Question about 2005 Nissan Murano

Open Question

How to install oring in 2005 nissan murano oil filter housing

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: nissan murano 2005 sl keyless entry remote programing

Close all vehicle doors, LOCK doors using drivers side switch.

Insert key all the way into the ignition, (do not turn) remove key.

Repeat this step 5 times. (6 total)

Hazards should flash to indicate program mode.

Press any button on transmitter to be programmed, hazards should flash to indicate successfull program.

*For additional remotes, cycle drivers door lock UNLOCK, LOCK, press any button on remote, hazards should flash. Repeat step as necessary.

Ignition ON, (engine off) ignition OFF, UNLOCK using drivers side switch, test remotes.

Source

Posted on Aug 06, 2008

Ad
jschoon77
  • 55 Answers

SOURCE: Location of oil filter on Nissan Altima 2005

The oil filter is located behind the right (passenger) inner fender cover. It is right next to the crankshaft pulley at the bottom of the front of the engine facing toward the right front wheel. I do not have a picture at this time.

Hope this is helpful!


Nissan Scope Technician- 10+ years experience in Nissan dealership.

Posted on Nov 04, 2008

  • 1 Answer

SOURCE: 2005 nissan murano sl, with rattling sound when accelerating

I recently experienced the same symptom with my '05 Murano and it was not a fuel problem. The dealer listed the cause as dry axle splines and replaced both front drive shaft assy's. Note that this was done as warranty with no cost incurred by me.

Posted on Jun 18, 2009

  • 3 Answers

SOURCE: Replace rear wiper on 2005 Murano

You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.

The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:

88b7c7f.jpg

moz-screenshot-61.jpg9b7da18.jpg








Posted on Jun 29, 2009

  • 40 Answers

SOURCE: how do i reset my check engine soon light 2005

you can buy a code reader from an auto parts store that will give you the ability to reset the check engine light, or most parts stores have one that they use on customers cars at no charge. if you ask them to read which code your car is throwing, most of them will let you hit the button to clear the code. they aren't supposed to do it themselves for some reason, but from my experience they will let you.

Posted on Oct 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel filter on Nissan Murano 2005


Hi Firad, IM AL the owner of Big As Auto Repair.

The fuel filter is inside the gas tank mounted to the end of the fuel pump. Hope this helps and please visit my auto-repair-website here: http://www.bigasautorepair.com/

Feb 22, 2017 | 2005 Nissan Murano

2 Answers

Nissan murano rattling noise front


Nissan had a problem with the exhaust bracket being cracked or broken

Mar 18, 2014 | 2005 Nissan Murano

1 Answer

Oil leak on drivers side 2005 saturn ion ,just had oil change last week


if you look at the front of the engine from the top there is a plastic cover with a 1 1/4'' bolt head that is the oil filter housing the cover has a oring seal on it at times the oring gets torn when installed

Jun 22, 2012 | 2005 Saturn ION

1 Answer

Looks like a oil leak behind the oil filter . Is it a oring ?


could be the oil cooler leaking. its located behind the oil filter.

Apr 03, 2011 | 2005 Nissan Maxima

1 Answer

I HAVE A 2003 MURANO WITH 145,000 MILES. AN OIL LEAK IS JUST STARTING NEAR THE OIL FILTER AREA. IS THE OIL PRESSURE SWITCH THE CAUSE? IF SO WEAR IS IT LOCATED ON THIS 3.5 ENGINE?


Theres no way to know if the oil pressure switch is the cause, you are there to look at it, I'm not. But I would check real close the OIL COOLER. Its the housing between the oil filter and the block. There is a seal (o ring) between that housing and the engine block and I would suspect that seal leaking. Get it from the dealer, its cheap. Part number B1304-34U00

Nov 12, 2010 | 2004 Nissan Murano

1 Answer

How much motor oil do I need to replace when I do an oil and filter change?


2005 murano 3.5 engine
Drain /refill 4.0 litres including filter

May 14, 2010 | 2005 Nissan Murano

2 Answers

Is liking oil from the oil filter assembly


Check to make sure the filter is tight. If it is, remove the filter and chekc to make sure there is not "another" filter o-ring on the bottom of the filter housing. It's not all that common for oil change shops to miss a filter o-ring stuck to the housing, but it can happen, and yes, I have done it myself.

Dec 10, 2009 | 2004 Nissan Murano

1 Answer

Nissan Murano 2005, the car is suddenly dead when i was waiting for trffic right, but the air conditoner was still running. I can restart the enginee, but it will die again if i don't pump the gas. Does...


Check the airbox and make sure all hoses are tightly pushed together around it. More than likely the air filter was checked and one of the hoses came loose.

Jul 07, 2009 | 2005 Nissan Murano

2 Answers

2004 Murano has an oil leak near the oil filter mounting backet.


The oil filter mounts on an oil cooler housing that has an o-ring on the block side of it. The housing is held in place by the double ended connector bolt that the oil filter screws onto one side and the other goes into the block. This should be tighten to 37 ft/lbs. prior to installation of the oil filter. It may be loose or the o-ring might need replacement.

Mar 08, 2009 | 2005 Nissan Murano

1 Answer

Probable cause of oil leak upper portion of oil filter


What upper portion are you talking about? Between housing and engine block? or where filter screws onto filter housing? If its where filter screws on sometimes when you chg. filter and you don't watch what your doing the old rubber Oring will stick on housing and you spin on new filter and it will leak because it will not seal because of the old Oring. Now if its comming from between the housing and block you will have to remove the housing and install a new gasget between engine block and filter housing.

Feb 24, 2009 | 1995 Mazda 626

Not finding what you are looking for?
2005 Nissan Murano Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...