Need to remove center console cover for prius 2008

6ya staff

• 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Download 6ya

6ya.com

Need repair answers fast Use 6ya to...

Posted on Jan 02, 2017

Bruce Bracey

• 1000 Answers

SOURCE: need instructions on how to remove center console to access electric window switch.

Here is what I could find, hope it helps.
Good luck.
Regards,


REMOVAL & INSTALLATION

See Figures 1 and 2
The following procedure is a general procedure for console removal. You may have to modify or skip certain steps depending upon your vehicle.

1. Disconnect the negative battery cable.
2. Remove the shift knob, floor compartment door and console trim plate.
3. Remove the instrument panel accessory trim plate.
4. Unfasten the retaining bolts, detach the connector, then remove the console door.

1. Remove the seats, as outlined later in this section, in order to get to the lower rear screw(s) on the side trim panels.
2. Remove the console side trim panels.
3. If equipped, remove the switch pack housing with the switches.
4. Remove the console compartment floor protector, bolt covers and bolts.
5. Unfasten the screws mounting the console to the instrument panel and tunnel.
6. Unclip the harness and accessory plug.
7. Tag and detach all necessary electrical connectors.
8. If necessary, remove any remaining retainers.
9. Tilt the rear of the console up, then slide the front tab back out of the instrument panel and remove the console from the vehicle.

1. Position the console in the vehicle by placing the front tab of the console into the instrument panel slot, making sure to align the screw holes.
2. Attach the electrical connectors as tagged during removal.
3. The remaining of installation is the reverse of the removal procedure. Tighten the console retaining screws to 89 inch lbs. (10 Nm).

Posted on May 04, 2009

Alwyn Black

• 15 Answers

SOURCE: how do i remove the center console in a mercedes

take out your ashtray and see if there is srews down there and remove the cover round the gear shifter to find the other srews

Posted on Jul 19, 2009

SOURCE: remove the door that covers cup holder in the center console of a 2007 hyundai sonata

2005 Sonata the cup holder cover won't close. Is there a solution?

Posted on Aug 27, 2009

SOURCE: Need to remove center console ashtray to recover a

it should either pop or screw out.

Posted on Oct 06, 2009

SOURCE: How to remove the center console from my 2008

Try Alldata online manual. OR - If your wanting to do this you probably can't shift out of Park? If your like me, a spring most likely come loose inside the shifter assembly. Pull up on the shinny PRND outer cover to remove, the rest of the covers unsnap (use small screwdriver), pull up on shifter knob (might need to wiggle a little), Look for the pink plastic thing on the left. It should have a spring that pulls back on it when you shift into reverse. If this is missing, unbolt the four nuts that hold the assembly to the floor, look for the old spring. If it's gone you can cut a new one to size and hook it back on. If yours is like mine, the small pink hook (****) is broke and you will need to drill a small hole in it to have something to clip the new spring to. By the way, I had to do all this with the assembly in the compartment as I was unable to remove it completly. Not enough room. I removed the coin tray in front of the shifter, ParkReverseNutralDrive thing, grey cover that surrounds the coin tray(just pull out and up (it snaps in), 4 mounting nuts, and the cable that attaches to the pink piece of plastic that Chrsler should have put a little more effort into designing. ARG! Good luck.

Posted on Jul 30, 2010