Question about Hyundai Cars & Trucks

1 Answer

Door ajar sensor

Location to dissconnect

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 198 Answers

Remove the screw holding it to pillar, remove switch and disconnect

Posted on Oct 19, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 58 Answers

SOURCE: 95 ford windstar door ajar

These switches are inside the doors attached to the door latch assembles.If you know some one with a scan tool you can go into the body computer and see which one is showing open when all the doors are closed. The most likly one is the drivers side door or the two in the rear gate. I've replaced those the most.If you don't want to replace them you can unplug them and the lights will go off. Hope this helps. If you need more info let me know> Thanks Dan

Posted on Jul 15, 2008

  • 1 Answer

SOURCE: door ajar light stays on

I have the same problem with my passenger door all the time. The dealer was nice and didn't charge me for some advice. Find out which door it is or do this to all. It is the part on the door the grabs the round thing in the door jam. It looks like two fingers kinda. Spray with WD-40 and clean with a rag to get all the dirt out of there. Spray again and open and close the door several times. This clears my problem and I hope this helps you too.

Posted on Jul 30, 2008

mas66
  • 104 Answers

SOURCE: DOOR AJAR LIGHT (bad sensor?)

I'm pretty sure that they are integral to the door lock assembly on that model, would need to replace the whole door lock if that is the case. Best to get the Ford dealer to plug in their computer and check the signals from the door locks to see which one is at fault. Check central locking and power mirror fuses first, if no power to door locks then the door ajar sensors will have no power as well.

Posted on Oct 25, 2008

  • 1 Answer

SOURCE: 97 Lincoln Contiental Drivers door ajar message

It is a sticky sensor in the door latch mechanism. Spray it w/ WD-40 and follow up with a dose of silicone spray. Open/close doors several times and it should be ok. If you have a problem with 1 door the other 3 are sure to follow---DO THIS TO ALL 4 DOORS!!!!!!!!!

Posted on Dec 22, 2008

ftw1952
  • 10319 Answers

SOURCE: Where are the door sensors

inner door latch assemblies hold these sensors

Posted on May 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2002 lincoln towncar door ajar light s stay on after minor accident. Only goes off when in drive. Can't find the fuse. I have to disconnect the battery


You have one or more door ajar sensor switches that are defective, have the BCM (Body control module) scanned to see which door is causing it, the light can be turned on by any of the 4 doors. The sensor is located inside the door on the door latch mechanism, there is no fuse as it is a ground circuit.

Oct 21, 2016 | 2002 Lincoln Town Car

1 Answer

The door ajar indicator light on the dash stays on, is there a sensor? where do I find it?


There is a door ajar switch , an it is dependent on make model an year vehicle as to it's location ! Most usually it is located in the door latch assembly, which means you must take the door panel off .

Sep 01, 2015 | Cars & Trucks

1 Answer

1996 ford explorer door ajar chime goes on and door locks constantly open What's wrong


Door ajar sensors on explorers get disconnected, sometimes the magnets get stuck. Spray WD40 or a lubricant on all four door jamb mechanisms (or two). Sometimes only one fails, and it is usually the tail gate one. Do a google.com search for the location of the sensors and see if they need replacement.

Good luck.

Mar 03, 2015 | 1996 Ford Explorer

1 Answer

Where can the door ajar sensor be found on 2006 Chevrolet Silverado 1500


on the newer model Chevrolet pickups the door ajar sensor is located inside the actuator mechanism on the door latch itself

Nov 26, 2014 | Cars & Trucks

1 Answer

Dome light stays on. Always says theres a door ajar.


The sensors are in the latch assembly. Try opening the doors and spraying the latches with WD-40 that will usually fix it.

Dec 18, 2009 | 1998 Ford Taurus

1 Answer

Door ajar dash trouble and dome light stays on even if all doors


The door sensors will need to be replaced. A screws can be removed and then a wire can be taken of and you then can replace the switch.

Sep 25, 2009 | 2001 Ford F250 Super Duty Super Cab

3 Answers

Door ajar light on, 1996 aerostar, where are the sensors located?


the door ajar sensor is located on the door latch assembly, u must detrim the door and then remove the rear most window guide rail, it twists into the latch at rear of latch, it is very small and a real pain to change.

Aug 27, 2009 | 1996 Ford Aerostar Extended

1 Answer

Door ajar stays on usually when it rains


Try opening and closing all four doors one at a time to determine which door ajar sensor has failed. Probably driver door. Sensor is located in door latch assembly and is a challenge for first timers. This is a common problem with these vehicles.

Mar 29, 2009 | 1999 Ford Expedition

1 Answer

Backup lights in Ford Exp 2002 will not come on


on the side of tranny where shift cable connects is the transmission range sensor or also called the MLP,this sensor could be the cause of no backup lights.
the door ajar switches are located in the door latchs.door ajar switches stick alot,spray WD-40 into all door latches,then open and close doors several times,if switch is only sticking this will cure problem.

Nov 13, 2008 | 2002 Ford Explorer

1 Answer

DOOR AJAR LIGHT (bad sensor?)


I'm pretty sure that they are integral to the door lock assembly on that model, would need to replace the whole door lock if that is the case. Best to get the Ford dealer to plug in their computer and check the signals from the door locks to see which one is at fault. Check central locking and power mirror fuses first, if no power to door locks then the door ajar sensors will have no power as well.

Oct 25, 2008 | 2003 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

37 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...