Question about Toyota Camry

1 Answer

I am trying to get the power window (drivers side) glass back on track. I have the panel off already.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Loosen the bolts that hold the window to the rail, then move window so that it will fall into the track. when you complete that tighten bolts.

Posted on Oct 13, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 26 Answers

SOURCE: Drivers side power window stuck

yes,

1. trust youself

2.Open the panel slowly, some screws behind the handle opener, first you start from the bottom of the panel, and check see where has the screw connect to the door metal part and figure it out to open it. As soon as you move the panel, cut the plastic on the metal and check the small plastic wheel see it is in the track, and also check the arm connect to the motor, maybe the arm loss, be sure put a pin to connect the arm and then test it.
3. any this kind job, cost you more than $350.00 -$450.00
Hope this can help.

Posted on Jun 22, 2008

  • 1 Answer

SOURCE: Drivers side widow will not go down more than 2 inches

A) Remove the screws in the following locations:

  1. Door handle
  2. door grip
  3. Middle of panel, 3/4 down the panel from the top
B) Removal of door Handle

  1. Use caution
  2. Slide the door handle in the direction of the motor
  3. The door handle is now freed from the door
C) Partial removal of door panel
  1. Insert a dull instrument into the port that is located on the panel roughly half way down the panel and the side the furthest from engine.
  2. Carefully pry the panel loose.
  3. With your hands, remove the panel by its contour. There are roughly 10 or so plastic plug
D) Tricky Part; Removal of door Handle

  1. Free the door handle from the panel, by carefully pushing it through the panel on an angle...
  2. You can now push the panel up beyond the door lock button.... then...
  3. The wiring haness is now exposed.
E) Wiring Harness

  1. You now un plug the wiring harness from:
  • Door handle
  • Lower courteosy light
  • Electric window controls (three wires)
F) Final steps

  • Lift the panel up and over the door lock button.
Now to your window problem.

When I examined the problem that I had with my Odyssey, I found the following:

  1. Two bolts were missing;
  2. The other tow bolts were lossed;
  3. The motor had shifted positions.





Posted on Nov 27, 2008

SOURCE: how to remove the inside door panel to access window off track

Go to http://www.wikihow.com/Remove-an-Inside-Door-Panel-from-a-Car Gave step by step instructions.

Posted on Dec 28, 2008

c17hydro
  • 2984 Answers

SOURCE: driver window off track need to take door panel off how?

On vehicles without power windows, place a soft cloth under the window regulator handle and pull upwards on the cloth to release the snapring. Remove the regulator handle and plate.

Fig. 2: Using a taped prytool, carefully remove the bezel portion of the handle

46f6882.jpg Fig. 3: Remove the bezel by pulling towards the tip of the handle

9b11f67.jpg Fig. 4: Remove any screw covers . . .

Posted on Mar 31, 2009

  • 1986 Answers

SOURCE: REMOVING A DOOR PANEL

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Power window slipped off track drivers side freezing temps


if your window has popped out of its track , a neet hack to get it back in is to use a bar of soap !! just rub a generous amount on glass edge and window track and gently wiggle the glass back into track (don't bend glass) use only an old credit card or your "cold" bare fingers to wiggle it back in , metal tools will break the glass 4 sure

leave the soap on windows edge it keeps ice from sticking !!

Dec 16, 2016 | Cars & Trucks

1 Answer

The drivers side window is off the track and now im having problems getting it closed


you can sometimes get it back in by lowering the window all the way down, pry or hold open the felt seals on the door, and look into the door with a flashlight, you might be able to get it back in track by moving the window back and forth (be carefull not to strain glass or it will shatter).. may have to remove door panel to put glass back on track.

Dec 15, 2013 | 2003 Chevrolet Malibu

1 Answer

How do you install the drivers side window in a 1994 Jeep Cherokee Sport? Already removed interior door panel, bottom window molding, and screw & washer from regulator, Can't understand how to get...


Most door glass slides in from the top **** in the door. Sometimes the window seal around the window frame may have to come out and can be re-installed after you secure the glass to the track. You may have to insert the glass at an odd angle to fit it thru. Be sure to have the door panel off so you can access the track screws(bolts) and make sure you do or don't have to bond it with adhisive. A great bonding agent for this is gorilla glue, tested and still working on my friends 93grand cherokee. Good luck.

Aug 31, 2010 | 1994 Jeep Cherokee

1 Answer

Drivers side door will not go up or down; window is off track and door will not open


Hello. You have two choices here on how to proceed. Often when this occurs, it is a sign that the window motor and the track inside that door are on their "last legs" This assembly is called the power window regulator and it can be found on the net for about $75.00 So, you may either put the window back in the track and hope for the best or you may choose to replace the power window motor and the track, which comes as one unit called a driver's side door power window assembly. Either way, you have to remove the inner door panel to expose the track and the motor and the glass.

Jan 25, 2010 | 2002 Chrysler Concorde

1 Answer

Power window off track, motor still works


your window does not ride on a track the motor has a gear that drives a mechanism up and down. it sounds like the motor came loose.
pop the door panel and remount the motor, first pull the window all the way up. hope this helps

Dec 24, 2009 | 1997 Buick Skylark

1 Answer

The drivers side rear window does not work. It does side down, and when the power switch is press the motor turns on. could the window be off its track or does the window unit need replaced?


It sounds like the window may be off its track. All that needs to be done is to remove the inner door panel. Be careful to pry the clips very gently. They break easily. However, most auto parts stores carry replacements. Once the door panel is off, remove the plastic sheeting that covers the door frame. It's attached with a mastic adhesive.
Once you have a clear view of the window rail, carefully pull the pane up and set the glass on the track. You may need to apply some silicone in the track to keep the glass in place.

Then, test the alignment by pressing the power button and roll the window up and down. With the window closed, replace the plastic sheeting and the door panel.

That should do it.

Oct 09, 2009 | 1994 Lincoln Town Car

1 Answer

Driver's side power window will not roll up


Sounds like wear and tear on the guides/seals.

May 19, 2009 | 1995 Honda Accord

1 Answer

DRIVER SIDE WINDOW OFF TRACK


you must pull door panel off (you can find the tool at any parts deals) then lift the window up with hands only it is hard but can be done get some one to hold the window glass up and check to see if any parts have fall if so put back on or replace. if not missing clean track and crank up to glass and line up. wind up and down to make sure it stay and then re-place door panel. hope this works it did for me on my 95 contour

alienphone

May 04, 2009 | 1995 Ford Contour

1 Answer

Fallen driver's side window


probably need a new window regulator. ebay. 93 to 98 should fit.

Section 01-05: Trim, Interior 1998 Villager Workshop Manual
REMOVAL AND INSTALLATION Trim Panel(s), Door Front
Removal
  1. Disconnect the battery ground cable (14301) if equipped with power locks or power windows.
  1. swv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: Use care when removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component.
    Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 inch screwdriver between the top rear portion of the front door inside handle escutcheon and the front door trim panel (23942) .




  1. If equipped with manual windows, slip a clean shop rag between the window regulator handle (23342) and the front door trim panel .
  1. Pull the shop rag back and forth to release the window regulator handle clip.




  1. Remove the three cover caps and front door trim panel screws.
  1. Remove the one front door trim panel capped screws from the door pull handle.
  1. If equipped with power windows, remove the door pull handle. Disconnect the electrical connectors.
  1. Slide a flat-bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door (20124) .
  1. Remove the front door trim panel.
Installation
To install, reverse the removal procedure.
---------------------------------------------------------
Window Regulator, Power Front Door
Removal
  1. Disconnect the battery ground cable (14301) .
  1. Remove the front door window glass (21410) . Refer to the front door window glass removal procedure in this section.
  1. Remove the two front door brace bolts and the front door brace.


    415712f.gif

  1. Disconnect the front window regulator electric drive electrical connector.
  1. Remove the four front door window glass regulator track bolts.

    67b6136.gif


  1. Remove the three front window regulator electric drive bolts.
  1. Remove the front door window glass regulator track and the front window regulator electric drive (23394) as an assembly through the opening in the front door (20124) .
Installation
  1. Install the front door window glass regulator track and the front window regulator electric drive as an assembly through the opening in the front door .
  1. Install the three front window regulator electric drive bolts. Tighten the front window regulator electric drive bolts securely.
  1. Install the four front door window glass regulator track bolts. Tighten the front door window glass regulator track bolts securely.

Apr 29, 2009 | 1998 Mercury Villager

1 Answer

Driver's side power window will not go back up


im asssuming it is power windows the window track could be off its mounts or po0wer motor is failing from drag check the tracks and glass rubbersalso .could have a failing switch or poor connection

Dec 03, 2008 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...