Question about Toyota Cars & Trucks

Open Question

Location speed sensor 2003 toyota 4runner 4.7

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 320 Answers

SOURCE: 2003 Toyota 4runner Instrument Panel bulb replacement

ypu can not buy them any where, i had the same problem.you have to order them from a toyota dealer. they are very inexpensive.. i tried different bulbs radio shack didnt work.

Posted on Jan 12, 2009

Ad
hi99ins
  • 123 Answers

SOURCE: SPEED SENSOR LOCATION FOR 1996 HONDA ACCORD

on the trans, its underneath the battery, in-line with the battery clamp toward the front of the car.

Posted on Jan 13, 2009

  • 245 Answers

SOURCE: location of speed sensor for a 2003 dodge durango

the speed sensor for this vehicle is actually in the rear differential of the vehicle. this is the sensor that runs the speedometer also known as the vehicle speed sensor. there are also two speed sensors in the front one on each wheel known as wheel speed sensors these are for the abs system only

Posted on May 17, 2009

Suraido
  • 195 Answers

SOURCE: Replace rotors on 2003 4runner

I have never changed it on a 4runner yet, but it's all pretty much the same. Jack the car/truck up, take off the wheel. Loosen the 2 or more bolts holding the caliper to the wheel spindle (the caliper is the C shaped part holding the pads). Take off the caliper, being careful not to rip or break the brake hoses that are bolted to the caliper. DO NOT TAKE THE HOSES OFF! it seems tempting to save time and be sure not to break them, but if you take them off the calipers you will need to bleed the air out of the system, which usually takes a bit of time. Just rest the caliper on the suspension table or any place where it won't fall too easily and where it wont put the hoses in danger. Now with the caliper off, both the pads and the disc should be free to move and remove. On some models the pads are hooked directly to the caliper, and some others like the ones on my toyota echo are in a holder the bolts back on to the caliper. The disc is usually just resting on the wheel studs and should be able to be removed without doing anything to it. In some rare cases, there will be one bolt holding it back, but its just there for centering purposes and is not necessary. So just put the new disc back on, put the pads back on the caliper or in the holder depending on the model, then bolt the caliper assembly back into place and put the wheel back on. And your done, you just need to put the car down and take the jack out.

Posted on Jul 08, 2009

  • 299 Answers

SOURCE: Where is the coolant temperature sensor located on

it is located where the lower rad hose connects there are two sensors there so make sure you have the correct one

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 toyota 4 runner speedometer doe's not word and i have replaced the speed sensor on the transmission the diagnostic says speed sensor a


I did not get all of your description. If the computer is saying the sensor circuit is the problem, it could be the connector at the sensor, something in the harness going back to the computer, or the gear in the transmission that turns the sensor.

Dec 17, 2012 | 2002 Toyota 4Runner

1 Answer

Where is the VSS located on a 1991 toyota 4Runner, automatic transmission, 3.0 liter


on the trans tailshaft on the left side of transmission.the taailshaft is where the driveshaft goes into the transmission. NOTE:on a 4 wheel drive,the speed sensor is on the transfer case near the back where the drive shaft connects to the transmission.

Aug 07, 2011 | 1991 Toyota 4Runner

1 Answer

Where is the etc sensor located on a 1991 toyota 4runner sr5?


what exactly is the vehicle doing and is it a 4 or 6 cyl and are you talking about the sensor for the trans to make it go into overdrive. let me know

Jun 18, 2011 | 1991 Toyota 4Runner

1 Answer

A/C problem on 2003 Toyota 4 Runner


Bad a/c relay , belt slipping,or bad speed sensor in compressor

Apr 13, 2010 | 2003 Toyota 4Runner

1 Answer

Where is located the KNOCK SENSOR in the 1987


The knock sensor is located on the right side (passenger) of the motor near the back, its a one wire connector probably either black or blue the sensor goes directly into the block

Sep 20, 2009 | 1987 Toyota 4Runner

1 Answer

98 v6 4runner stalled at speed restared and seems fine ???


If it only stalls when stopped or stopping, along with the speedo not reading right would be a speed sensor normal located on the trans.

Feb 10, 2009 | 1998 Toyota 4Runner

1 Answer

Replacing the Drive belt on 2003 Toyota 4runner.


It uses a spring loaded tensioner. Its not adjustable.

Jan 10, 2009 | 2003 Toyota 4Runner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...