Question about 2002 Buick Regal
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
the answer here is the forward clutch pack is worn out, in order to replace this umust overhaul the trans.
Posted on May 28, 2009
check sensor on reservoir. Unplug connector to sensor to see if light goes out. If yes, replace sensor. If no, wire may be shorted.
Posted on Oct 02, 2010
SOURCE: can a resister make my
You are correct.Yes the resistor can make car to no start condition.Because this resistor is for fuel pump.And there are many others having same problem,this resistor needs to be replaced.It will be replaced by the dealer.Failure of the Fuel Pump Resistor will prevent the vehicle from starting.Occasional problems with this vehicle are failures of the Fuel Pump Resistor, 3.8L VIN 1 Supercharged Engine only. The cost to repair the Fuel Pump Resistor is estimated at $39.47 for parts and $19.50 for labor at garage. develop an electrical open in the fuel pump resistor. This condition prevents operation of the fuel pump and the engine will not run. Correction Dealers are to install a new resistor on the plenum with an aesthetic cover. Vehicles Involved Involved are all 1997-1998 Buick Regal GS and Pontiac Grand Prix GTP model vehicles equipped with 3.8L engines and built within these VIN breakpoints:--------------- The following are instructions for removing the fuel pump resistor from its original mounting location on the lower right front body rail as shown in Figure 1, and replacing it with a new fuel pump resistor and cover in new location shown in Figure 2. The new location is on the front of dash sheet metal (3) at the rear of the engine compartment, inboard or to the left of the alternator (4). The passenger or right side windshield wiper arm (5) and stop (6) are called out for reference purposed only. 1. Turn the steering wheel to the full right position. 2. Open the hood and disconnect the negative battery cable. 3. Remove the diagonal brace (1) from over the windshield washer solvent reservoir by removing the two bolts (2) that attach it to the radiator support and the one bolt (3) that attaches it to the strut tower. Refer to Figure 3. ----------------- If you want exact location and exact procedure,for how to replace the resistor.Please click on this link.:---- http://technoanswers.blogspot.com/2011/02/fuel-pump-resistor-for-1997-1998-buick.html ---------------- This will help you.Thanks.Helpmech,.
Posted on Feb 01, 2011
Tips for a great answer:
Sep 20, 2012 | 1998 Buick Regal
Sep 13, 2011 | 1994 Buick Regal Gran Sport
Sep 20, 2010 | 1998 Buick Regal
Jan 25, 2010 | 1998 Buick Regal
Nov 28, 2009 | 1998 Buick Regal
May 28, 2009 | 1998 Buick Regal
136 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: