Question about Cars & Trucks
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The above information about the sensor being located at the top of the motor to the passenger side of center is bogus. That is only the pig tail plug in. The actual sensor pig tail continues down below, underneath the plastic lower timing belt cover, on the front of the motor, just above the crankshaft timing gear.
It is a very involved process of removing and replacing. You will have to remove all of the belts, the front timing belt covers, (upper and lower). You will also have to remove the front bracket that is mounted to the front of the block, which serves as the mount for the power steering pump, the alternator and the A/C compressor.You will also have to remove the crankshaft pulley. You cannot remove the plastic lower timing belt cover unless you remove all of these things first. The sensor is located underneath the lower cover. It has two bolts that hold it in place. You will have to remove these two bolts.
The crankshaft pulling bolt is a right handed thread and loosens by turning counter clockwise. The pulley will slip off but is a very tight fit. Do not try to turn it while removing it as there is a small pin that keeps it aligned to one position. Use a small ball pine hammer to tap it loose.
It is also a good idea to remove the electric cooling fan shroud that is mounted to the inside side of the radiator and the radiator hoses to give yourself more room to work. It has only two bolts at the top holding it in place. And then slips into two retaining clips at the bottom. Lifting it will pull it out of these retaining clips.
When you remove the small bypass hose located at the top of the radiator , to the passenger side, be careful not to break off the small nipple protruding out of the radiator tank. It is plastic and will break easily if you try to pull the rubber bypass hose from it. This will have to be taken to a radiator shop to have repaired if you accidentally break this off. Be sure to carefully loosen the hose from this nipple before trying to pull it off.
And one more thing, if you go to that much trouble to replace this sensor, it is a good idea to go ahead and replace the timing belt as well. It is a maintenance item and you will have to go through the same process to replace it as well. Do it once and do it all.
I hope this helps.
Posted on Nov 15, 2008
Here you go, just ignore part about removing sprockets. Click on pictures for larger view.
Posted on Mar 01, 2009
The crankshaft pos. sensor is located on the left "driver" side of the engine on the bellhousing and is retained by a single 10mm bolt.The sensor may be tight,be sure to twist as you pull so that it doesnt break off in the bottom end.
Posted on Jul 26, 2009
Tips for a great answer:
Feb 09, 2018 | Kia Cars & Trucks
Oct 09, 2015 | Kia Cars & Trucks
Jun 19, 2015 | 2006 Kia Sportage
Jun 04, 2014 | 2006 Kia Sedona
Sep 15, 2012 | 2005 Kia Sportage
Sep 23, 2011 | 2005 Kia Sportage
Apr 18, 2011 | Kia Sportage Cars & Trucks
Apr 28, 2009 | Kia Sportage Cars & Trucks
May 23, 2018 | Cars & Trucks
547 people viewed this question
Usually answered in minutes!