Question about 1995 Chevrolet Tahoe

1 Answer

My rear side brakelights dont work but the center one up top does

Posted by on

  • Christopher Robison
    Christopher Robison May 11, 2010

    Have you tried to replace the bulb?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 410 Answers

The reason that your side brakes do not work is because your brake light switch has gone out. Your particular brake light switch has two lines going out of it which is what makes it so you still have your center brake light. The switch is located on the pedal and is fairly easy and cheap to replace. Replace it and your brake lights will be back to normal. Let me know if you have any further questions about this. Thanks for using FixYa!

Posted on Aug 07, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Brake lights rear blinkers quit working when turn signal is on flashes really fast


You simply have a burned out bulb or bulbs. With the key turned on turn on the directional for the left side and then the right side. Typically one bulb is blown and the opposite side works normally. Observe the normal side and note which is the flashing bulb. It is the flashing bulb on the other (malfunctioning) side that needs to be replaced. To replace the bulb you must remove the entire brakelight assembly, which isn't difficult. Open the trunk and locate the electrical harness that lines up with the brakelight assembly. Near the harness, locate the two (possibly three) nuts or wingnuts that attach the brakelight assembly to the car. Once the nuts are removed, the assembly can be pulled off the rear of the car. After replacing the bulb, be sure to test the operation of the new bulb before reassembling everthing.

Mar 18, 2015 | 2002 Ford Taurus

2 Answers

Lumina headlights and tail lights not working.


Sounds like a bad diode and fuse. But also this kind of problems are hard to find even for a technician.

Jan 11, 2018 | 2001 Chevrolet Lumina

1 Answer

Brakelights dont work center one does changed B-L-S STILL DA SAME


Chevrolet put and electronic brake light module under the dash to the right of the steering column check module and replace

Mar 26, 2013 | 1999 Chevrolet Blazer

1 Answer

Gmc 1998 serra.. taillights and brakelights dont work when lights are on..... brake lights work when lights are off...


dont know if this will help but check for a bad ground maybey in the rear of the truck

Sep 17, 2011 | 1998 GMC Sierra

2 Answers

Rear brakelights dont come on fuses and bulbs are fine rear window brake light works


If the high level brake light works, then the brake light circuit is fully functional.

Brake light bulbs may LOOK fine, but can still have failed. Often folks don't notice that one bulb has failed until the second one has blown; it's then easy to incorrectly assume that the fault is more complex.

Try replacing the brake light bulbs: if that doesn't work then please report back for additional options.

Sep 24, 2010 | 1999 Audi A4

1 Answer

Tail lights


These are famous for the circuit boards in the tail lights going bad. If the tail lights are in bad condition, replace the whole tail light, if the lenses are good, then you can buy just the circuit boards. Any (Good) parts store should have them.

Feb 12, 2010 | 1989 Chevrolet C/K 3500

1 Answer

My peugeot 206 break lights dont work. Only the top center light. Which is only part working.


Since the center one is working it means tht the fuse to them allis ok as they are connected together, you will haveto check the rear bulbs and probably replace them both sides.
Hope this helps!

Nov 28, 2009 | 1986 Peugeot 505

1 Answer

Rear brakelights don't work but center brakelight does


Hi,

Pls check:
  • the brake bulbs;
  • the bulb socket and the terminals/contacts;
  • the grounding of the brake lights. A workaround is to simply hardwire another grounding wire from the body of the brake bulb socket to the body of the vehicle.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.

Aug 14, 2008 | Saab 900 Cars & Trucks

Not finding what you are looking for?
1995 Chevrolet Tahoe Logo

124 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...