Question about Oldsmobile Cutlass Ciera

1 Answer

Car stalling i have a 94 cutlass ciera and i will start is and then it wants to cut off. when i slowly and gradually give it gas it will stay on but shake violently until i am able to give it enough gas. then it will idle fine. any help. or could anyone tell me where the fuel filter is located

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 55 Answers

Sounds like mass air flow sensor on the intake system needs changing. check for vacuum leaks, make sure car has normal tune up done

Posted on Apr 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

'93 cutlass ciera 3.3 wont stay on after starting up


ignition module getting warm and cutting of or auto shutoff relay loosing power..

Jan 05, 2014 | 1993 Oldsmobile Cutlass Ciera

1 Answer

94' Cutlass Ciera S won't start after driving.


Have you checked for fault codes? do that first.

Jul 12, 2013 | Cars & Trucks

1 Answer

I have a 91 cutlass ciera that stalled yesterday. It now starts but wont stay running unless im gasing. If I let off the gas it cuts off. i can hear the exaughts sputtering a bit now wen im gasing also....


The only real way to solve any issues ,with any
product,is have it & perform some type of testing

When you ask a question you need to state if
you have automobile knowledge

I won't spend an hour typing all the possibilities of
what may be your cars issues

You will need a repair shop,as I assume you know,
even if someone lists a few probable causes.

May 26, 2011 | 1991 Oldsmobile Cutlass Ciera

2 Answers

94 Oldsmobile Cutlass Ciera- stalling issues.


Sounds crazy but, check for bad injector[s] Wadski

May 27, 2010 | 1994 Oldsmobile Cutlass Ciera

1 Answer

94 cutlass ciere wont start


check out fuel pump relay and oil sending unit for oil leak oil sender is made to cut out fuel pump apon oil pressure failing

Jun 30, 2009 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Electrical problems


It sounds like a short in the wiring harness somewhere, if I were you I would take it to a shop that specializes in auto electrical diagnosis look in the yellow pages to find, from here I can't really direct you on what to do besides tearing the interior apart and replacing the section of the harness that is acting up.

Jun 12, 2009 | 1994 Oldsmobile Cutlass Ciera

1 Answer

Car shakes


You need to bring the car to a repair shop and have them drain the tank if a sizeable amount of diesel was pumped into the tank.

Apr 23, 2009 | 1998 Oldsmobile Cutlass

1 Answer

95 Ciera Hesitates & stalls when warm


Change the IAC the idle air control. You may be able to clean it and put it back on.

Jan 07, 2009 | 1995 Oldsmobile Cutlass Ciera

1 Answer

94 Ciera stalls when first started unless I keep my foot on the gas.


Well, First, Check for any vacuum leaks, these will cause a low Idle due to a "lean" fuel/air mixture condition.

What is the engine size? If you have the V-6 take off the big air intake hose from the engine side, turn off the engine and block the throttle wide open with a tick or a brick. The plate inside the throttle body will be wide open , Use a good carberator cleaner and a stiff tooth brush to clean every partical of built up carbon from BOTH sides of the plate and also spray all around the throttle body inside where the plate is try to reach inside with the tooth brush as far as you can and scrub all carbon build up Spray down good with the carb cleaner. Take the block from the Throttle and replace the hose make sure there are no holes and the hose is properly installed and tight car will start hard be hard to start but it will start go easy on the gas after it starts and let it run a bit at idle
Let me know how it goes and if this information is helpful please give me a fixya! Rating
If you need any further help in this area please let me know email me at
fixincars@yahoo.co

Aug 26, 2008 | 1994 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

286 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...