Question about Cars & Trucks

1 Answer

I have a ford falcon AU series one 6 cylinder wagon. It takes ages to get it started but when I does it will idle, but idles rough. When I accelerate it dies. I have changed the injectors, fuel filter, crank angle censor, airflow censor, have blown the lines out and still nothing. Please help?!!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 42,022 Answers

Run the fault codes as what you have done may only be by passing the real faulty sensor. Check the cat converter for failure and blocking the exhaust system

Posted on Oct 13, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 14 Answers

SOURCE: 1992 gmc chevy 350 wont idle when warm

This could be a number of things but i think that your problem sounds like a vacuum leak or an EGR problem. Try listening for leaks and try un-plugging the EGR solenoid valve one time.

Posted on Apr 17, 2009

  • 77 Answers

SOURCE: 1996 Honda Accord Rough Idle Even After tune up

Perform a valve clearance inspection and adjust if necessary. Tight or sticking valves will cause a misfire or rough running concern. Note: Perform valve adjustment when the engine is stone cold. 4cyl: INT 0.26mm EXH: 0.30mm (V6 engine are hydraulic and no adjust necessary.) Also check for a sticking or stuck open EGR valve. For diagnostic purposes only: Remove the EGR valve. Place a business card over the EGR passage and bolt the EGR valve back on. This plugs the EGR ports and if the misfire goes away the EGR valve is partially stuck open and is defective.
Check for low fuel pressure. Check for low compression. Check cam timing. Check for a weak ignition coil. Also don't over look the possibility of worn or broken engine mounts which cause excessive engine movement and engine vibration. -hope this helps

Posted on Mar 05, 2010

GARYca
  • 672 Answers

SOURCE: 2003 Ford Expd. running rough @ idle -

There could be many issues. These codes read your engine is running too lean. Check : all your vacuum hoses for leaks, PCV valve and hose, MAF sensor. This may require an experienced technician to figure this out. Hopefully I help'd!!

Posted on Apr 05, 2010

  • 540 Answers

SOURCE: 97 chevy pu 305 vortec, had cyl 6 misfire and

thats usually a sign of a vacuum leak, recheck and make sure you don't have any loose hoses, or cut intake seals

Posted on Nov 12, 2010

SOURCE: Ford F150 engine backfiring, running/idling rough

I Have a 1999 ford f150 4.6 that back fires and is just running really ruff when idling alot of nack fire a sord of like a pulse going on what is my problem?

Posted on Oct 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Falcon seems to take a while to start and I have to press the accelerator as well or it will stall, whats the deal?


My 2004 BA Falcon won't start. Apparently it's low - Fixya

www.fixya.com/cars/t12343045-2004_ba_falcon_start_apparently_s_low
Apr 8, 2012 - Apparently it's low on - Ford 2005 Falcon 4.0 question. ... Ba engine generally is strong, common fault is ecu, if hard starting when cold, pour hot water on computer and it ... If the headlights do not dim or go out, then the battery is likely ok..... Automatic 2004 BA Falcon stalls while driving ... Open Questions:.

My xr6 won't start. Comes up saying immobilized. - Fixya

www.fixya.com/.../t12430461-xr6_start_comes_up_saying_immobilized
Feb 6, 2012 - My xr6 won't start. ... Question about 2005 Ford Falcon 4.0 ... you will get airbag errors popping up for a few weeks then after a while it .... in a while it willstart and run for about 20 seconds, then it dies and won't start. ... Open Questions: ...You may NOT copy or distribute the content that appears on this site ...

Ford falcon sometimes won't start - Ford - Automotive - Whirlpool ...

forums.whirlpool.net.au > Automotive > Ford

WhirlpoolOct 26, 2010 - I have a EF Falcon that has an intermittent problem with starting. ... It might take a minute or 5 minutes or persistent retrying. ... Normally if you wiggle the T-Bar around it will then start. ... motor with a rebuilt unit, I had a remove starter on myalarm, and would use the remote start while using my jack-handle to ... Worst Car You Ever Owned
Jun 1, 2012
LPG conversion problems with stalling - Ford
Jan 16, 2012
More results from forums.whirlpool.net.au

2006 Ford Explorer Engine Stalls While Idling: 24 Complaints

www.carcomplaints.com/Ford/Explorer/.../engine_stalls_while_idling.sht...

