Question about Cars & Trucks

Open Question

Replace 2009 hyundai elantra touring brake light

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


SOURCE: i have a hyundai elantra 2001.. the brake light and the battery light both turn on.. what could be the problem...

Your alternator is probably not charging at full capacity. The brake light is next in sequence with the battery light, and will glow dimly. (Set your parking brake, and it will glow brighter.) I replaced the alternator, and cleared up the problem.

Posted on Oct 26, 2008

  • 53 Answers

SOURCE: Brake lights won't go off

learned to trouble shoot this in school, it might be that your lights and or switch are backwards, that was usually the case we discovered to be the culprit, and be sure you have the right bulbs and not some random generic compatible with these model cars, those bulbs will not be compatible with the current going thru them, if this does not help, you might want to try to reinstall the original components to back track your work, unfortunetlly electronics on cars is very time consuming as we learned in class.....hope this works or helps

Posted on May 21, 2009

  • 1280 Answers

SOURCE: how to remove brake drum rear wheel 2004 Hyundai Elantra

Jack up rear of car till tire is off the ground.
Remove lug nuts & remove wheel.
Remove phillips screw(s) from drum.
Using a hammer, strike the drum to loosen it from the hub.
Remove drum by simutaneously turning it and pulling it outward away from the vehicle.

Posted on Oct 04, 2009

  • 94 Answers

SOURCE: How to replace 2004 Hyundai Elantra starter

First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Posted on Feb 07, 2010

  • 171 Answers

SOURCE: how to replace 2002 hyundai elantra hub and bearing

With the car on ground, break loose the drive-axle nut, and the wheel nuts , than jack up the car, support it properly, remove the wheel ,remove the axle-nut.
Remove the brake caliper assembly-- support it properly.
Remove the two bolts that hold the hub bracket to the Macpherson strut assemble, remove the lower arm ball joint and remove the steering tie- rod ball-joint attached to the hub bracket. That's it.Slide off the hub /with the bracket off the drive-shaft.
Follow steps backwards to assemble back.

Posted on Apr 09, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Have a 2009 elantra touring manual transmission. it makes low noise from the transmission, when in neutral. as soon as i hit the clutch the noise disapears.what could it be? thanks

The thrall bearing may be worn out. It sits on the clutch fork. When you step on the pedal, the fork pulls the bearing away from the clutch "fingers", taking the load off the thrall bearing.

Feb 04, 2017 | 2009 Hyundai Elantra

1 Answer

Where are the usb ports in the 2009 elantra

Only the 2009 Hyundai Elantra Touring has a USB port.

Dec 05, 2016 | 2009 Hyundai Elantra

1 Answer

My Hyundai Elantra dashboard light don't come on and front right head light out

You either have a bad fuse or burnt out lamps. Fuse is easier to replace.

Aug 28, 2015 | 2010 Hyundai Elantra Touring

2 Answers

The brake lights won't come on,on my 2009 Elantra

To keep it simple u might check the brake light switch on the brake pedal. It is most likely bad or it might be misadjusted. If u knnow how to use a test light see if it has power and if circuit is complete when pedal is pressed down.

Sep 23, 2012 | 2009 Hyundai Elantra

1 Answer

My 2009 elantra touring gls radio has a ghost in it. at random times the volume or the channels will increase. how can this be fixed?

There is nothing wrong with your radio. Your Elantra radio automatically changes the volume for you. When you slow down and stop, it lowers the volume, then the volume goes back up when you accelerate.

Mar 15, 2010 | 2009 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14548 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides