Question about Cars & Trucks
You got the igniton wet
and now, if you connect a scan tool the codes
are P0300 (30x to max cyl)
never pressure wash any engine, if you did or the damage is unlimited.
Posted on Oct 12, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The filter is after the sensor. If the filter is dirty, it should be replaced anyways. If the sensor is covered in dirt, than yes clean it first.
Lastly replace MAF
Posted on May 09, 2009
right renew the glow plug timer/relay if you put a meter on the glow plugs when cold and turn ign on (with help) it should supply power for a about 20 secs ,time depends on outside air temperature ,if all else fails then do a colin --- use a push button switch,wired to a relay so glow plugs can be operated by pushing the switch which you will mount on the dash ,cant beat a manual overide system
Posted on Dec 14, 2009
Testimonial: "alicantecoli provided accurate and correct advice for the diesel cold engine start problem I had."
hi the air flow meter measure air flow to intake therefor it could be meter or 1st thing to check being in africa ? remove the air filter and check the underside of the element as this iswhere dust etc is collected and prevented entering the air induction of engine so if dirty do not try cleaning as this is waste of time renew element then you will have unresticted good air flow hope this helps
Posted on Dec 23, 2009
Hw to change air filte rin 2007 Honda Odyssey
The problem with other web instructions is little guidance on how exactly to remove the glove box. First, the little cover over the control am needs to be pulled off (down towards you). Either fingers or a screwdriver.
Next, trickiest part is removing the retaining tabs. See instructions here: http://techinfo.honda.com/rjanisis/pubs/AI/AII38194.pdf
Basicaly, there is no way to ge behind the glove box to compress the release tabs. So insert a scredrver into the plastic tab cover from the insider of the glove box and just pull towards you until it pops out. When reinserting just place back (with the retainer cylinders poking back through the opening from inside the glove box) and press back in until it snaps.
On the 07 Ody, once you ave the control arm released and the two retaining tabs removed, the glove box should fold down completely. Then just press towards each other the two black end tabls holding the ac filter compartment door. Took me 30 min to figure out, hopefully with this should take you 5 ...
Posted on Jul 09, 2010
Tips for a great answer:
May 31, 2016 | Cars & Trucks
Jan 26, 2016 | Isuzu Cars & Trucks
Jan 19, 2013 | 2004 Ford F250
Aug 30, 2012 | 2007 Jeep Liberty Limited
Dec 11, 2010 | 2006 Chevrolet Cobalt
Dec 14, 2009 | 2004 Hyundai XG350
Aug 01, 2009 | 2007 Chevrolet Tahoe
Jun 15, 2009 | 1994 Chevrolet K1500
Jul 31, 2008 | 2003 Chevrolet Avalanche
34 people viewed this question
Usually answered in minutes!