Question about 2003 Nissan Murano

Open Question

Replace blower motor 2003 nissan murano - 2003 Nissan Murano

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 334 Answers

SOURCE: Replacing front struts, 2003 Nissan Murano, how much?

that a hard one to answer. its depends on were you take it. prises very from state to state.like were i work hr labbor rate is 55.00 hr thats in maine . ill say if you take it to a dealer you may pay $300.00 to $400.00 in part and labor.a louco garge would proubly charge $150.00 to $250.00 .but byeing parts for nissan can cost a lot. ask people around you for a good mec. ok have a good day

Posted on Mar 28, 2009

  • 82 Answers

SOURCE: AC blower motor resistor Nissan Maxima 2000

yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,

Posted on Apr 19, 2009

  • 3 Answers

SOURCE: Replace rear wiper on 2005 Murano

You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.

The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:

88b7c7f.jpg

moz-screenshot-61.jpg9b7da18.jpg








Posted on Jun 29, 2009

  • 495 Answers

SOURCE: 2003 nissan murano with check engine light codes

P0420 is Catalyst System Efficiency Below Threshold - Bank 1
and
P0456 is EVAP Control System Very Small Leak (Negative Pressure Check)

Posted on Nov 22, 2009

  • 4 Answers

SOURCE: i need to change spark plugs on my 2003 nissan

the front spark plugs are easy just remove the coil packs and there right there, now the back ones are a bit tricky if u want to tackle it yourself, because you have to remove the intake manifold to access the coil packs to remove the sparkplugs, i also recommend remove the cowling and wipers this gives u more room and opens the area up to make the job simpler, when removing the intake manifold try not to damage any connectors you should be able to find a do it yourself book at a automotive store but if at any time you feel you do not have the skill to do it successfully stop and put it back together

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan codes


code p1778 refers to CVT step motor --mechanical malfunction===causes --- step motor
I would replace the step motor as it has a mechanical fault and probable will be unrepairable.

Mar 29, 2014 | 2003 Nissan Murano

1 Answer

I have a 2008 nissan murano and i am not getting any air to blow for a/c or heater and blower motor does not cut on.


Sounds like the blower motor is not getting any current or has seized. check the fuse, probably blown it the motor is seized up. once the fuse is good, quickly put on full blast and hit/knock/kick the moter and see if it engages. It might if you hit hard enough, then that confirmes you ned to change the motor.

Jan 02, 2013 | 2007 Nissan Murano SE

2 Answers

My Nissan Murano has 82,000 miles. Do I ned to


Yes

Your owners manual will give you the mileage at which it should be changed.

Apr 06, 2010 | 2003 Nissan Murano

2 Answers

My horn went out on my 06 Nissan Murano. I'm


The horn doesn't use a fuse, instead it used a relay which is the large square black box you see in your fuse box. There should be one for your horn, blower motor (the blower that pushes the heat out the vents in your car) and a few other things.

Easiest way to see if it has gone bad is to switch the horn and blower motor relay and then try and use the horn and blower motor. If the horn works and the blower motor doesn't then you have a bad relay. You can go to any auto parts store and they will have them in stock.

Subikid90

Mar 03, 2010 | 2005 Nissan Murano

1 Answer

2003 murano after running for a while the blower motor runs but no heat or a/c comes out of the vents


You need to go to your authorized mechanic and have the a/c charged and tested for leaks.Radiator fluid gives you your heat so the a/c has it's own issue.As for the heat the heater core may need to be replaced.

Jan 13, 2010 | 2003 Nissan Murano

1 Answer

Hello My 2003 murano heat or defroster is not working and i just had the engine and radiator flushed. What could this be


Does the blower fan work.If not have the blower motor check, also check your fuse's.

Dec 24, 2009 | 2003 Nissan Murano

1 Answer

2003 Murano front wipers just stopped!!


sounds like thats it, you can check it for power,to make sure but it does sound like the motor.

Dec 13, 2009 | 2003 Nissan Murano

2 Answers

When should the timing belt on a 2005 nissan marano be replaced ?


Hello tbyers006: My name is Roger and I will help you. According to what the shop manuals show. Your vehicle has a 3.5 V-6 engine. This motor does not have a timing belt. This engine uses a timing chain. Timing chains have no scheduled replacement. Should you have further questions please just ask. Please rate the answer you received. This way I know the answer was helpful. Thank You for using Fix Ya. Roger

Oct 30, 2009 | 2003 Nissan Murano

2 Answers

2003 Nissan Murano Spark plug removal ( rear babk ) - the fastest way to do it.


yes i have done this myself many of times on all transverse mounted motors. also another approach you can use is to put the vehicle on jack stands and remove the plugs from underneath. then you don't have to remove the dog bone mounts. hope this helps

Oct 23, 2008 | 2003 Nissan Murano

Not finding what you are looking for?
2003 Nissan Murano Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...