Question about 2005 Nissan Altima

1 Answer

Service engine soon light came on...the diagnostic said that it's my speed sensor. where is that in an '05 altima 2.5s and can i buy it anywhere other then a dealership?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 22 Answers

VSS (Vehicle Speed Sensor)? Is its that then did your ABS light come one? You have 4 sensors, one per wheel located on the back side of the knuckle/spindle

Posted on Apr 27, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 nissan altima has low speed when acelerating


Hello
When the service engine soon light (Also called the check engine light) is turned on this is to alert you to the fact that powertrain control module (computer) has detected a failure somewhere in the systems it controls, there are fault codes set in the modules memory for these faults. What needs to happen now is to have the powertrain control module scanned with a special tool called an OBD2 electronic engine control scanner or a OBD2 code reader. Once the code(s) are read then you must perform the diagnostics for each code and make the appropriate repairs based on the findings of the diagnosis that was performed, this is called doing "Pinpoint" testing.

Jun 22, 2012 | Nissan Altima Cars & Trucks

1 Answer

I have a nissan altima 05 3.5L engine service light just came on and my scanner read these codes P0722 and p0717 p0462 and p0500 are these things i can fix on my own?


CODE PO462 FUEL TANK LEVEL SENSOR VOLTAGE LOW. CODE PO717 TURBINE SHAFT SPEED SPEED SENSOR NO SIGNAL. CODE PO722 OUTPUT SHAFT SPEED SENSOR NO SIGNAL. CODE PO500 VECHICLE SPEED SENSOR CIRCUIT MALFUNCTION. SOUND LIKE YOU HAVE TCM ECM PROBLEMS GETTING TOO MANY CODES. COULD HAVE LOOSE GROUND WIRE TO THE TCM AND ECM.

Aug 06, 2011 | 2005 Nissan Altima

1 Answer

My service engine soon light is on and it reads that the engine speed signal circuit is the problem, what should I do!


This is normally caused by the Crank Sensor. The Engine Speed signal is given by the Crank sensor, not the vehicle speed sensor. Most people get confused and replace the speed sensor instead.

So to resolve your problem you will need to replace the crank sensor. The engine speed sensor code is always related to the crank sensor failure.

Thanks Jay!

Jun 26, 2011 | 2006 Nissan Altima

2 Answers

2005 nissan almera,1.5letre.. fault code po725


P0725 NISSAN - Engine Speed Signal

The P0725 Codes is triggered when TCM does not receive the engine speed signal from ECM.

The Engine Control Module (ECM) monitors the engine speed through the Crankshaft Position (CKP) sensor with the engine running, and send signal to the Transmission Control Module (TCM).

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes:
- Open or shorted CKP sensor circuit condition
- Poor CKP sensor electrical connection
- Check communication error between the ECM and TCM
- Failed CKP Sensor

Possible solution:
Very common problem with Nissan vehicles, usually replacing the Crankshaft Position sensor takes care of the problem.

Keep us updated.

Feb 12, 2011 | 2005 Nissan Altima

1 Answer

Locating the engine speed sensor on an 05 altima


Its on the right front of the transaxle near the right axle flange.

Aug 02, 2009 | 2005 Nissan Altima

1 Answer

Replaced crankshaft sensor, car still won't start


A camshaft sensor can cause a no start situation, so can a bad coil, or ignition control modual. You need further testing done.
A speed sensor does not cause a no start, that I'm aware of.

Jul 14, 2009 | 1990 Oldsmobile Regency

1 Answer

2003 nissan altima 2.5s transmission rough shift


Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Sep 25, 2008 | 2003 Nissan Altima

Not finding what you are looking for?
2005 Nissan Altima Logo

476 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

80637 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...