Question about 2001 Chrysler Sebring

1 Answer

Idles too high

I have a chrysler sebring lxi and all of a sudden it started idling too high (2.5 rpms). after checking under the hood we founf what was making it idle too high and when you unplug it it idles way too low, but its a box that is connected to the breather system, i dont know what this box is called.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 710 Answers

Idle speed sensor is the device you are refering to. It is available at most auto parts places.

Posted on Apr 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Runs rough when it's warm. comes and goes. has a 2.7. and then a 99 dodge carvan with a 3.3 does the same thing.


Chrysler Sebring Questions - Car running very rough ...

www.cargurus.com > Questions > Chrysler > Sebring

CarGurusMar 27, 2011 - It seems after car gets to a certain temperature it runs very rough. ... 2011 at 12:16 PM about the 1998 Chrysler Sebring 2 Dr LXi Coupe ... it.one day it washot out and it was running sluggish with rough idle.and ... I changed the altnator and battery its runs like its brand-new.now ... 2002 Chrysler Sebring LXi.

Chrysler Sebring Questions - Engine Power Loss After Car ...

www.cargurus.com > Questions > Chrysler > Sebring

CarGurusNov 3, 2011 - Engine Power Loss After Car Is Warmed Up - Major loss of power after car has ... When vehicle is cold runs ok, sometimes a little rough but not bad. Full power. Allowed vehicle to run for over 45 minutes last night at idle, died on its own, car sat approximately 20-30 minutes. ... 2002 Chrysler Sebring LX.

* Chrysler Sebring/200 Convertible Club * • View topic - Rough ...

www.sebringclub.net/board/viewtopic.php?p=69097

Dec 29, 2006 - 5 posts - ‎3 authors
However, the vehicle still suffers from rough idle under certain conditions: ... been resolved (I don't think he noticed that it happened only when warm though). .... The test will tell you its general condition without having to dig it out of the fender, ..... Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group rough ...
15 posts
May 24, 2010
Low idle rpm
15 posts
Mar 8, 2007
More results from www.sebringclub.net

Jan 01, 2016 | 2002 Chrysler Sebring

1 Answer

My 2001 grand cherokee started to high idle all of a sudden, close to 2000 rpms. Where should I start checking??


Check for unmetered air entering the engine usually from a vacuum leak. Check all hoses to make sure none are disconnected/collapsed/leaking vacuum under the hood. If all ok, possible idle air control motor sticking resulting in high idle

Aug 03, 2015 | Cars & Trucks

1 Answer

I need a diagram to put on a serpintine belt for a Chrystler Seebring LXI 2 door Coupe


There should be a diagram somewhere under hood. If not, check shop manual (might be able to just look at one a parts store if you feel it is too expensive to buy).

Mar 27, 2014 | 2002 Chrysler Sebring

2 Answers

I have changed the timing belt on my 2002 Chrysler Sebring LXI coupe and the car runs great when it stays running. When I shut the car off and start it back up it just starts and dies but if i unhook the...


Check the throttle plates and idle speed control motor make sure there both clean.

Also check manifold vacuum at idle the best you can hold an idle. I have run into timing belt being one tooth off and engine still ran fine. But the vacuum was low that's how I could tell the belt was a tooth off.

Oct 27, 2010 | 2001 Chrysler Sebring

2 Answers

2004 chrysler sebring idle speed is too slow. HOw


why do you want your rpms higher while idling? you don't want them high because your gas bill will reflect that. slow shouldn't matter but if it's dying while on idle it could either be your mass air flow sensor or your fuel filter being clogged

Mar 23, 2010 | 2004 Chrysler Sebring

1 Answer

2000 Chrysler Sebring LXi will turn over but not start. Is there a fuse that controls the fuel, if so where is it? Could it be the fuel pump?


There is a fuel pump relay in the main distribution fuse box under the hood,
But you didn't say whether you had spark or not,
Also you can eliminate the fuel pump by checking your fuel pressure at the reed valve under the hood.

Nov 18, 2009 | 2000 Chrysler Sebring

2 Answers

Change PCV on high idle engine RPMS Chrysler stratus/cirrus/brez


the pcv is under the intake manifold on backside if it is leaking it can cause a high idle but i would check th ecar over for vacuum leaks as this is common as well

Aug 29, 2009 | 1998 Chrysler Sebring

1 Answer

My idle is way to high on my 2004 chrysler sebring convertible 2.7 v6. i cleaned the throttle body but it still idles at 2 rpms. does this car have i.a.c. motor?? or does it have just an i.a.c. valve? i...


did u test for intake manifold leaks? did you disconnect the battery after the cleaning to reset idle speed control system? if u can find no leaks and system was reset then IAC may be sticking.

Apr 15, 2009 | 2004 Chrysler Sebring

1 Answer

Chyrsler sebring lxi 1995 2.5 v6 24 valve


ok this sounds easy when you ran the vehicle the computer controled the idiling motor now that you replace the idiling motor the computer hasnt been reset to except the new parameters
once you reset computer this should bring the idle back down to its specified idle
you can also adjust back of gas pedel the idle cable and on the throttle body by the idling screw

Jun 13, 2008 | 1995 Chrysler Sebring

1 Answer

Car stopping when slowing down


make sure the idle motor is conected

Jun 01, 2008 | 2000 Chrysler Sebring

Not finding what you are looking for?
2001 Chrysler Sebring Logo

Related Topics:

990 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...