Question about Cars & Trucks

Open Question

WIPER ARM REMOVAL NISSAN PRIMERA P12 - Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: how to reset the engine

turn ignition round to 2nd position turn everything else off like the radio heaters etc. then push and hold down info whilst doing this turn the volume key towards the passenger window and a secret screen will apear here you can do everything that a garage can do. hope this helpd ya. kennylad

Posted on Dec 07, 2008

  • 1 Answer

SOURCE: nissan primera gearbox

how much is the price for nissan primera 2003 gear box

Posted on Jan 14, 2009

c17hydro
  • 2984 Answers

SOURCE: removal of wiper arm

WINDSHIELD WIPERS AND WASHERS
Windshield Wiper Blade and Arm
REMOVAL & INSTALLATION

  1. Place the wipers are in the PARK position, then turn the ignition OFF.
  2. Disconnect the negative battery cable.
Lift up the wiper arm pivot nut cover . . .

It's plastic and just pops up and you slip it off. Next, remove the nut. Once you remove the nut, mark the arm and the shaft or top of the mounting area so you know where to place the arm back on the splines. Then, you use a tool similar to a battery clamp remover and pop the arm off. Installation is in reverse order...just remember to align the splines to the arm.


Posted on Apr 01, 2009

  • 3600 Answers

SOURCE: removal of broken rear wiper arm. removed nut but

After removing the nut turn the arm up and wiggle it back and forth while pulling it will come off.

Posted on Oct 11, 2009

Testimonial: "Thank you for the advice. You saved me labor cost at the dealer and waiting around for the repair."

4743micheal
  • 54 Answers

SOURCE: Nissan Primera petrol P12 - malfunction warning

tats the engine management light mate usally comes on when u have low oil or antthing to do with the engine bring it to nissan dealer if its not low oil they will hook it up to a machine and bingo they have your problem.

Posted on Feb 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is immobilzer reciver on a nissan primera p12


Peter, I think it is part of or at least goes around the ignition switch.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Nissan Primera P12 Immobiliser Ring Receiver Aerial Key Reader 28590 C9965
Nissan Primera P12 Ignition Immobiliser Fault Solution
nissan primera p12 immobiliser receiver location Google Search

May 19, 2016 | Nissan Cars & Trucks

1 Answer

Change boot strut on nissan primera


There are steel clips on either end of the struts use a flat head screwdriver to remove them and the strut should pop out with a little persuasion. Make sure to hold boot lid in case it falls on fingers.

Dec 28, 2013 | 2005 Nissan Primera 1.8

1 Answer

How to change fuel filter on 2003 nissan primera


2003 Nissan Primera, the P12 engine runs on chain NOT belt!!! You don't need to change the chain unless in very very unlikely case the chain snaps.

Mar 15, 2013 | 2003 Nissan Primera

1 Answer

Hi all, Nissan Primera, P12, 2002 is over revving, especially when idling. Sprayed the MAF sensor and changed the air filter but that didn't make any difference. It also uses lots of petrol sinc


Sounds like a vacuum leak or a bad intake manifold gasket. Take engine cleaner and spray the gasket where the intake manifold bolts onto the motor while running. If there is any change in the idle, your gasket needs to be replaced. Spray all vacuum hoses too. This is the best and cheapest way to test. Let me know how you do please

Jan 20, 2013 | Cars & Trucks

1 Answer

Have you left me I need back lighting my car


what is your question,I'm sure I can help.










TIM

Dec 07, 2010 | 2001 Nissan Maxima

2 Answers

Nissan primera p12 2005 wiring manual


please i need electrical shematic for nissan primera 2005 p12

Feb 26, 2010 | 2003 Nissan Altima

2 Answers

I lost my nissan primera 1996 radio code


just take it in to your local nissan dealer - they will look it up for you

Jan 30, 2010 | 1996 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

109 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...