Question about 2003 Ford Focus

2 Answers

Electric window hi can anyone help please i have ford focus 53 plate , the electric window on passenger side wont open or shut carnt work it on driver side controls either .....can anyone help me please

Posted by on

  • d_clanga Apr 23, 2009

    thankyou ill try this solution 2moro

  • d_clanga Apr 23, 2009

    thankyou ill try this b4 i go buy a motor

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 76,846 Answers

Most likely the electric motor that raises and lowers the window is defective, u will need to remove the door panel and replace the window motor, about a 2 hour job and $100 in parts.

Posted on Apr 23, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 57 Answers

What you need to do is take the control loose so you can see the wires .Make sure they are plugged in, if they are run a wire from the control wire to the battery this will tell you if your motor is working or not,if the motor works and the window comes up then the wiring is where your problem is.If not then you need to replace the motor

Posted on Apr 23, 2009

  • marykitty63 Apr 23, 2009

    what you need to do is take the control loose so you can see the wires .Make sure they are plugged in, if they are run a wire from the control wire to the battery this will tell you if your motor is working or not,if the motor works and the window comes up then the wiring is where your problem is.If not then you need to replace the motor

  • marykitty63 Apr 23, 2009

    what you need to do is take the control loose so you can see the wires .Make sure they are plugged in, if they are run a wire from the control wire to the battery this will tell you if your motor is working or not,if the motor works and the window comes up then the wiring is where your problem is.If not then you need to replace the motor

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Both of the electric windows have stopped working on my 2 door ford focus


Try spraying some electrical contact cleaner into all of the switches on the main controll on the drivers door. With the vehicle running ignition on . It s likely just a bad connection water gets in between the window glass and the switches . If that dosn't work remove the main switch and clean the contacts and it will work again.

Mar 11, 2012 | Ford Focus Cars & Trucks

2 Answers

This maybe a dumb question but can anyone help me by telling me were it is i can find the computer on a 2001 ford focus please and thank you


Hi, the PCM is hid inside the car behind the kick panel on the passenger's side.

Removal & Installation
  1. Disconnect the battery ground cable.
  2. Remove the instrument panel side trim strip.
  3. Remove the cowl side trim panel (kick panel).
  4. Remove the glove box.
  5. Remove the passenger side lower foot well trim panel.
  6. Remove the two retaining nuts.
  7. Remove the generic electronic module (GEM0 and the bracket and position aside.
  8. Disconnect the 3 powertrain control (PCM) module electrical connectors and remove the PCM.
  9. Installation is the reverse of the remove procedure.
    CAUTION Make sure that the PCM electrical connectors do not unlock when installing the GEM module.
jturcotte_2152.gif

Aug 29, 2011 | 2001 Ford Focus

1 Answer

Ford focus 53 plate central locking not working. The lock system will lock with the remote controle but unlock in the same cycle. The passenger internal door lock will not lock from the inside, but the...


sounds like the passanger door lock mechanism has gone down mate have this replaced and this should sort your problem out

let me know if this helps
cheers

Feb 04, 2011 | Ford Focus Cars & Trucks

2 Answers

Passenger window does not work


You can get a wiring diagram and tests light and test the circuits. Or just change the switchs the problem could be in a either switch. Also with the doors opened wiggle the wires going from the doors to the body while pushing on the switch. You may have a broken wire in this area or bad connection. Hope it works out.

Jun 04, 2010 | 2000 Ford Focus

1 Answer

Is there more than 1 fuse box on a 53 plate focus? I can't find the ancillary socket fuse


hi yes there are 2 there is one in the engine bay and one that has the fuse you are looking for on the passenger side under the dash, the fuse number is F79 and it is a 15amp...hope this helps

May 31, 2010 | 2003 Ford Focus

1 Answer

Electric windows


you have a bad master window control.that the switchs on drivers door, good luck.

Oct 09, 2009 | Ford Escort Cars & Trucks

1 Answer

Window one operate but can operate passenger side from driver


Ford was notorious for bad switches on the drivers window control panel. But before you replace it pull the whole inner door panel off. You will have to unplug the switch panel to do it... check the connections on the window motor itself, then check and clean the connector that plugs into the inner door panel and the switch panel itself, If these dont fix it check an auto boneyard for a replacement switch... AAlso if you are savy with automotive electrical, CAREFULLYcheck the motor operation with a jumper wire replacing the switch to ensure it isnt a bad motor... most likely it is the switch but Murphy's law has a whole subset of rules for automotive electrical applications...

Apr 13, 2009 | 1998 Ford F250 SuperCab

2 Answers

VW Polo 2001 - Electric Windows wont open from Drivers side..


I removed all 3 switches from driver and passenger door, which is really easy with a flat head screw driver. took them completely apart, very carefully, with a small screwdriver out of a christmas cracker. put them back together again and 2 switches started working, so I put 1 in the drivers side and 1 in the passengers side so now my drivers door window opens and I lean over to open the passenger door. cool, no money spent...yet ;o)

Mar 25, 2009 | 2001 Volkswagen Golf

Not finding what you are looking for?
2003 Ford Focus Logo

454 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...