Question about Cars & Trucks

Open Question

American Heritage Turbo Broiler Model AHTB-2111, What Could Be The Problem? Can't be opened screws are unavailable to market, How to dismantle it?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cylinder head torque specs for 2002 jeep Cherokee 2.5 crd diesel,


mitchells down>? that it?
welcome to a USA forum.
where dont have 2002 Cherokees, sorry, not a one here.
last one 2001, until 2014. so.... whats up with this post?
but they do in europe. and is our Liberty in drag.
so where are you?, tell that and helpers can look books up in
your country , we dont have this car here. so no books.
this one>?
VM Motori/Detroit Diesel

here is my wiki paste, so again, where are you.....
the crd was tried back in 80s but is not same engine,then.,

Numerous versions were available in markets outside the U.S. and Canada.
Early-2002 through mid-2003 model year CRDs were equipped with a 2.5lt VM Motori Diesel producing 105 kW (143 PS; 141 hp) and 343 N·m (253 lb·ft). An external wastegated turbo was standard and the engine was available only with a manual transmission.

and
the last North American market Jeep product that was offered witht this diesel engine was the 1987 Jeep Cherokee and Comanche.


next time post country and get 100x better answers
and faster and most important accurate.
best question would be.....????
are bolts TTY
are bolts re-useable
are bolt torqued, or angle set or both. all are the best questions.

Oct 22, 2016 | Jeep Cherokee Cars & Trucks

1 Answer

Can i see the wiring diagram of turbo broiler


You did not specify the manufacturer make or model, so I hope this can get you started: Wiring Diagram RD100

Jun 03, 2015 | Cars & Trucks

2 Answers

I got a 1999 Honda ODY, TCS and CEL light keep coming on. Replaced the Gascap, O2 sensor etc. After replacing all sensors, waterpump etc. the TCS light as well as the CEL are back on. Any help ou there? We...


this may seem like a stupid question, but have taken the car to an auto parts store to have them read the codes in the computer. i don't know what stores are in germany but here in the U.S. autozone or someplace like that will do it at no charge.

Apr 06, 2011 | 1999 Honda Odyssey

1 Answer

My seat belt and air bag warning lights are showing up on the dash of my 2006 bmw 330i. how can I get that repaired?


2006?' sorry but this side of the computer is using encrypted software so its a dealer only job ,and your lucky on an american market vehicle at least you can read the codes try doing that on a europeon market model

Nov 06, 2010 | BMW 330 Cars & Trucks

1 Answer

Cant get fuel to the enjeters replaced the


no take it on a breakdown truck to a kia garage as i think the immobilisor has cut in ,now these vehicles have two diagnostic plugs ,one OBDII in the cab and another one under the bonnet,now the one under the dash which is the OBDII will on a american model allow you to do the emmision test but on the europeon market model it will not do anything other than allow you to read the chassis number ,To do any work on it you would need to read the diagnostic plug under the bonnet which on europeon models needs a special plug and is encrypted ,now weither your american market model is encrypted ?? i do not know

Aug 01, 2010 | 2001 Kia Sportage

1 Answer

Etc fail safe mode codes p2104 2107 2110 2111 2112


P2104 Throttle Actuator Control System - Forced Idle
P2107 Throttle Actuator Control Module Processor
P2110 Throttle Actuator Control System - Forced Limited RPM
P2111 Throttle Actuator Control System - Stuck Open
P2112 Throttle Actuator Control System - Stuck Closed

Seems like Throttle Actuator is the problem.

Good luck on this repair.

Jul 13, 2010 | 2005 Lincoln LS

1 Answer

Hi, my son has a 1997 Ford Fiesta SI, how do I get the near-side door trim off? I need to get at the door lock, someone tried to break in and left the external lock hanging off. I entered in the "PRODUCTS...


generally, the actuall panel should just pry outward. there's a large number of plastic things holding the pannel on. these will most likely have to be replaced. look for plastic plugs on the pannel. sometimes these hide screws behind them. you've also got to remove the plastic trim inside the door handle. if you have a actuall window crank handle, there will be a clip you'd have to pop out from under with a rag. be on the lookout for screws with funny-shaped heads, you may have to buy a special screwdriver for them. make sure you get some assitance from a DIYer or a car specialist with a day off to make sure you get everything put back together right. for future help reference (as the names here are oriented toward their American market Counterparts), look for the names "Festiva" or "aspire", which I believe is the closest American market equivelant to your son's Fiesta. Pumas could go there as well.

Jun 10, 2009 | 1997 Ford Escort

1 Answer

How to dismantle back lamps in mini cooper 2008?


You have to open the hatch or trunk and maybe some plastic or carpet to get to the screws...

Mar 30, 2009 | 2007 Mini Cooper Convertible

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...