Question about Volkswagen Polo

Open Question

Key light dash flashing

Key light flashing does not start

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: ignition locked; dash light of car outline with key inside flashs

Get the steering wheel to move even just a little bit and it will unlock.

Posted on Jan 12, 2009

cadman000
  • 607 Answers

SOURCE: it wont start turn key dash lights up nothing happens

sounds like a dead battery to start with. Not even enough juice in the battery to energize the solenoid / brake interlock to get it out of PARK. Hope this helps

Posted on May 05, 2009

SOURCE: won't start after cleaning battery terminals

Sounds like you have an aftermarket alarm with starter disable. By disconnecting the battery the alarm reset and the defualt setting is usually to set the alarm automatically (active arming). You have three options..
A. If you have the key fob that went with the alarm you can disarm the alarm.
B. If no key fob is available you can disconnect the battery again, turn the ignition key to the on position and reconnect the battery. This usually doesn't allow the alarm to set and allows the car to start.
C. Remove the aftermarket alarm system. This is usually the long term fix i recommend if the fob isn't available. Option B should get you going though.

Posted on May 09, 2009

  • 1348 Answers

SOURCE: Engine won't start. Dash lights flash rapidly when key turned.

the battery says 12 volts but may be dropping to 4 or 5 under a load...i would suggest jumpstarting the car and see what happens.the battery should read in the high 12 volts and not less than 9.5 under cranking. the dash lights go out on your car when starting,and the alarm will go off ,and disable the ignition if the voltage is too low in cranking the car because the computer will shut it down and activate the anti theft.....check your battery posts are tight. best of luck

Posted on Jul 22, 2009

dsakrison1
  • 65 Answers

SOURCE: having trouble starting my 2003 subaru wrx

The sensor is not in your key. It is in the Key Fob, unless your car is not equipped with keyless entry. If there is no key fob than your car is not equipped with vehicle immobilization.

Posted on Sep 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ive got a honda accord ,both keys are on the same key ring and if i put the key in the ignition the green key light kn the dash starts to flash, both keys do the same


What shape is the light? Where on the dash? Check your owners manual to see exactly which light on the dash that is. It may be an oil change lamp reminding you to have your regular service done. The dealer or a good Honda mechanic can reset that light after they change your oil.

Feb 12, 2015 | Honda Cars & Trucks

1 Answer

Millineum honda/franklin ave


anti theif problem. try un hooking battery for a few to reset computer

Sep 19, 2017 | 2003 Honda Civic

2 Answers

I drove the car to my mothers yesterday, went to my dads got there just finr. We went to leave and the car won't start turn over nothing. The security light is flashing. My dad could get it to start from...


you need to get a new ign. lock cylinder and chip key. Or you can get a lock cylinder and copy your old key with a regular key no chip. Take new cylinder, put old chip key in it. Plug into harness at the bottom of steering column just behind the dash, fine orange wire from existing one in the column. Hide lock cylinder under dash and start car with copy of old key.

Dec 26, 2010 | 1991 Buick Park Avenue

1 Answer

Starter turns but no ignition, PK3 M security, the problem is intermittent and does not cause a problem with every start. So far I have been able to get it started after several attempts with differing...


is your security light in dash flashing if so try to start let off key but do not cut off leave key on so all your dash lights are on let vehicle set for at least 15 mins. flashing security light should stop flashing once it stops flashing start vehicle sounds like it has tripped security

Mar 16, 2010 | 2002 Pontiac Grand Prix

1 Answer

Maintence light flashing 7-8 times ? 92k


IT IS A MILEAGE LIGHT WITH THE KEY OFF HOLD THE SELECT RESET BUTTON ON DASH AT THE SAME TIME TURN KEY ON THE LIGHT WILL FLASH ONE TIME KEEP HOLDING THE BUTTON WHEN THE LIGHT GOES OFF TURN KEY OFF THEN START CAR LIGHT SHOULD GO OFF AFTER A COUPLE OF SECONDS AND SHOULD BE RESET

Dec 20, 2009 | 2002 Honda Accord

1 Answer

No keys


If you want to initiate a new master key.... 1. Insert new key into ignition cylinder and turn it to the ON (RUN) position. The security light on the dash will flash for fifteen minutes.
2. When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder OFF and then back to the ON (RUN) position. The security light on the dash will flash for fifteen more minutes.
3. When the security light stops flashing, you have FIVE minutes to start the next step. Turn the ignition cylinder to OFF and then back ON (RUN) position. The dash will flash for fifteen more minutes.
4. After the security light stops flashing the third time, the new key has been programmed into the vehicles computer and will operate the car. It has replaced ALL the previous electronic key codes and is the ONLY key programmed into the vehicles computer.

The dealership should be able to do this for you without a current key, of course this means towing the vehicle to them. See if they will sell you a key and you program it yourself.

hope this helps. I found the above info at FordF150.net

Jun 22, 2009 | 1998 Ford Contour

1 Answer

Car won't start, but light and dash light come in a 2003 grand am


Turn key on , let security light flash for fifteen minutes. Take key out and press reset button and put key back in and start car

May 07, 2009 | Pontiac Grand Am Cars & Trucks

3 Answers

Key Does Not Work


It could be that chip inside key just went bad. Do u have a 3rd key? That works? If so take the 2 good keys and turn the igntion to run postion for 3 secs each then do the same for the 3rd key and this will reprogram it if the chip is ok. If you do not have 2 good keys then u will have to have a scan tool that will link up with PATS system and perform security access to reprogram it.

Feb 12, 2009 | 2005 Ford Taurus

1 Answer

Keyless entry keylob want lock or unlock doors or trunk.change battery and checked all fuses.


You need to program the remote. Get in to the car and LOCK all doors with the switch on drivers side door. Take the key and insert it into the ignition cylinder in and out 6-10 times, until the flashers/hazards flash on your dash board. Or just keep putting the key in and out (nice and easy now, not fast) until you see the lights on dash flash. After the lights flash, turn the key into ACC mode to make the whole dash light up.(do not start car) .With the key in ACC position, hit any button on remote, that will make the hazards flash again. Turn key off and unlock door with switch again. Open door.DONE.
Good luck.

Jul 15, 2008 | 2001 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...