Question about Cars & Trucks

Open Question

What transmission codes are alternatives for an Audi A4 2.6L V6 Auto with the code CJU?

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: AUDI A4 AUTO

In the gearbox sump is 2 plugs. one small to drain the oil and a big on that fits a 17 socket l-key .start engine in neutral ,turn out the :17" nut and fill with pump until oil overfills. I dit mine this way and got the advice from a good geeerbox rebuilder in Pretoria. NOW HELP ME AND TAKE A PHOTO OF YOUR SPEEDO PIPES AND E MAIL TO ME I CHANGED THE PIPES AND MIXED THEM UP AND NOBODY HAVE OR WANT TO SHARE THE INFO PLSE vmd.bakker@vodamail.co.za

Posted on Aug 19, 2008

pippall
  • 1486 Answers

SOURCE: 1995 Audi A4 transmission control

If the tranmission codes are the same. yes you can.

Posted on Aug 09, 2009

  • 550 Answers

SOURCE: i have audi Q5 2010 model i have a fault code to the transmission i dont know what is this P1f68

HI,
Strongly suggest taking to the dealer as it should still be under warranty.

Code info I googled:

OBD II Fault Code P1F68 :Description of OBD II Fault code P1F68

TH2TNK Sensor Value Offset Shifting
Possible failuer of OBD II Fault code P1F68

  • Hydrogen Tank Internal Temperature Sensor (TH2TNK) offset shifting
  • Inlet Air Temperature Sensor (TA) offset shifting
  • Offset shifting of both Teperature Sensor (TH2TNK) and Inlet Air Temperature Sensor (TA) in Hydrogen Tank
  • RTC function error (Miscalculated Soak Time)
  • FSVSCM failure
  • FCCM failure
Diagnostic Procedure using AutoHex auto Scan tool tester
  • The rear average wheel speed > 15km/h and vehicle speed on the meter<1km/h
  • If the rear average wheel speed > 15km/h and VSP<1km/h lasts for 0.3 seconds, the malfunction is determined.
Test Conditions using AutoHex Scan tool tester
  • Vehicle speed / wheel speed is normal
  • Brake is out of action
  • The automatic brake is out of action
Clear Fault codes Conditions
  • The rear average wheel speed > 15km/h and vehicle speed on the meter<1km/h
  • If the rear average wheel speed > 15km/h and VSP<1km/h lasts for 0.3 seconds, the malfunction is determined.
MIL Status
  • Glow ON


Note:
  • AutoHex is a professional OBD /OBD II diagnostic scanner / scan tool tester.
  • This fault code is a GERENRIC fault code, some cars may change the meaning of this fault code.
    To get the accurate fault code description you may use AutoHex OBD scanner

Posted on Oct 24, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have audi a4 1996 v6 donot gode power speed When you press on the gas pedal starting slow ??Is the problem in geerbox or air system or oil pump thanks


run the fault codes as the problem may be in the accelerator position sensor or the throttle position motor if there is a problem in the transmissions the fault codes will reveal the faulty sensors/ servos and solenoids

Jan 23, 2016 | Audi Cars & Trucks

1 Answer

Obd code p1652


this could mean your transmission control module is going bad does the car have trouble shifting gears at all?

May 14, 2013 | Audi Cars & Trucks

1 Answer

Where is the speedo drive on an Audi a4 2.8 V6 automatic gearbox located


its and speed sensor. should be on transmission.. check with auto zone..

Dec 15, 2012 | 1998 Audi A4

1 Answer

I have a 2004 Chrysler 300m with a 3.5l engine and getting a 0871 and 0700 code.


Please don't forget to rate!


Trouble Code: P0871 (3.5L V6 VIN G Auto)
A/T O/D Pressure Switch Circuit Malfunction


Trouble Code Conditions:
Engine started; vehicle driven in a forward gear, and the PCM detected that the O/D Pressure Switch circuit indicated open or closed at the wrong time.

Possible Causes:

  • Related DTCs may be present
  • O/D pressure is incorrect, or internal transmission faults exist
  • O/D pressure switch circuit is open, shorted to ground or power
  • O/D pressure switch is damaged or it has failed
  • TCM relay power circuit to O/D switch is open (loss of B+)
  • Intermittent wiring or connector problems exist
  • PCM or TCM has failed


Trouble Code: P0700 (3.5L V6 VIN G Auto)
Automatic Transmission Control System Malfunction


Trouble Code Conditions:
Ignition on or engine started. The PCM received a message over the CCD Bus from the Transmission Control Module (TCM) that it had detected a problem and set a trouble code in memory.

Possible Causes:

  • The presence of this code means the TCM detected a problem
  • TCM related Sensor has solenoid is damaged or has failed
  • This code is for information only - check for other TCM codes
  • TCM or PCM has failed

May 08, 2011 | 2004 Chrysler 300M

1 Answer

I have an audi a4 1996 2.6 v6 the auto transmission will not select gears after i drove it in very heavy rain conditions. is there a possibility water could have gotten into the transmission and if i...


The transmission should be totally sealed from rain getting in unless you were submerged,even then not really.What sometimes can occur although rare, is that in very heavy rain and slip conditions the controls and sensors for torque distribution and anti spin and lock can get a liitle confused and set off numerous fault codes.The system goes into limp home mode that usually limits revs and/or shift changes.I would first make contact with a garage or dealership that can successfully read your ecu for fault codes and clear them.Also does your speedometer and /or rev counter still function correctly,as a speed sensor fault can give a similar fault,but again it will set of a fault code.I hope this helps or at least will get us closer to a solution.

Mar 20, 2011 | 1996 Audi A4

3 Answers

Prob's with my Audi A6 2003 Auto 3.0 V6 (gearbox)


Doubt it as the fault suggests you need to look into the range sensor. If similar to Renault there is a switch on the gearbox that senses where the select lever is (at the gearbox end). If the display is wrong then the sensor needs looking at and either it will need to be adjusted into a set position by moving it, or perhaps the connector to it or wiring to/from it have a fault.

May 08, 2010 | 2003 Audi A6

4 Answers

Does the 3.0l transmission fit on the 4.0l engine


Hiya,

There are 5 automatic transmissions used in the Ford Ranger, Explorer and Mountaineer. They may be identified by checking the transmission code on the Safety Standard Certification Label attached to the driver's side door post, in the space marked Trans. The transmissions can also be identified by a tag attached to the lower left hand extension attaching bolt. The transmission codes are as follows:
  • 1991–94 code T is for the A4LD transmission
  • 1995–99 code T is for the 4R44E (2.3L, 2.5L & 3.0L) or 4R55E (4.0L) transmission
  • 1996–99 code U is for the 4R70W (5.0L) transmission
  • 1997–99 code D is for the 5R55E (5-speed automatic) transmission
So, what you need to do now is...establish from a FORD workshop, whether both the A4LD and 4R55E transmissions share the same components and mounting dimensions.

Cheers,

Scott

Nov 12, 2009 | 1992 Ford Ranger

1 Answer

1995 Audi A4 transmission control


If the tranmission codes are the same. yes you can.

Aug 08, 2009 | 1998 Audi A4

1 Answer

Can find the dip stick on a 96 audi, standard v6 quatro


If you are looking for the transmission dipstick, there is none; The auto tranny is not serviceable by the end user (unless you have special equipnet and a VAG scanner in your garage).

Jun 18, 2009 | 1997 Audi A4

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...