1 Answer

2008 Ford Explorer Eddie Bauer Driver Seat moves and light goes on while driving


Most likely a failing driver door latch internal contact switch , GEM module thinks it sees door open and kicks seat back and turns dome lite on. Use of a scanner to access GEM will show codes to verify issue.

Feb 21, 2014 | 2007 Ford Explorer Eddie Bauer

1 Answer

2007 ford explorer interior lights work then do not then work


if the problem is happening only when the door is open, it could be a bad connection in the door jamb switch that turns on the lights when you get in.

If it comes and goes while you are driving, the problem could be in the headlight switch/light dimming knob.

loose connection or faulty switch is my guess here.

Dec 10, 2012 | 2007 Ford Explorer Eddie Bauer

1 Answer

My Ford explorer 2007 Spanner symbol appear on dashboard when i drive a minute over 100KM/H then when i reset it dose not come back till i turn off the car and restart it and drive again over 100KM/H for...


l on the axle shaft ends for a ring with teeth this is a abs reluctor ring look for a crack in the ring the crack at higher speeds sends a signal with a different speed the the other wheels triggering a traction light

Sep 05, 2012 | 2007 Ford Explorer Eddie Bauer

2 Answers

Wrench, ABS, aniti skid, 4x4 lights on dash


First thing to do is have the computer scanned for trouble codes.

Jul 11, 2012 | 2007 Ford Explorer Eddie Bauer

1 Answer

Not able to reset oil change light 2006 ford explorer eddie bauer


Try disconnecting the battery for five minutes to reset the computer. You might want to write down your radio station settings. Some radios retain memory and some don't.

Jan 30, 2011 | 2007 Ford Explorer Eddie Bauer

1 Answer

2007 FORD EXPLORER XLT


need to set tires at correct pressure you can find a sticker on the inside of drivers door to tell you the correct pressure after you do that it sould reset the light after you drive

Feb 02, 2010 | 2007 Ford Explorer Eddie Bauer

1 Answer

I have 98 eddie bauer ford explorer with headlight problems. Headlights work when first starting up and then about ten minutes into drive the dash lights flicker and then headlights go out. If i pull the...


The headlamp switch will cause the lamps to turn off. The switch heats up and turns the headlamps off. It will cool down and work for about 10 minutes and cut out,

Oct 06, 2009 | 1998 Ford Explorer

Not finding what you are looking for?
2007 Ford Explorer Eddie Bauer Logo

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...