Question about GMC Envoy

Open Question

2003 GMC Envoy- Vibration under gas pedal while accelerating at any speed

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: How to replace the headlights on my 2003 GMC envoy.

The headlights on the envoy are the easiest parts of the car to repair. You just pull the two tabs at the top of the headlights, screw out the bulb containers and you are good to go

Posted on Nov 15, 2008

  • 2 Answers

SOURCE: Is there another fuse box on the 2003 GMC Envoy

There is one under the passenger seat driver side. Flip up the seat and lift off the cover.

Posted on Mar 20, 2009

  • 1 Answer

SOURCE: Vibration when I accelerate in my 2003 Audi A4 1.8T

if car shakes whilst acelerating and goes off when you let you foot off throttle then could well be a drive shaft cv joint

Posted on May 04, 2009

  • 179 Answers

SOURCE: 2003 GMC Envoy stalling w/ AC on when stopping

try turning up the idle ajustment screw also have alternator checked, another solution would be to have your car tuned up weak spark from your coil worn plugs wires etc. not enough power is being produced

Posted on May 31, 2009

Onifade
  • 268 Answers

SOURCE: vibrates when gas pedal pressed.

1. Check the ball-joint.

2. Check the Tye-rods.

3. Your shock absorbers/ struts.

4. Wheel balancing and alignment.

Good luck.

Posted on Dec 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why gmc envoy 4.2 has no acceleration when gas pedal pressed?


try to clean the TB. if that does not work it might be the 02 sensor

Aug 15, 2014 | 2003 GMC Envoy

1 Answer

Vibration in engine area felt in gas pedal


Almost sounds like maybe a motor mount issue.

Nov 30, 2013 | 2003 Ford Taurus

1 Answer

2005 GMC ENVOY 4.2L VIBRATION PROBLEM AT IDLE AND START UP OR ANY TIME NO ACCELERATING


Hello! This is a known problem that is addressed by the following Technical Service Bulletin...Guru...saailer

Subject:Steering System Moan, Groan, Shudder and/or Vibration Type Noise During Low Speed Turning Maneuvers (Replace Steering Gear) #04-02-32-007A - (12/01/2004) Models:2004-2005 Buick Rainier
2003-2005 Chevrolet TrailBlazer, TrailBlazer EXT
2003-2005 GMC Envoy, Envoy XL
2004-2005 GMC Envoy XUV
2003-2004 Oldsmobile Bravada
Short Wheelbase Utilities Built Prior to VIN Breakpoint 52123375
Long Wheelbase Utilities Built Prior to VIN Breakpoint 56137280
This bulletin is being revised to remove the 2002 model year and add the long wheelbase utilities. Please discard Corporate Bulletin Number 04-02-32-007 (Section 02 -- Steering).

ConditionSome customers may comment on a moan, groan, shudder and/or vibration noise while making low speed turning maneuvers. Customers usually notice this condition in parking lot turning maneuvers.
Correction
  1. Diagnose the power steering concern. Refer to Symptoms - Power Steering System (SI Document ID #670351).
  2. Replace the steering gear with a newly designed steering gear. See the parts information below. Refer to Power Steering Gear Replacement (SI Document ID #742314).
Parts Information

Part Number

Description

Qty
88965356
Gear Kit, Steering
(Short Wheelbase Utilities)
1
88967181
Gear Kit, Steering
(Long Wheelbase Utilities)
1
Warranty InformationFor vehicles repaired under warranty, use:

Labor Operation

Description

Labor Time
E9740
Gear Assembly, Power Steering - Replace
Use published labor operation time
E2000
Toe, Front - Adjust

May 03, 2012 | GMC Envoy XL Cars & Trucks

1 Answer

My 2003 gmc envoy says change oil and i just had oil changed what do i need to do


The Change Oil reminder needs to be reset. This done as follows;
1. Turn key to RUN position, do not start engine
2. Fully depress and release the accelerator pedal three times within 5 seconds
3. Turn key to LOCK position.

Oct 04, 2011 | 2003 GMC Envoy

2 Answers

SUV unintentionally accelerating


YOUR VEHICLE IS NOT SAFE TO OPERATE:

Contact your local GMC Dealer.

We have pulled the recall data for your vehicle and no one has reported this problem.



Hope this tip helps.

r/
David

Feb 26, 2010 | 2003 GMC Envoy

1 Answer

Vibration


possible engine misfire. get engine codes checked free at Autozone

Dec 06, 2009 | 2002 GMC Envoy

2 Answers

Rough Idle while stopped and low speeds


heve utried adjusting the trottle , just put your foot on the accelerater and hold at just under 1000 revs if shaking goes then thats your problem should idle at just under 1000rpm

Oct 10, 2009 | 2003 GMC Envoy Xl

1 Answer

The reduced engine power light came on my 2003 GMC Envoy, and it completely lost Thrust (The maximum speed now is 10mph) can someone tell what needs to be done?


If you live near an Autozone, they can diagnose your code for free. This is gm's attempt to protect the engine from worse damage by limiting the power output of the motor...
it could be major, could be as minor as a gas pedal sensor...
get the code..

Jun 09, 2009 | 2004 GMC Envoy

1 Answer

Where is the brake/park islinode on a 2003 envoy by gmc


under the driver's side dash near the upper part of the brake pedal. You'll have to lay on your back under the dash to see it. You might hear it " click" when the brake pedal is depressed.

Mar 29, 2009 | 2003 GMC Envoy

1 Answer

Vibration on the floor underneath gas pedal


I would venture to say your exhaust is hitting your frame, or, you may need new motor mounts. The exhaust is what I would lean toward. If you can imagine your exhaust sitting under your vehicle, and the fact that the vehicle has a little age, the motor mounts probably give a little, causing the motor to move slightly on acceleration and deceleration, thus your exhaust is going to move, and may be vibrating on whatever its touching. Good luck.

Feb 25, 2009 | 2003 Volvo S60

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...