Question about 1991 Dodge B Series Cargo

Open Question

Broken belt pulley - 1991 Dodge B Series Cargo

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Serpentine belt not broken but will not run on pulleys engine starts but belt stays still


Did you recently replace the belt? If so, did you get the right belt ( not to short or to long). If not, was there any noise before it stopped moving? If the belt hasn't been touched, then it sounds like another component has seized and isn't allowing the belt to move. You could have oil, transmission oil, or anti-freeze on the belt / pulleys allowing it to slip. Belts become glazed with age and also need to be replaced. I would start with checking all the pulleys for smooth noise free operation, then clean all the surfaces, and change the belt. I like the Goodyear Gator belts.

Apr 13, 2014 | Cars & Trucks

1 Answer

Serpantine belt came off


Belt pulley and belt tensioner. Belt pulley is fxhed and tensioner is movable. You need to have belt tensioner relased of the pressure using belt tool (long handle and 15'' wrench) .. Then you can folow belt routing diagram located on fan shroud or underneath front hood!

Feb 05, 2014 | 1998 Ford Windstar

1 Answer

2001 holden rodeo air conditioning broken, broken fan belt, suitable fanbelt to bypass aircon


Use the same belt as the ac compressor will not work unless you turn it on. Disconnect the wire to the ac pulley clutch and the pulley just becomes an idler and you can get the standard belt anywhere.

Dec 16, 2013 | Cars & Trucks

1 Answer

2002 Volkswagen Passat power steering belt pulley broke off


find the bolts attaching the bracket to the engine (possibley2 or 3) Buy a genuine replacement assy and fit get a new belt as the old one may have suffered damage. Replace where you removed the broken bit and adjust the belt to the correct tension

Jan 11, 2013 | 2002 Volkswagen Passat

2 Answers

Power steering just went out suddenly after being stuck on a hill because of snow?


If your drive belt is still on all the pulleys yet and turning properly but you have no power assist then the power steering pump shaft may have broken. Usually the pulley will stay in place and keep turning as usual but if the shaft is broken inside the pump you won't have any assist. I've fixed two so far this winter for this same problem this winter and both were on vehicles that were stuck or ran off of the road into the snow. On both of those you could pull the power steering pump pulley and shaft outwards quite a ways once the belt was removed due to the broken shaft. Ordinarily the pulley won't move in or out more than a fraction of an inch. If the shaft is broken then the pump would need to be replaced.

Jan 11, 2011 | Chevrolet Suburban 1500 Cars & Trucks

2 Answers

BMW X3 aircon belt problem--keeps jumping out of crakshaft pulley


if air con belt runs off the pulley inspect the crankshaft damper pulley, it may be broken!
the air cond belt is a stretch belt with no tensioner!

Jan 21, 2010 | 2005 BMW X5

3 Answers

My 2004 PT cruiser is on its second serpentine belt tensioner pulley. The dealer and parts houses only sell the "tensioner/pulley as an assembly. I only need the pulley. Do you know where I can buy just...


If you are on your second tensioner/pulley you have an alignment problem with your belt. I don't know if that is a broken engine mount you saw but it could be your problem with the belt. And no you have to buy the whole part.

Sep 08, 2009 | 2004 Chrysler PT Cruiser

2 Answers

Broken Belt under the 1998 Plymouth Breeze 2.4L DOHC 4 Cyl. engine.


Sounds like you have a broken belt that drives the alternator, water pump and maybe the power steering depending on engine type and size. Have the belt replaced before driving car as if you overheat the engine you could end up with major engine damage.The belt on the 2.4 litre engine is manually adjusted with a bolt on the alternator housing. To install this belt yourself maybe difficult if you do not know the routing of the belt around the number of pulleys involved. get help.

May 24, 2009 | 1998 Plymouth Breeze

1 Answer

Broken bottom alternator belt


Check those pulleys that the Alternator belt runs on and make sure that they are ok. Make sure that oil is NOT getting on this belt (form oil leaks ) that's one of the most common reasons for belts to break that often. Good Luck

Dec 29, 2008 | 1992 Eagle Talon

1 Answer

95 toyota corolla


If you have A/C, your 95 Toyota Corolla should have three belts. Alternator. A/C. Power steering.

Frank.
Frank's Friendly Cars Maui Car Rental.
www.MauiCarRental.biz

Dec 01, 2008 | 1998 Toyota Corolla

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...