Question about 2001 Jeep Grand Cherokee
Jeep wont start or turn over. Battery checked at auto zone and tested good. Interier lights dont come on or dash. Some sort of clicking noise from behind dash even when take key out?
The clicking noise could be a relay trying to latch or a security system armed either way you have to have your BCM(body control module ) checked, le me know what is the diagnosis
Posted on Oct 14, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Every morning at lunch time and evening my jeep won't start. It doesn't grind but the electrical goes crazy. After a couple of trys it finally starts. Help
Posted on Aug 20, 2009
Check that your battery has 12v, check and clean terminal contacts. If battery has less than 12v have it charged and load tested. 9 of 10 times this will get you going...if not, I'll give you the rest of testing later if you need it.
Posted on Sep 08, 2009
SOURCE: Jeep Cherokee starting issue
On an intermittent start problem like this you may be having a starter solenoid issue or your wire on the starter from the key switch may be loose. Or you may have a corroded battery cable or the safety neutral switch may be going bad. Is it a automatic? If it were it would be the clutch safety switch going out. So do the simple things first. Clean cables like the first guy said if that does not fix it locate the starter and if you have jumper cables the next time it does it put the positive lead of the jumper cable on the Positive battery terminal and the other touch to the starter wire with the key in the run position where the big wire on the starter is, if you here it spin it means the starter motor is ok if it don't it is bad or the connection on the starter is loose. Also a bad battery cable could cause this from the battery to the starter next put a small wire into the end of the positive jumper cable and touch the S terminal on the starter if you here a solid clung it means the solenoid is good. So check the connections on the starter and tighten the starter bolts as they may have worked loose and don't have a good ground. So if you want more as stance just post on my question and I will hell p more and if this is more informative please rate
Posted on Sep 23, 2009
SOURCE: 2006 Jeep Wrangler won't start
First, make sure you can turn the engine by hand. If you can't then the starter can't turn it either. Have someone else turn the key and look for the source of the click...may be a relay. Go over the starting circuit with a volt meter. Check for power at the starter main terminal and then with the key turned to "start" check for power at the trigger terminal on the starter. Check battery voltage and check relay operation.
You have a neutral safety switch on the transmission if its an automatic and a clutch switch if it's a stick. Check them as well. Make sure battery grounding on fender and block are also clean and secure.
Posted on Oct 02, 2009
Testimonial: "Will try! Thanks!"
Tips for a great answer:
Oct 27, 2017 | 2005 Jeep Grand Cherokee
Feb 10, 2018 | 1996 Jeep Grand Cherokee
Sep 16, 2011 | 2005 Jeep Grand Cherokee
Feb 08, 2010 | 2005 Jeep Grand Cherokee
Dec 02, 2009 | 2000 Jeep Grand Cherokee
Sep 08, 2009 | 2002 Jeep Grand Cherokee
Feb 21, 2009 | 2002 Jeep Grand Cherokee
Jan 23, 2009 | 1996 Jeep Grand Cherokee
370 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: