Question about 2003 Honda Accord

Open Question

Honda accord lx 1998.p 1167.no dtc definition found

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: Honda Removal of factory radio 1991 Accord lx

start by removing the console. there should be four screws that hold it in; two on each side; one in the front and one in the rear. you may have to take the gearshift knob of if the car is manual trans.then, remove the ash tray. there are two screws at the front of the ashtray receiver and one at the back.with the ashtray and slide removed, take the bezel off of the radio. there should be two screws behind or above the air outlet vents on top andn two screws in the under the center dividing rail. you may have to pop out the air outlets to get to the screws. there may also be a screw at the bottom of the bezel in the center.with the bezel removed the only thing that holds the radio in at that point is two screws that come up from underneath where the ashtray receiver was. take out those two screws and the radio should pull out from the front. Be sure to disconnect the antenna lead and the connector from the back of the radio before pulling on it too hard or you'll damage one or the other.hope that helps

Posted on Jan 17, 2009

Online-Tech
  • 51 Answers

SOURCE: where is the valet switch for honda accord 2002 lx?

Hi,
Does the vehicle have an aftermarket alarm system? Is the valet switch for this what you are looking for? If so, it depends entirely on who installed it as where they have put it, although it's usually under the dash on the driver’s side. Some alarms have different sequences that you have to go through to put the alarm into valet mode; it's not usually just a switch that you flick. Best to pop into an alarm or stereo installer and see if they can spot it for you, or if the car is immobilized, find out what sort of alarm it is and call an installer for the info on the valet procedure.

Thank You for contacting Fixya.com

Posted on Aug 03, 2009

Sean80000
  • 1867 Answers

SOURCE: 1994 hoda accord lx brakes

Please refer to the link below.

http://corp.advanceautoparts.com/english/youcan/asp/ccr/ccr20011001bb.asp

Posted on Dec 01, 2009

philschneide
  • 448 Answers

SOURCE: how to remove starter from 1998 honda accord

Detach the cable from the negative terminal of the battery. Caution: If you have an anti-theft radio, make sure you have the activation code before disconnecting the battery.

Remove the battery and battery tray from the engine compartment (remove the battery first, then remove the bolts for the battery tray and remove it.).

Remove the lower radiator hose and the wiring harness from the starter bracket. Make sure they are positioned out of the way.

Clearly label, then disconnect the wires from the terminals on the starter motor solenoid (the smaller cylinder attached to the starter). Disconnect any clips securing the wiring to the starter.

Remove the mounting bolts (two) and detach the starter (pull it gently out of its housing).

Reverse this procedure for installation.

Hope this is of help to you.

Posted on Dec 26, 2009

  • 819 Answers

SOURCE: how to remove starter solenoid from 1998 honda accord LX 4cyl?

the starter solenoid is integral to the starter.

Posted on Dec 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi i have a 1997 honda acccord lx with a vtec engine i got the check engine light and scanned, recieved dtc code p1259 vtec system failure the symptoms are it driving normal until it reaches 3,500 rpm


If this is a 1997 LX Accord, it did not come with the VTEC, that was only on the EX version in 1997. So someone put an EX VTEC engine in your LX. I've seen this done, and it requires a EX pcm computer. It also needs VTEC wiring to be installed. Check the engine serial # and ID what this engine is from.
If this is actually an EX Accord, then there are more things that can fail than the solenoid. The pressure switch is a common failure.

Oct 21, 2014 | 1997 Honda Accord

1 Answer

What is no dtc definition


There is a problem with the VTEC Oil Pressure Switch circuit or VTEC Solenoid Valve circuit

Make sure the oil level is good and it is not dirty. Dirty oil can clog the VTEC assembly so you might have to take it apart, clean it, and replace the seals.
Read more: http://engine-codes.com/p1259_1998_honda_civic.html#ixzz3E3cMniiB

Sep 03, 2014 | 1998 Honda Accord

1 Answer

P1259 no dtc definition


Hello friend, from here...http://www.modifiedlife.com/1999-honda-accord-diagnostic-check-engine-trouble-codes/

P1257, P1258, P1259 22 VTEC System Malfunction

I have no idea what VTEC means.

Good luck

Sep 03, 2014 | Honda Accord Cars & Trucks

1 Answer

Need to know where to find a routing diagram for the serpentine belt on a 2000 honda accord lx 4 cylinder


see the following site that I found by googling "2000 honda accord serpentine belt replacement" You will need to know what engine size and whether you have AC.
https://www.google.com/search?q=2000+honda+accord+serpentine+belt+replacement&client=firefox-a&hs=zDs&rls=org.mozilla:en-US:official&tbm=isch&tbo=u&source=univ&sa=X&ei=ylF4UoS5O6zfsAS8oYCgAg&ved=0CFgQsAQ&biw=1280&bih=896

Nov 04, 2013 | 2005 Honda Accord

2 Answers

Need wiring diagram for 1992 honda accord lx to trace


how can i fix my problem on a 1995 honda accord ex headlights wiring when i turn on the switch the parking lights come on but the headlights do not come on what do i need to do

Feb 09, 2012 | 1992 Honda Accord

1 Answer

Lighted visor vanity mirror on 1995 honda accord not working


To all,

I looked at a wiring diagram, traced it back and found a disconnected wire. After I reconnected the wire, the vanity lights started working.

Thanks fpr all your help and support.


Bignuggie

Sep 05, 2008 | 1995 Honda Accord

Not finding what you are looking for?
2003 Honda Accord Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...