Jan 27, 2016 | 2005 Ford Falcon 4.0

1 Answer

Idles rough then takes off good


The emittion of black smoke on start-up is an indication that the fuel mixture is rich, (there's too much fuel going into the engine for the amout of air present in the engine), this could be because the fuel in one of the cylinders is not being ignited (burnt) by the spark plug,or one of the sensors is giving a false reading.

Oct 11, 2012 | 1984 Ford F 150

2 Answers

I have 1999Chevy suburban with 6.5 turbo diesel motor.it idles up and down and when driving the gas pedal is real touchy Wat is the problem and were do i locate the problem


Check the help links related to this problem.Click the link below to go through its troubleshooting procedure :-----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html---------
Car won't start without hitting the gas pedal? http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
-------Complete loss of brake pedal then all gets normal? http://repairhelpcenter.blogspot.com/2012/01/complete-loss-of-brake-pedal-then-all.html
------Car dies when gas pedal is pressed? http://schematicsdiagram.blogspot.com/2011/12/car-dies-when-gas-pedal-is-pressed.html
--------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down?

http://technoanswers.blogspot.in/2012/02/pushing-on-gas-pedal-but-car-slows-down.html

---------

After replacing brake rotors and pads, brake pedal remains on floor? http://technoanswers.blogspot.in/2012/02/after-replacing-brake-rotors-and-pads.html

---------

accelerator pedal sensor? http://technoanswers.blogspot.in/2012/02/2009-chevy-impala-accelerator-pedal.html

-------

For rough idle issues and problem troubleshooting,go through the help links provided below :----- van idles rough?

http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html

---------
will not idle when cold?

http://technoanswers.blogspot.in/2012/02/ford-explorer-40-will-not-idle-when.html

----------
runs lean and idles rough?

http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html

-----------
Engine stumbles coming off idle when warm?

http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html

------------
Erratic idle on car?

http://schematicsdiagram.blogspot.com/2011/12/erratic-idle-on-car.html

----------
Low idle when cold out side?

http://repairhelpcenter.blogspot.com/2011/12/low-idle-when-cold-out-side.html

---------
Idle Air Control (IAC) Valve Replacing?

http://schematicsdiagram.blogspot.com/2011/12/gmc-idle-air-control-iac-valve.html

----------
Engine quits at idle?

http://repairhelpcenter.blogspot.com/2011/10/engine-quits-at-idle.html

------------
Car overheats and Air blows hot at idle?

http://howtobyme.blogspot.com/2011/11/car-overheats-and-air-blows-hot-at-idle.html

------
While stop engine idles like cylinder missing?

http://schematicsdiagram.blogspot.com/2012/01/while-stop-engine-idles-like-cylinder.html

---------

This will help.

Thanks.

Mar 01, 2012 | 1999 GMC Suburban

3 Answers

2003 cadillac cts 3.2 liter..rough idle, scan tool shows misfire on bank 1, cylinders 1,3,&5. only at idle, scan tool also showed a cam postion sensor code. cam position sensor changed. no change in...


Did you ever find a solution to this? I am having the same issue on 2,4,6. I have replaced the coils. checked the intake for vacuum leaks. I am lost here let me know if you find anything and I will do the same.

Jan 08, 2011 | 2003 Cadillac CTS

1 Answer

How to adjust idle on ford falcon el 6 cylinder


wam the car up, disconnect the idle speed control valve wiring plug (idle control valve sits on top of the throttle body) then set the idle to 700rpm with the grub screw stop just above where the throttle cable fits to the throttle body. Reconnect theidle control valve and you're done. It may take a few k's driving for the ECU to relearn the new throttle stop position. The idle speed control valve is only used by the ECU to add idle speed when extra load is put onto the engine such as power steering or air con use, the base idle is set mechanically on the old falconns.

Oct 04, 2009 | 1983 Ford Fairmont

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...