Question about Mitsubishi Pickup
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
frajogag: First off, be aware that these bolts are "torque to yield" bolts (streach bolts). What this means is that instead of torqueing the head bolts to a specific torque specification, they are torqued down to a set spec and then tightened by rotating the bolts a certain angle, like 90 degrees. and all of them are turned the same amount.
This means that the shanks of the bolts must be checked to make sure they are not too thin (or the bolt has already stretched beyond limits and is prone to snap if used)
Here is how you check the bolts. Measure the bolt using a micrometer, at the base, or within the first 13mm from the end where it threads in. Then go to about 10mm before the threads end heading toward the top of the bolt. There should not be more than a 0.23mm (.0091 inch) or less difference or the bolt should be discarded.
Torque the bolts down to 98.1Nm ( 72.ft lb)
Looking at the head from the side, so you are looking at the full length from side to side, I will number the head bolts in this fashion.
#1 & 2 are directly in front of you and in the center of the cylinder head crossing it width wise.
#3&4 are to the left of #1&2, / #5&6 are to the right of #1&2
#7&8 are to the left of #3&4 / #9$10 are to the right of #5&6
Now, you have the sequence.
After the initial pull, back off all the bolts in the same sequence and then retorque them to 36 Nm ( 28 ft lb)
Using a torque angle wrench or having the ability to accurately judge turning angles. Rotate (clockwise) to a 75 degree angle. do this to all the bolts using the sequence I had provided.
Rotate the bolts (clockwise) 75 degrees again on all bolts in the same sequence. The proceedure is complete!
Posted on Apr 23, 2009
youre going to torque it to 65 ft lbs.. start from the centre out and go diagonally. be sure to replace the head bolts and very lightly oil them before installation.
Posted on Nov 09, 2009
Tips for a great answer:
Oct 21, 2016 | Cars & Trucks
Aug 17, 2015 | Kia Cars & Trucks
Jan 30, 2013 | 2006 Kia Carnival 2.7
Jul 03, 2012 | Kia Carnival Cars & Trucks
Jan 31, 2011 | 1999 Kia Sportage
Mar 16, 2010 | 2005 Kia Rio
Nov 24, 2009 | 2001 Kia Sportage
Feb 04, 2009 | 2005 Kia Sedona
94 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: