Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
No, should have enough room to slide it out ,if not disconnect the engine mounts and jack up or lift up the engine just enough to slide the pan.
Posted on Nov 02, 2009
Things to check
Remove the spark plugs and read them, they should all have a dry tip and be clean from any carbon, oil or fuel.
Usually if burning fuel properly they will have a brown or whitish looking tint from burned carbon.
If any of the plugs look wet or black or dirty looking different from the others the problem is with that cylinder, change all the plugs and see if that helps, the next lease expensive thing is replacing the plug wires.If your fouling plugs ask your parts store for 1 number hotter plug ( heat range)
Open the hood at night with the engine running and see if you find any blue looking arcing around or in the wires, if so replace the wires.
If all above looks good your fuel injectors might be dirty or one might not be working. You could try an injector cleaner mixed in with your gas
A rough idle comes from one or more cylinders not firing as hard as the others or not at all, there are so many causes for this so you have to troubleshoot with the lease expensive fix first.
Another thing is water in the gas, you can pour plain ole rubbing alcohol in your gas tank if you suspect water in your gas. alcohol mixes with the water and makes it burn instead of mis firing.
One more thing that can cause rough idle is your valves, this requires a compression check on each cylinder. If one cylinder has less compression than the rest remove the compression tester and squirt some engine oil in the cylinder then re test, if the compression increases it is bad rings or a bad cylinder bore, if not it is a valve problem.
Oil seals around the piston increasing the compression temporarily while testing but makes no difference in testing if the valves are leaking.
Good Luck,... troubleshooting and patience, or a good mechanic is the solution if you are working with neither
Posted on Mar 01, 2010
it does due to the sump gasket at the bottom but if you can carefully slide a cutter under the cover when all the bolts are out you may be lucky enough to not damage the gasket. if you do damage the sump gasket cut it back flush with the engine and apply a sealer like THREE BOND to the area to create a new liquid gasket. to do it correctly remove the sump
Posted on Jun 22, 2010
Tips for a great answer:
May 01, 2015 | Nissan XTrail Cars & Trucks
Nov 25, 2014 | 2005 Nissan Primera 2.0
Oct 01, 2014 | Nissan XTrail Cars & Trucks
Nov 08, 2013 | Nissan Altima Cars & Trucks
Apr 09, 2013 | Cars & Trucks
Feb 21, 2013 | Cars & Trucks
alancer unit mounting bolts tightening sequence shown-2.5L engine
Balancer timing chain alignment marks-2.5L engine
Nov 17, 2010 | 2003 Nissan Sentra
Sep 20, 2017 | Honda Cars & Trucks
36 people viewed this question
Usually answered in minutes!